Institut für Physikalische Chemie und Theoretische Chemie
Refine
Has Fulltext
- no (243)
Year of publication
Document Type
- Article (152)
- Doctoral Thesis (76)
- Monograph/Edited Volume (14)
- Other (1)
Is part of the Bibliography
- yes (243)
Institute
Strategische Planung für die Beprobung : effektive Analytik bei großflächigen Bodenkontaminationen
(1995)
Strategische Planung für die Beprobung : effektive Analytik bei großflächigen Bodenkontaminationen
(1995)
Mit einer ausgewogenen Stoffauswahl wird der Leser an das Studium der Physikalischen Chemie herangeführt. Das Verständnis der Theorie wird durch zahlreiche Aufgabenstellungen und die Angabe ihrer Lösungswege erleichtert. Das vorliegende Buch gibt dem Studenten darüber hinaus Anregungen für ausgewählte Experimente zu den behandelten Teilgebieten. In der Durchführung und Auswertung der Experimente kann der Student erneut überprüfen, wie gut es ihm gelungen ist, ein Grundverständnis für physikalisch-chemische Zusammenhänge zu entwickeln.
Investigation on the photoreactions of Nitrate and Nitrite ions with selected Azaarenes in water
(1999)
Erste Ergebnisse einer Fallstudie zur Stoffdynamik naturschutzrelevanter Böden der Döberitzer Heide
(1997)
A weak-mode representation of floppy molecules. IV. Spectroscopic states of model HCN and CNH
(1997)
Deuteration effects on the vibronic structure of the emission and excitation spectra of triangular [ 4] phenylene (D-3h [4]phenylene) were studied using laser-excited Shpol'skii spectroscopy (LESS) in an octane matrix at 4.2 K. For correct assignment of the vibrational modes, the experimental results were compared with calculated frequencies (B3LYP/6-31G*). CH vibrations were identified by their characteristic isotopic shifts in the spectra of deuterated triangular [4]phenylenes. Two CC stretching modes, at 100 cm(-1) and 1176 cm(-1), suitable as probes for bond strength changes in the excited state, were identified. The isotope effect on the internal conversion rates of triangular [4] phenylene was evaluated from measurements of temperature dependent lifetime. Isotope dependency and the magnitude of the internal conversion rates indicate that internal conversion in triangular [4] phenylene is most likely induced by CH vibrations. The results obtained by LESS and lifetime measurements were compared with PM3 PECI calculations of the excited state structure. The theoretical results and the relation between ground and excited state vibration energies of the 1176 cm(-1) probe vibration indicate a reduction of bond alternation of the central cyclohexatriene ring in the excited state
Optical methods play an important role in process analytical technologies (PAT). Four examples of optical process and quality sensing (OPQS) are presented, which are based on three important experimental techniques: near- infrared absorption, luminescence quenching, and a novel method, photon density wave (PDW) spectroscopy. These are used to evaluate four process and quality parameters related to beer brewing and polyurethane (PU) foaming processes: the ethanol content and the oxygen (O-2) content in beer, the biomass in a bioreactor, and the cellular structures of PU foam produced in a pilot production plant
Polymerbedeckte Lipidvesikel
(1999)
Kinetic analysis of the thermic effect of food and its relationship to body composition in humans
(2000)
The course of energy expenditure after a meal can vary widely with regard to the slope of onset, amplitude, and duration of the thermic effect. The aim of the present study was to explore the relationship between the thermic effect of food (TEF), as characterized by kinetic analysis of postprandial energy expenditure, body composition, and variables related to the metabolic syndrome including central obesity, hypertension, and glucose tolerance. A total of 181 men and women (body mass index [BMI] range, 19.4 to 52.2 kg/m2) were characterized for body composition, blood pressure, oral glucose tolerance, and energy expenditure after a test meal. Energy expenditure, as measured by indirect calorimetry, was analyzed over a 6-hour period by 3-parameter curve fitting using equations derived from kinetics describing a biphasic reaction involving 2 consecutive first-order reactions (A->B->C). Apart from total thermic effect of food (TEFk), the curve also provided an estimate of time of peak (Tp) and amplitude of peak (Ap) for each subject. Multiple stepwise regression analysis with TEFk, Ap, and Tp as dependent variables showed significant effects of sex, age, body weight, body fat, -blockade, and body composition on TEF curve parameters. Cluster analysis based on Tp shown 2 distinct clusters with significant differences in age and body fat mass. This study shows that kinetic analysis of postprandial energy expenditure can be used to examine the determinants of the time course of the thermic effect of food in man.
