530 Physik
Refine
Year of publication
Document Type
- Article (961) (remove)
Keywords
- diffusion (25)
- anomalous diffusion (22)
- gamma rays: general (20)
- ISM: supernova remnants (12)
- cosmic rays (12)
- stars: massive (11)
- organic solar cells (9)
- stars: atmospheres (9)
- astroparticle physics (8)
- perovskite solar cells (8)
Institute
- Institut für Physik und Astronomie (886)
- Institut für Chemie (36)
- Institut für Mathematik (15)
- Extern (8)
- Institut für Geowissenschaften (6)
- Institut für Umweltwissenschaften und Geographie (6)
- Mathematisch-Naturwissenschaftliche Fakultät (5)
- Fachgruppe Politik- & Verwaltungswissenschaft (3)
- Hasso-Plattner-Institut für Digital Engineering gGmbH (3)
- Institut für Biochemie und Biologie (3)
- Department Linguistik (2)
- Institut für Informatik und Computational Science (2)
- Sozialwissenschaften (2)
- Hasso-Plattner-Institut für Digital Engineering GmbH (1)
- Institut für Ernährungswissenschaft (1)
- Potsdam Institute for Climate Impact Research (PIK) e. V. (1)
- UP Transfer (1)
Experimental results show that the polymerization of pyrrole in the presence of beta-naphthalenesulfonic acid and different fluorosurfactants like perfluorooctanesulfonic acid, perfluorooctyldiethanolamide, and ammonium perfluorooctanoate leads to polypyrrole with special morphologies, such as rings or disks and rectangular frames or plates. The formation of these unusually shaped particles of polymer dispersions is explained by the chemical and colloidal peculiarities of the oxidative pyrrole polymerization with ammonium peroxodisulfate in aqueous medium.
Three methods for the determination of the surface tension of liquids based on force measurements namely, the vertical plate method of Wilhelmy, the frame method of Lenard and the ring method of du Nouy are compared and studied in respect of a common principle of correction. It is shown that these three most important force-based methods allow the determination of the surface tension under static conditions. The force components of the corresponding liquid column below the measuring wire obtained for the straight part of the withdrawal curve up to the transition in its curved part provides exact surface tension values. The experimentally accessible value of the force component describes the physical background of the measured value correction contrary to the approximate equations obtained by mathematical way. Usually the determination of surface tension of liquids is based merely at the vertical plate method on exact equations thermodynamically derived whereas in the case of the frame and ring methods correction factors in approximate equations are used. At usual application of the force-based methods under the non-static condition of the withdrawal of a liquid column, the force maximum measured at withdrawal of the measuring object (plate, frame, or ring) is the basis for the determination of surface tension. In these cases, the measured surface tension values are compensated by correction equations for the frame and ring methods which are based on an correction factor and correction tables empirically obtained. The surface tension values obtained in this usual way agree with those obtained by using the force component of the corresponding liquid column below the measuring wire for the straight part of the withdrawal curve up to the transition in its curved part. Problems arising at the force measurements with increasing thickness of the measuring wires inside and outside the rings are discussed.
Optical excitation of spin-ordered rare earth metals triggers a complex response of the crystal lattice since expansive stresses from electron and phonon excitations compete with a contractive stress induced by spin disorder. Using ultrafast x-ray diffraction experiments, we study the layer specific strain response of a dysprosium film within a metallic heterostructure upon femtosecond laser-excitation. The elastic and diffusive transport of energy to an adjacent, non-excited detection layer clearly separates the contributions of strain pulses and thermal excitations in the time domain. We find that energy transfer processes to magnetic excitations significantly modify the observed conventional bipolar strain wave into a unipolar pulse. By modeling the spin system as a saturable energy reservoir that generates substantial contractive stress on ultrafast timescales, we can reproduce the observed strain response and estimate the time- and space dependent magnetic stress. The saturation of the magnetic stress contribution yields a non-monotonous total stress within the nanolayer, which leads to unconventional picosecond strain pulses.
We employ Bayesian statistics using the nested-sampling algorithm to compare and rank multiple models of ergodic diffusion (including anomalous diffusion) as well as to assess their optimal parameters for in silico-generated and real time-series. We focus on the recently-introduced model of Brownian motion with "diffusing diffusivity'-giving rise to widely-observed non-Gaussian displacement statistics-and its comparison to Brownian and fractional Brownian motion, also for the time-series with some measurement noise. We conduct this model-assessment analysis using Bayesian statistics and the nested-sampling algorithm on the level of individual particle trajectories. We evaluate relative model probabilities and compute best-parameter sets for each diffusion model, comparing the estimated parameters to the true ones. We test the performance of the nested-sampling algorithm and its predictive power both for computer-generated (idealised) trajectories as well as for real single-particle-tracking trajectories. Our approach delivers new important insight into the objective selection of the most suitable stochastic model for a given time-series. We also present first model-ranking results in application to experimental data of tracer diffusion in polymer-based hydrogels.
