Refine
Document Type
- Article (2)
- Doctoral Thesis (1)
Language
- English (3) (remove)
Is part of the Bibliography
- yes (3)
Keywords
- XAS (3) (remove)
Institute
Thermal evolution of the band edges of 6H-SiC: X-ray methods compared to the optical band gap
(2014)
The band gap of semiconductors like silicon and silicon carbide (SIC) is the key for their device properties. In this research, the band gap of 6H-SiC and its temperature dependence were analyzed with silicon 2p X-ray absorption spectroscopy (XAS), X-ray emission spectroscopy (XES) and resonant inelastic X-ray scattering (RIXS) allowing for a separate analysis of the conduction-band minimum (CBM) and valence-band maximum (VBM) components of the band gap. The temperature-dependent asymmetric band gap shrinking of 6H-SiC was determined with a valence-band slope of +2.45 x 10(-4) eV/K and a conduction-band slope of -1.334 x 10(-4) eV/K. The apparent asymmetry, e.g., that two thirds of the band-gap shrinking with increasing temperature is due to the VBM evolution in 6H-SiC, is similar to the asymmetry obtained for pure silicon before. The overall band gap temperature-dependence determined with XAS and nonresonant XES is compared to temperature-dependent optical studies. The core-excitonic binding energy appearing in the Si 2p XAS is extracted as the main difference. In addition, the energy loss of the onset of the first band in RIXS yields to values similar to the optical band gap over the tested temperature range. (C) 2014 Elsevier B.V. All rights reserved.
Silicate melts are major components of the Earth’s interior and as such they make an essential contribution in igneous processes, in the dynamics of the solid Earth and the chemical development of the entire Earth. Macroscopic physical and chemical properties such as density, compressibility, viscosity, degree of polymerization etc. are determined by the atomic structure of the melt. Depending on the pressure, but also on the temperature and the chemical composition, silicate melts show different structural properties. These properties are best described by the local coordination environment, i.e. symmetry and number of neighbors (coordination number) of an atom, as well as the distance between the central atom and its neighbors (inter-atomic distance). With increasing pressure and temperature, i.e. with increasing depth in the Earth, the density of the melt increases, which can lead to changes in coordination number and distances. If the coordination number remains the same, the distance usually decreases. If the coordination number increases, the distance can increase. These general trends can, however, vary greatly, which can be attributed in particular to the chemical composition.
Due to the fact that natural melts of the deep earth are not accessible to direct investigations, in order to understand their properties under the relevant conditions, extensive experimental and theoretical investigations have been carried out so far. This has often been studied using the example of amorphous samples of the end-members SiO2 and GeO2 , with the latter serving as a structural and chemical analog model to SiO2. Commonly, the experiments were carried out at high pressure and at room temperature. Natural melts are chemically much more complex than the simple end-member SiO2 and GeO2, so that observations made on them may lead to incorrect compression models. Furthermore, the investigations on glasses at room temperature can show potentially strong deviations from the properties of melts under natural thermodynamic conditions.
The aim of this thesis was to explain the influence of the composition and the temperature on the structural properties of the melts at high pressures. To understand this, we studied complex alumino-germanate and alumino-silicate glasses. More precisely, we studied synthetic glasses that have a composition like the mineral albite and like a mixture of albite-diopside at the eutectic point. The albite glass is structurally similar to a simplified granitic melt, while the albite-diopside glass simulates a simplified basaltic melt. To study the local coordination environment of the elements, we used X-ray absorption spectroscopy in combination with a diamond anvil cell. Because the diamonds have a high absorbance for X-rays with energies below 10 keV, the direct investigation of the geologically relevant elements such as Si, Al, Ca, Mg etc. with this spectroscopic probe technique in combination with a diamond anvil cell is not possible. Therefore the glasses were doped with Ge and Sr. These elements serve partially or fully as substitutes for important major elements. In this sense, Ge serves as an a substitute for Si and other network formers, while Sr replaces network modifiers such as Ca, Na, Mg etc.,
as well as other cations with a large ionic radius.
In the first step we studied the Ge K-edge in Ge-Albit-glass, NaAlGe3O8, at room temperature up to 131 GPa. This glass has a higher chemical complexity than SiO2 and GeO2, but it is still fully polymerized. The differences in the compression mechanism between this glass and the simple oxides can clearly be attributed to higher chemical complexity. The albite and albite-diopside compositions partially doped with Ge and Sr were probed at room temperature for Ge up to 164 GPa and for Sr up to 42 GPa. While the albite glass is nominally fully polymerized like NaAlGe3O8, the albite-diopside glass is partially depolymerized. The results show that structural changes take place in all three glasses in the first 25 to a maximum of 30 GPa, with both Ge and Sr reaching the maximum coordination number 6 and ∼9, respectively. At higher pressures, only isostructural shrinkage of the coordination polyhedra takes place in the glasses. The most important finding of the high pressure studies on the alumino-silicate and alumino-germanate glasses is that in these complex glasses the polyhedra show a much higher compressibility than what can be observed in the end-members. This is shown in particular by the strong shortening of the Ge-O distances in the amorphous NaAlGe3O8 and albite-diopside glass at pressures above 30 GPa.
In addition to the effects of the composition on the compaction process, we investigated the influence of temperature on the structural changes. To do this, we probed the albite-diopside glass, as it is chemically most similar to the melts in the lower mantle. We studied the Ge K edge of the sample with a resistively heated and a laser-heated diamond anvil cell, for a pressure range of up to 48 GPa and a temperature range of up to 5000 K. High temperatures at which the sample is liquid and that are relevant for the Earth mantle, have a significant impact on the structural transformation, with a shift of approx. 30% to significantly lower pressures, compared to the glasses at room temperature and below 1000 K.
The results of this thesis represent an important contribution to the understanding of the properties of melts at conditions of the lower mantle. In the context of the discussion about the existence and origin of ultra-dense silicate melts at the core-mantle boundary, these investigations show that the higher density compared to the surrounding material cannot be explained by only structural features, but by a distinct chemical composition. The results also suggest that only very low solubilities of noble gases are to be expected for melts in the lower mantle, so that the structural properties clearly influence the overall budget and transport of noble gases in the Earth’s mantle.
X-ray spectroscopy is a powerful tool to study the local charge distribution of chemical systems. Together with the liquid jet it becomes possible to probe chemical systems in their natural environment, the liquid phase. In this work, we present X-ray absorption (XA), X-ray emission (XE) and resonant inelastic X-ray scattering (RIXS) data of pure water and various salt solutions and show the possibilities these methods offer to elucidate the nature of ion-water interaction.