Refine
Has Fulltext
- no (3)
Year of publication
- 2022 (3)
Document Type
- Article (3)
Language
- English (3)
Is part of the Bibliography
- yes (3)
Keywords
- Absorbed dose (1)
- Dose rate (1)
- RADFET (1)
- RADFETs (1)
- Radiation hardness (1)
- Self-adaptive MPSoC (1)
- annealing (1)
- decoupling capacitors (1)
- fading (1)
- irradiation (1)
- pMOS radiation dosimeter (1)
- sensitivity (1)
- single event transients (1)
- standard delay cells (1)
Instruments for measuring the absorbed dose and dose rate under radiation exposure, known as radiation dosimeters, are indispensable in space missions. They are composed of radiation sensors that generate current or voltage response when exposed to ionizing radiation, and processing electronics for computing the absorbed dose and dose rate. Among a wide range of existing radiation sensors, the Radiation Sensitive Field Effect Transistors (RADFETs) have unique advantages for absorbed dose measurement, and a proven record of successful exploitation in space missions. It has been shown that the RADFETs may be also used for the dose rate monitoring. In that regard, we propose a unique design concept that supports the simultaneous operation of a single RADFET as absorbed dose and dose rate monitor. This enables to reduce the cost of implementation, since the need for other types of radiation sensors can be minimized or eliminated. For processing the RADFET's response we propose a readout system composed of analog signal conditioner (ASC) and a self-adaptive multiprocessing system-on-chip (MPSoC). The soft error rate of MPSoC is monitored in real time with embedded sensors, allowing the autonomous switching between three operating modes (high-performance, de-stress and fault-tolerant), according to the application requirements and radiation conditions.
The radiation-sensitive field-effect transistors (RADFETs) with an oxide thickness of 400 nm are irradiated with gate voltages of 2, 4 and 6 V, and without gate voltage.
A detailed analysis of the mechanisms responsible for the creation of traps during irradiation is performed.
The creation of the traps in the oxide, near and at the silicon/silicon-dioxide (Si/SiO2) interface during irradiation is modelled very well. This modelling can also be used for other MOS transistors containing SiO2.
The behaviour of radiation traps during postirradiation annealing is analysed, and the corresponding functions for their modelling are obtained. The switching traps (STs) do not have significant influence on threshold voltage shift, and two radiation-induced trap types fit the fixed traps (FTs) very well. The fading does not depend on the positive gate voltage applied during irradiation, but it is twice lower in case there is no gate voltage.
A new dosimetric parameter, called the Golden Ratio (GR), is proposed, which represents the ratio between the threshold voltage shift after irradiation and fading after spontaneous annealing. This parameter can be useful for comparing MOS dosimeters.
Analysis of single event transient effects in standard delay cells based on decoupling capacitors
(2022)
Single Event Transients (SETs), i.e., voltage glitches induced in combinational logic as a result of the passage of energetic particles, represent an increasingly critical reliability threat for modern complementary metal oxide semiconductor (CMOS) integrated circuits (ICs) employed in space missions.
In rad-hard ICs implemented with standard digital cells, special design techniques should be applied to reduce the Soft Error Rate (SER) due to SETs.
To this end, it is essential to consider the SET robustness of individual standard cells. Among the wide range of logic cells available in standard cell libraries, the standard delay cells (SDCs) implemented with the skew-sized inverters are exceptionally vulnerable to SETs. Namely, the SET pulses induced in these cells may be hundreds of picoseconds longer than those in other standard cells.
In this work, an alternative design of a SDC based on two inverters and two decoupling capacitors is introduced. Electrical simulations have shown that the propagation delay and SET robustness of the proposed delay cell are strongly influenced by the transistor sizes and supply voltage, while the impact of temperature is moderate. The proposed design is more tolerant to SETs than the SDCs with skew-sized inverters, and occupies less area compared to the hardening configurations based on partial and complete duplication.
Due to the low transistor count (only six transistors), the proposed delay cell could also be used as a SET filter.