Refine
Has Fulltext
- no (221)
Year of publication
- 2016 (221) (remove)
Document Type
- Article (221) (remove)
Is part of the Bibliography
- yes (221)
Keywords
- Pollen (4)
- Body waves (3)
- climate change (3)
- erosion (3)
- water balance (3)
- Arctic (2)
- Barasona Reservoir (2)
- Central Asia (2)
- Climate (2)
- Climate change (2)
Institute
- Institut für Geowissenschaften (221) (remove)
The determination of the total carbon storage of peatlands is of high relevance in the context of climate-change mitigation efforts. This determination relies on data about stratigraphy and peat properties, which are conventionally collected by coring. Ground-penetrating radar (GPR) and electrical resistivity imaging (ERI) can support these point data by providing subsoil information in two-dimensional cross-sections. In this study, GPR and ERI were conducted at two groundwater-fed fen sites located in the temperate zone in north-east Germany. The fens of this region are embedded in low conductive glacial sand and are characterised by thick layers of gyttja, which can be either mineral or organic. The two study sites are representative of this region with respect to stratigraphy (total thickness, peat and gyttja types) and ecological conditions (pH-value, trophic condition). The aim of this study is to assess the suitability of GPR and ERI to detect stratigraphy and peat properties under these characteristic site conditions. Results show that GPR clearly detects the interfaces between (i) Carex and brown-moss peat, (ii) brown-moss peat and organic gyttja, (iii) organic- and mineral gyttja, and (iv) mineral gyttja and the parent material (glacial sand). These layers differ in bulk density and the related organic matter content. ERI, however, does not delineate these layers; rather it delineates regions of varying properties. At our base-rich site, pore fluid conductivity and cation.exchange capacity are the main factors that determine peat electrical conductivity (reverse of resistivity), whereas organic matter and water content are most influential at the more acidic site. Thus the correlation between peat properties and electrical conductivity are driven by site-specific conditions, which are mainly determined by the solute load in the groundwater at fens. When the total organic deposits exceed a thickness of 5 m, the depth of investigation by GPR is limited due to increasing attenuation. This is not a limiting factor for ERI, where the transition from organic deposits to glacial sand is visible at both sites. Due to these specific sensitivities, a combined application of GPR and ERI meets the demand for up-to-date information on carbon storage of peatlands, which is, moreover, very site-specific because of the inherent variety of ecological conditions and stratigraphy between peatlands in general and between fens and bogs in particular. (C) 2016 Elsevier B.V. All rights reserved.
We present an algorithm that performs sequentially one-dimensional inversion of subsurface magnetic permeability and electrical conductivity by using multi-configuration electromagnetic induction sensor data. The presented method is based on the conversion of the in-phase and out-of-phase data into effective magnetic permeability and electrical conductivity of the equivalent homogeneous half-space. In the case of small-offset systems, such as portable electromagnetic induction sensors, for which in-phase and out-of-phase data are moderately coupled, the effective half-space magnetic permeability and electrical conductivity can be inverted sequentially within an iterative scheme. We test and evaluate the proposed inversion strategy using synthetic and field examples. First, we apply it to synthetic data for some highly magnetic environments. Then, the method is tested on real field data acquired in a basaltic environment to image a formation of archaeological interest. These examples demonstrate that a joint interpretation of in-phase and out-of-phase data leads to a better characterisation of the subsurface in magnetic environments such as volcanic areas.
The problem of estimating the maximum possible earthquake magnitude m(max) has attracted growing attention in recent years. Due to sparse data, the role of uncertainties becomes crucial. In this work, we determine the uncertainties related to the maximum magnitude in terms of confidence intervals. Using an earthquake catalog of Iran, m(max) is estimated for different predefined levels of confidence in six seismotectonic zones. Assuming the doubly truncated Gutenberg-Richter distribution as a statistical model for earthquake magnitudes, confidence intervals for the maximum possible magnitude of earthquakes are calculated in each zone. While the lower limit of the confidence interval is the magnitude of the maximum observed event, the upper limit is calculated from the catalog and the statistical model. For this aim, we use the original catalog which no declustering methods applied on as well as a declustered version of the catalog. Based on the study by Holschneider et al. (Bull Seismol Soc Am 101(4): 1649-1659, 2011), the confidence interval for m(max) is frequently unbounded, especially if high levels of confidence are required. In this case, no information is gained from the data. Therefore, we elaborate for which settings finite confidence levels are obtained. In this work, Iran is divided into six seismotectonic zones, namely Alborz, Azerbaijan, Zagros, Makran, Kopet Dagh, Central Iran. Although calculations of the confidence interval in Central Iran and Zagros seismotectonic zones are relatively acceptable for meaningful levels of confidence, results in Kopet Dagh, Alborz, Azerbaijan and Makran are not that much promising. The results indicate that estimating mmax from an earthquake catalog for reasonable levels of confidence alone is almost impossible.