In this work we present theoretical studies of the hydrolytic reaction of methyl formate, formamide and urea with one water molecule. The studied systems contain two additional water molecules which can act as bifunctional acid- base catalysts. These water molecules catalyze proton transfers between the primary reacting species. Our models describe the concerted transfer of two protons in every reaction step. The calculations have been carried out with the Becke3LYP/6-31G* method. Unspecific solvation effects have been included by means of a polarizable continuum model. Substrate reactivity differences as well as preferences for different reaction pathways can be discussed with the aid of these molecular systems. The studied alternative mechanisms include the common addition-elimination mechanism via a tetrahedral intermediate, and a concerted SN-like mechanism without a reaction intermediate. Our results suggest that the proved decreasing substrate reactivity in the order ester, amide, urea is caused by a rising resonance stabilization of the reaction centre, and not by a different positive partial charge of the carbonyl carbon. It is also concluded, that the probability of a concerted addition of a nucleophile and elimination of a leaving group without a tetrahedral intermediate rises in the order ester, amide, urea. The ordering of reactivity is not influenced by this behaviour.
Basicities of 16 acyl compounds including selected aldehydes, ketones, esters, amides and ureas in the gas phase and in water were calculated with the Becke3LYP/6-31G* method. Solvent effects were modeled using a polarizable electrostatic continuum representation of the solvent. The properties of the electron densities of protonated molecules were described by localized bond orbitals. Our results suggest that the carbonyl oxygen is the preferred site of protonation for all molecules studied. Calculated pKa values in water range from -12 for aldehydes to + 1.5 for ureas. They agree well with published experimental data. We found that a high basicity of acyl compounds at the carbonyl oxygen is coupled with a large amount of additional resonance stabilization at the carbonyl group. The protonation of the leaving group of eaters, amides and ureas is less preferred, but the basicity difference between C=O and -OR or -NR2 decreases from esters to ureas. Calculated pKa values for this site range from -18 for esters to + 3 for ureas. These values are often not accessible by experiment. The structure of carboxylic acid derivatives protonated at the leaving group is determined by prefragmentation of the molecules into an acylium ion or positively charged isocyanate and an alcohol or amine. (C) 1998 Elsevier Science B.V.
Different chemical and enzymatic methods were applied for the hydrolysis of main stems from Lupinus nootkatensis (harvest November 2002). The whole process (all steps) is based on the lignocellulose-feedstock biorefinery regime. The acid hydrolysis of L. was performed with concentrated hydrochloric acid; advantages in this process are exothermic hydrolysis and the possibility of acid recovery. Enzymatic hydrolysis achieved high yields of fermentable carbohydrates (regarding to input cellulose) with high selectivity. However, this way requires the generation of cellulose from L. by chemical pulping. Monosaccharide derivatives thus obtained were identified by their GC retention times and the corresponding MS fragmentation. Hexamethyldisilazane was used as derivatization reagent to prepare the trimethylsilyl derivatives of the carbohydrates and of the degradations products of cellulose from the different fractions. The glucose content was quantified by GC peak integration with respect to an internal standard.
