Refine
Has Fulltext
- no (4)
Document Type
- Article (3)
- Working Paper (1)
Language
- English (4)
Is part of the Bibliography
- yes (4)
Keywords
- Crack opening and closure (1)
- F-test (1)
- Hydraulic fracture (1)
- Induced seismicity (1)
- Source mechanism (1)
- conomics (1)
- environmental remediation (1)
- experimental design (1)
- heavy metals (1)
- immobilization (1)
- open science (1)
- political science (1)
- precipitation (1)
- replication (1)
- reproduction (1)
- research transparency (1)
Birth weight variation is influenced by fetal and maternal genetic and non-genetic factors, and has been reproducibly associated with future cardio-metabolic health outcomes. In expanded genome-wide association analyses of own birth weight (n = 321,223) and offspring birth weight (n = 230,069 mothers), we identified 190 independent association signals (129 of which are novel). We used structural equation modeling to decompose the contributions of direct fetal and indirect maternal genetic effects, then applied Mendelian randomization to illuminate causal pathways. For example, both indirect maternal and direct fetal genetic effects drive the observational relationship between lower birth weight and higher later blood pressure: maternal blood pressure-raising alleles reduce offspring birth weight, but only direct fetal effects of these alleles, once inherited, increase later offspring blood pressure. Using maternal birth weight-lowering genotypes to proxy for an adverse intrauterine environment provided no evidence that it causally raises offspring blood pressure, indicating that the inverse birth weight-blood pressure association is attributable to genetic effects, and not to intrauterine programming.
Our study presents the results of a moment tensor inversion of 19 microseismic events with M-L between 2.0 and 3.4, associated with the stimulation operation of an enhanced geothermal reservoir in Basel, Switzerland, in 2006. We adopt a three-step procedure to retrieve point source solution parameters based on full waveform inversion. The inversion is performed by fitting displacement amplitude spectra and displacement seismograms in the first and second step, respectively, assuming a double couple source model and thus obtaining focal solutions for all 19 events. Our results are in agreement with focal mechanisms from a previous study, which employed P wave first-motion polarities from more than 40 stations, whereas our solutions are achieved using full waveform data recorded by less than 10 surface stations. In the last step, a full moment tensor inversion is performed. The results from the moment tensor inversion show an improvement on the waveform fitting compared to the double couple models, which is verified by an F-test. We investigate the stability of the moment tensor solutions by employing different velocity models. The isotropic components of the moment tensor solutions of some events are not negligible, suggesting source volume changes due to fluid injection. Events with significant isotropic components occurred mainly during the stimulation phase and close to the injection well. On the other hand, events that occurred in the post-stimulation phase are predominantly pure shear failure and located further away from the well bore. These spatio-temporal patterns can be explained by the influence of pore pressure variations during and after the hydraulic stimulation at the geothermal site. (C) 2014 Elsevier Ltd. All rights reserved.
BACKROUND: Few studies have been carried out to connect nutrients recovery from wastewater and heavy metals immobilization in contaminated soil. To achieve the goal, ammonia nitrogen (AN) and phosphorus (P) were recovered from rare-earth wastewater by using the formation of struvite, which was used as the amendment with plant ash for copper, lead and chromium immobilization. RESULTS: AN removal efficiency and residual P reached 95.32 +/- 0.73% and 6.14 +/- 1.72mgL(-1) under optimal conditions: pH= 9.0, n(Mg): n(N): n(P)= 1.2: 1: 1.1, which were obtained using response surface methodology (RSM). The minimum available concentrations of Cu, Pb and Cr (CPC) separately reduced to 320.82 mg kg(-1), 190.77 mg kg(-1) and 121.46 mg kg(-1) with increasing immobilization time at the mass ratio of phosphate precipitate (PP)/plant ash (PA) of 1: 3. Humic acid (HA) and fulvic acid (FA) were beneficial to immobilize Cu, both of which showed no effect or even a negative effect on Pb and Cr immobilization.
This study pushes our understanding of research reliability by reproducing and replicating claims from 110 papers in leading economic and political science journals. The analysis involves computational reproducibility checks and robustness assessments. It reveals several patterns. First, we uncover a high rate of fully computationally reproducible results (over 85%). Second, excluding minor issues like missing packages or broken pathways, we uncover coding errors for about 25% of studies, with some studies containing multiple errors. Third, we test the robustness of the results to 5,511 re-analyses. We find a robustness reproducibility of about 70%. Robustness reproducibility rates are relatively higher for re-analyses that introduce new data and lower for re-analyses that change the sample or the definition of the dependent variable. Fourth, 52% of re-analysis effect size estimates are smaller than the original published estimates and the average statistical significance of a re-analysis is 77% of the original. Lastly, we rely on six teams of researchers working independently to answer eight additional research questions on the determinants of robustness reproducibility. Most teams find a negative relationship between replicators' experience and reproducibility, while finding no relationship between reproducibility and the provision of intermediate or even raw data combined with the necessary cleaning codes.