The effect of methods of statistical downscaling of daily precipitation on changes in extreme flow indices under a plausible future climate change scenario was investigated in 11 catchments selected from 9 countries in different parts of Europe. The catchments vary from 67 to 6171 km(2) in size and cover different climate zones. 15 regional climate model outputs and 8 different statistical downscaling methods, which are broadly categorized as change factor and bias correction based methods, were used for the comparative analyses. Different hydrological models were implemented in different catchments to simulate daily runoff. A set of flood indices were derived from daily flows and their changes have been evaluated by comparing their values derived from simulations corresponding to the current and future climate. Most of the implemented downscaling methods project an increase in the extreme flow indices in most of the catchments. The catchments where the extremes are expected to increase have a rainfall dominated flood regime. In these catchments, the downscaling methods also project an increase in the extreme precipitation in the seasons when the extreme flows occur. In catchments where the flooding is mainly caused by spring/summer snowmelt, the downscaling methods project a decrease in the extreme flows in three of the four catchments considered. A major portion of the variability in the projected changes in the extreme flow indices is attributable to the variability of the climate model ensemble, although the statistical downscaling methods contribute 35-60% of the total variance. (C) 2016 Elsevier B.V. All rights reserved.
There is increasing evidence for recent changes in the intensity and frequency of heavy precipitation and in the number of days with snow cover in many parts of Norway. The question arises as to whether these changes are also discernable with respect to their impacts on the magnitude and frequency of flooding and on the processes producing high flows. In this study, we tested up to 211 catchments for trends in peak flow discharge series by applying the Mann-Kendall test and Poisson regression for three different time periods (1962-2012, 1972-2012, 1982-2012). Field-significance was tested using a bootstrap approach. Over threshold discharge events were classified into rainfall vs. snowmelt dominated floods, based on a simple water balance approach utilizing a nationwide 1 x 1 km(2) gridded data set with daily observed rainfall and simulated snowmelt data. Results suggest that trends in flood frequency are more pronounced than trends in flood magnitude and are more spatially consistent with observed changes in the hydrometeorological drivers. Increasing flood frequencies in southern and western Norway are mainly due to positive trends in the frequency of rainfall dominated events, while decreasing flood frequencies in northern Norway are mainly the result of negative trends in the frequency of snowmelt dominated floods. Negative trends in flood magnitude are found more often than positive trends, and the regional patterns of significant trends reflect differences in the flood generating processes (FGPs). The results illustrate the benefit of distinguishing FGPs rather than simply applying seasonal analyses. The results further suggest that rainfall has generally gained an increasing importance for the generation of floods in Norway, while the role of snowmelt has been decreasing and the timing of snowmelt dominated floods has become earlier. (C) 2016 Elsevier B.V. All rights reserved.
The 11 July 1889 Chilik earthquake (M-w 8.0-8.3) forms part of a remarkable sequence of large earthquakes in the late nineteenth and early twentieth centuries in the northern Tien Shan. Despite its importance, the source of the 1889 earthquake remains unknown, though the macroseismic epicenter is sited in the Chilik valley, similar to 100 km southeast of Almaty, Kazakhstan (similar to 2 million population). Several short fault segments that have been inferred to have ruptured in 1889 are too short on their own to account for the estimated magnitude. In this paper we perform detailed surveying and trenching of the similar to 30 km long Saty fault, one of the previously inferred sources, and find that it was formed in a single earthquake within the last 700 years, involving surface slip of up to 10 m. The scarp-forming event, likely to be the 1889 earthquake, was the only surface-rupturing event for at least 5000 years and potentially for much longer. From satellite imagery we extend the mapped length of fresh scarps within the 1889 epicentral zone to a total of similar to 175 km, which we also suggest as candidate ruptures from the 1889 earthquake. The 175 km of rupture involves conjugate oblique left-lateral and right-lateral slip on three separate faults, with step overs of several kilometers between them. All three faults were essentially invisible in the Holocene geomorphology prior to the last slip. The recurrence interval between large earthquakes on any of these faults, and presumably on other faults of the Tien Shan, may be longer than the timescale over which the landscape is reset, providing a challenge for delineating sources of future hazard.