The velocity distribution function of granular gases in the homogeneous cooling state as well as some heated granular gases decays for large velocities as f proportional to exp(-const x nu). That is, its high-energy tail is overpopulated as compared with the Maxwell distribution. At the present time, there is no theory to describe the influence of the tail on the kinetic characteristics of granular gases. We develop an approach to quantify the overpopulated tail and analyze its impact on granular gas properties, in particular on the cooling coefficient. We observe and explain anomalously slow relaxation of the velocity distribution function to its steady state.
This paper discusses translocation features of the 20S proteasome in order to explain typical proteasome length distributions. We assume that the protein transport depends significantly on the fragment length with some optimal length which is transported most efficiently. By means of a simple one-channel model, we show that this hypothesis can explain both the one- and the three-peak length distributions found in experiments. A possible mechanism of such translocation is provided by so-called fluctuation-driven transport.
Archival X-ray spectra of the four prominent single, non-magnetic O stars zeta Pup, zeta Ori, xi Per and zeta Oph, obtained in high resolution with Chandra HETGS/MEG have been studied. The resolved X-ray emission line profiles provide information about the shocked, hot gas which emits the X-radiation, and about the bulk of comparably cool stellar wind material which partly absorbs this radiation. In this paper, we synthesize X-ray line profiles with a model of a clumpy stellar wind. We find that the geometrical shape of the wind inhomogeneities is important: better agreement with the observations can be achieved with radially compressed clumps than with spherical clumps. The parameters of the model, i.e. chemical abundances, stellar radius, mass-loss rate and terminal wind velocity, are taken from existing analyses of UV and optical spectra of the programme stars. On this basis, we also calculate the continuum-absorption coefficient of the cool-wind material, using the Potsdam Wolf-Rayet (POWR) model atmosphere code. The radial location of X-ray emitting gas is restricted from analysing the FIR line ratios of helium-like ions. The only remaining free parameter of our model is the typical distance between the clumps; here, we assume that at any point in the wind there is one clump passing by per one dynamical time-scale of the wind. The total emission in a model line is scaled to the observation. There is a good agreement between synthetic and observed line profiles. We conclude that the X-ray emission line profiles in O stars can be explained by hot plasma embedded in a cool wind which is highly clumped in the form of radially compressed shell fragments.
Context. Very massive stars pass through the Wolf-Rayet (WR) stage before they finally explode. Details of their evolution have not yet been safely established, and their physics are not well understood. Their spectral analysis requires adequate model atmospheres, which have been developed step by step during the past decades and account in their recent version for line blanketing by the millions of lines from iron and iron-group elements. However, only very few WN stars have been re-analyzed by means of line-blanketed models yet. Aims. The quantitative spectral analysis of a large sample of Galactic WN stars with the most advanced generation of model atmospheres should provide an empirical basis for various studies about the origin, evolution, and physics of the Wolf-Rayet stars and their powerful winds. Methods. We analyze a large sample of Galactic WN stars by means of the Potsdam Wolf-Rayet (PoWR) model atmospheres, which account for iron line blanketing and clumping. The results are compared with a synthetic population, generated from the Geneva tracks for massive star evolution. Results. We obtain a homogeneous set of stellar and atmospheric parameters for the GalacticWN stars, partly revising earlier results. Conclusions. Comparing the results of our spectral analyses of the Galactic WN stars with the predictions of the Geneva evolutionary calculations, we conclude that there is rough qualitative agreement. However, the quantitative discrepancies are still severe, and there is no preference for the tracks that account for the effects of rotation. It seems that the evolution of massive stars is still not satisfactorily understood.
We demonstrate that a multiple delayed feedback is a powerful tool to control coherence properties of autonomous self-sustained oscillators. We derive the equation for the phase dynamics in presence of noise and delay, and analyze it analytically. In Gaussian approximation a closed set of equations for the frequency and the diffusion constant is obtained. Solutions of these equations are in good agreement with direct numerical simulations.
It is shown that several polymers can form insoluble interfacial layers on a poly (ethylenedioxythiophene):poly(styrene sulfonate) (PEDOT:PSS) layer after annealing of the double-layer structure. The thickness of the interlayer is dependent on the characteristics of the underlying PEDOT.PSS and the molecular weight of the polymers. It is further shown that the electronic structures of the interlayer polymers have a significant effect on the properties of red-light-emitting polymer-based electrophosphorescent devices. Upon increasing the highest occupied molecular orbital and lowest unoccupied molecular orbital positions, a significant increase in current density and device efficiency is observed. This is attributed to efficient blocking of electrons in combination with direct injection of holes from the interlayer to the phosphorescent dye. Upon proper choice of the interlayer polymer, efficient red, polymer-based electrophosphorescent devices with a peak luminance efficiency of 5.5 cd A(-1) (external quantum efficiency = 6 %) and a maximum power-conversion efficiency of 5 Im W-1 can be realized.