Adsorptive Eigenschaften von Bodensubstraten in Abhängigkeit vom anthropogenen Überprägungsgrad
(1996)
Polyelectrolyte complexes
(1996)
The influence of the water soluble polymer poly(ethylene glycol) (PEG) on structure formation in the quasiternary system sodium dodecylsulfate (SDS)/pentanol-xylene/water was checked by means of conductometry, rheology, and micro differential calorimetry. The polymer induces the formation of an isotropic phase channel between the o/w and w/o microemulsion. The transition from the normal as well as from the inverse micellar to the bicontinuous phase range can be detected by conductometry, rheology as well as micro-DSC. As a result of polymer-surfactant interactions, the spontaneous curvature of the surfactant film is changed and a sponge phase is formed. The bicontinuous phase is characterized by a moderate shear viscosity, a Newtonian flow behaviour, and the disappearence of interphasal water in the heating curve of the micro-DSC. When the polymer-modified bicontinuous phase is used as a template phase for the nanoparticle formation, spherical BaSO4 nanoparticles were formed. During the following solvent evaporation process the primarily formed spherical nanoparticles aggregate to nanorods and triangular structures due to the non-restriction of the bicontinuous template phase in longitudinal direction
The paper is focused on the formation and redispersion of monodisperse BaSO4 nanoparticles in polyelectrolyte- modified microemulsions. It is shown that a cationic polyelectrolyte of low molar mass, e.g. poly(dially1dimethylammonium chloride) (PDADMAC), can be incorporated into the individual inverse microemulsion droplets (L2 phase) consisting of heptanol, water, and an amphoteric surfactant with a sulfobetaine head group. These PDADMAC- filled microemulsion droplets can be successfully used as a template phase for the nanoparticle formation. The monodisperse BaSO4 nanoparticles are produced by a simple mixing procedure and can be redispersed after solvent evaporation without a change in particle dimensions. Dynamic and electrophoretical light scattering in combination with sedimentation experiments in the analytical Ultracentrifuge of the redispersed powder show polyelectrolyte-stabilized nanoparticles with diameters of about 6 nm. The polyelectrolyte shows a "size control effect", which can be explained by the polyelectrolyte-surfactant interactions in relation to the polyelectrolyte-nanoparticle interactions during the particle growth, solvent evaporation and redispersion process. However, the approach used here opens away to produce different types of polyelectrolyte-stabilized nanoparticles (including rare metals, semiconductors, carbonates or oxides) of very small dimensions. (C) 2004 Elsevier B.V. All rights reserved
The influence of polyelectrolytes on structure formation in liquid crystalline Na-dodecylsulfate/decanol/water systems was investigated by means of small angle X-ray diffraction, rheology, NMR spectroscopy, and microscopy. By adding Na-polyacrylate (PAA) into the mesophase, the one-phase region is left and phenomena of phase separation into a solvent-rich and a polymer/surfactantrich phase occurs. By incoporating an anionic and cationic polyelectrolyte step by step the tendency of phase separation is increased drastically. The self-organization process can be regulated directly by varying the water content of the system. However, at a water content of 30% the properties of the resulting liquid crystal were changed drastically. X-ray diffraction shows a multitude of Bragg peaks, NMR shows a peak-splitting, and rheology shows a change from non-Newtonian to Newtonian-flow behavior. On the basis of the experimental results an ordered multilayer associate structure can be assumed.
Polyanion-polycation complex formation as a function of the position of the functional groups
(1996)
This paper focuses on the characterization and use of polymer-modified phosphatidylcholine (PC)/sodium dodecyl sulfate (SDS)-based inverse microemulsions as a template phase for BaSO4 nanoparticle formation. The area of the optically clear inverse microemulsion phase in the isooctane/hexanol/water/PC/SDS system is not significantly changed by adding polyelectrolytes, i.e., poly(diallyldimethylammonium chloride) (PDADMAC), or amphoteric copolymers of diallyldimethylammonium chloride and maleamid acid to the SDS-modified inverse microemulsion. Shear experiments show non- Newtonian flow behavior and oscillation experiments show a frequency-dependent viscosity increase (dilatant behavior) of the microemulsions. Small amounts of bulk water were identified by means of differential scanning calorimetry. One can conclude that the macromolecules are incorporated into the individual droplets, and polymer-filled microemulsions are formed. The polymer-filled microemulsions were used as a template phase for the synthesis of BaSO4 nanoparticles. After solvent evaporation the nanoparticles were redispersed in water and isooctane, respectively. The polymers incorporated into the microemulsion are involved in the redispersion process and influence the size and shape of the redispersed BaSO4 particles in a specific way. The crystallization process mainly depends on the type of solvent and the polymer component added. In the presence of the cationic polyelectrolyte PDADMAC the crystallization to larger cubic crystals is inhibited, and layers consisting of polymer-stabilized spherical nanoparticles of BaSO4 (6 nm in size) will be observed. (c) 2004 Elsevier Inc. All rights reserved