The warm water geothermal reservoir below the village of Waiwera in New Zealand has been known by the native Maori for centuries. Development by the European immigrants began in 1863. Until the year 1969, the warm water flowing from all drilled wells was artesian. Due to overproduction, water up to 50 A degrees C now needs to be pumped to surface. Further, between 1975 and 1976, all warm water seeps on the beach of Waiwera ran dry. Within the context of sustainable water management, hydrogeological models must be developed as part of a management plan. Approaches of varying complexity have been set-up and applied since the 1980s. However, none of the models directly provide all results required for optimal water management. Answers are given simply to parts of the questions, nonetheless improving resource management of the geothermal reservoir.
Injection of fluids into deep saline aquifers causes a pore pressure increase in the storage formation, and thus displacement of resident brine. Via hydraulically conductive faults, brine may migrate upwards into shallower aquifers and lead to unwanted salinisation of potable groundwater resources. In the present study, we investigated different scenarios for a potential storage site in the Northeast German Basin using a three-dimensional (3-D) regional-scale model that includes four major fault zones. The focus was on assessing the impact of fault length and the effect of a secondary reservoir above the storage formation, as well as model boundary conditions and initial salinity distribution on the potential salinisation of shallow groundwater resources. We employed numerical simulations of brine injection as a representative fluid. Our simulation results demonstrate that the lateral model boundary settings and the effective fault damage zone volume have the greatest influence on pressure build-up and development within the reservoir, and thus intensity and duration of fluid flow through the faults. Higher vertical pressure gradients for short fault segments or a small effective fault damage zone volume result in the highest salinisation potential due to a larger vertical fault height affected by fluid displacement. Consequently, it has a strong impact on the degree of shallow aquifer salinisation, whether a gradient in salinity exists or the saltwater-freshwater interface lies below the fluid displacement depth in the faults. A small effective fault damage zone volume or low fault permeability further extend the duration of fluid flow, which can persist for several tens to hundreds of years, if the reservoir is laterally confined. Laterally open reservoir boundaries, large effective fault damage zone volumes and intermediate reservoirs significantly reduce vertical brine migration and the potential of freshwater salinisation because the origin depth of displaced brine is located only a few decametres below the shallow aquifer in maximum. The present study demonstrates that the existence of hydraulically conductive faults is not necessarily an exclusion criterion for potential injection sites, because salinisation of shallower aquifers strongly depends on initial salinity distribution, location of hydraulically conductive faults and their effective damage zone volumes as well as geological boundary conditions.
The role that climate and environmental history may have played in influencing human evolution has been the focus of considerable interest and controversy among paleoanthropologists for decades. Prior attempts to understand the environmental history side of this equation have centered around the study of outcrop sediments and fossils adjacent to where fossil hominins (ancestors or close relatives of modern humans) are found, or from the study of deep sea drill cores. However, outcrop sediments are often highly weathered and thus are unsuitable for some types of paleoclimatic records, and deep sea core records come from long distances away from the actual fossil and stone tool remains. The Hominin Sites and Paleolakes Drilling Project (HSPDP) was developed to address these issues. The project has focused its efforts on the eastern African Rift Valley, where much of the evidence for early hominins has been recovered. We have collected about 2 km of sediment drill core from six basins in Kenya and Ethiopia, in lake deposits immediately adjacent to important fossil hominin and archaeological sites. Collectively these cores cover in time many of the key transitions and critical intervals in human evolutionary history over the last 4 Ma, such as the earliest stone tools, the origin of our own genus Homo, and the earliest anatomically modern Homo sapiens. Here we document the initial field, physical property, and core description results of the 2012-2014 HSPDP coring campaign.