Refine
Has Fulltext
- no (22)
Document Type
- Article (19)
- Conference Proceeding (2)
- Monograph/Edited Volume (1)
Is part of the Bibliography
- yes (22)
Keywords
- radical polymerization (3)
- copolymerization (2)
- ) (1)
- EPR (1)
- ESR (1)
- atom transfer radical polymerization (ATRP) (1)
- block copolymers (1)
- fluorinated olefins (1)
- fluoropolymers (1)
- hexafluoropropene (1)
Institute
- Institut für Chemie (22)
The SP-PLP-EPR technique is used to carry out a detailed investigation of the radical termination kinetics of 1H, 1H, 2H, 2H-tridecafluorooctyl methacrylate (TDFOMA) in bulk at relatively low conversion. Composite-model behavior for chain-length-dependent termination rate coefficients, kti,i, is observed. It is found that for TDFOMA, ic approximate to 60 independent of temperature, and as approximate to 0.65 and al approximate to 0.2 at 80 degrees C and above. However, at lower temperatures the situation is strikingly different, with the significantly higher average values of as = 0.89 +/- 0.15 and al = 0.32 +/- 0.10 being obtained at 50 degrees C and below. This makes TDFOMA the first monomer to be found that exhibits clearly different exponent values, as and al, at lower and higher temperature, and that has both a high as, like an acrylate, and a high ic, like a methacrylate.
Propagation rate coefficients for homogeneous phase VDF-HFP copolymerization in supercritical CO2
(2012)
For the first time, propagation rate coefficients, kp,COPO, for the copolymerizations of vinylidene fluoride and hexafluoropropene have been determined. The kinetic data was determined via pulsed-laser polymerization in conjunction with polymer analysis via size-exclusion chromatography, the PLP-SEC technique. The experiments were carried out in homogeneous phase with supercritical CO2 as solvent for temperatures ranging from 45 to 90 degrees C. Absolute polymer molecular weights were calculated on the basis of experimentally determined MarkHouwink constants. The Arrhenius parameters of kp,COPO vary significantly compared with ethene, which is explained by the high electronegativity of fluorine and less intra- and intermolecular interactions between the partially fluorinated macroradicals.
Mesoporous silica monoliths were prepared by the sol - gel technique and. lled with 1-ethyl-3-methyl imidazolium [Emim]-X (X = dicyanamide [N(CN)(2)], ethyl sulfate [EtSO4], thiocyanate [SCN], and triflate [TfO]) ionic liquids (ILs) using a methanol-IL exchange technique. The structure and behavior of the ILs inside the silica monoliths were studied using X-ray scattering, nitrogen sorption, IR spectroscopy, solid-state NMR, and thermal analysis. DSC finds shifts in both the glass transition temperature and melting points (where applicable) of the ILs. Glass transition and melting occur well below room temperature. There is thus no conflict with the NMR and IR data, which show that the ILs are as mobile at room temperature as the bulk (not confined) ILs. The very narrow line widths of the NMR spectra suggest that the ILs in our materials have the highest mobility reported for confined ILs so far. As a result, our data suggest that it is possible to generate IL/silica hybrid materials (ionogels) with bulk-like properties of the IL. This could be interesting for applications in, e.g., the solar cell or membrane fields.
The generation of nanoscale primary poly(vinylidene fluoride) (PVDF) particles by rapid expansion of supercritical solutions (RESS) is reported. The experimental results show that RESS enables the formation of PVDF particles with median particle diameters ranging from 56 to 226 nm and that the size of PVDF particles can be influenced by polymer properties. The particle size can be decreased either by increasing molar mass, in case of identical polymer end groups, or by increasing the degree of crystallinity, in case of similar molar mass and different end groups.
The influence of the reaction medium (organic solvents, water, ionic liquids, supercritical CO2) on the propagation rate in radical polymerizations has very different causes, e.g., hindered rotational modes, hydrogen bonding or electron pair donor/acceptor interactions. Depending on the origin of the solvent influence propagation rate coefficients, k(P), may be enhanced by up to an order of magnitude associated with changes in the pre-exponential or the activation energy of k(P). In contrast, non-specific interactions, size and steric effects lead to rather small changes in the vicinity of the radical chain end and are reflected by modest variations in k(P).
The surface of carbon black (CB) nanoparticles was functionalized with poly(vinylidene fluoride) (PVDF) either by trapping of macroradicals or by cycloaddition. PVDF with two iodine end groups (I-PVDF-I) obtained from iodine transfer polymerization in supercritical CO2 was heated in the presence of CB and the C-I bond was cleaved resulting in a reaction between the macroradical and the CB surface. To allow for cycloaddition of PVDF to the CB surface for a number of polymers, the iodine end groups were replaced by azide end groups. In addition, microwave irradiation was applied to the functionalization. The influence of temperature, time, polymer concentration, and polymer molar mass on the functionalization reaction was examined.
Individual rate coefficients for 1H,1H,2H,2H-tridecafluorooctyl methacrylate radical polymerizations
(2010)
Kinetic data for radical polymerizations of 1H,1H,2H,2H-tridecafluorooctyl methacrylate (TDFOMA) in bulk is reported. Pulsed laser initiated polymerizations yield propagation rate coefficients, k(p), which are by a factor of 1.9 higher than methyl methacrylate k(p). The activation energy of TDFOMA k(p) is not significantly different from that of alkyl methacrylates. Chain-length averaged termination rate coefficients were estimated from chemically initiated polymerizations with in-line FT-NIR spectroscopic monitoring of monomer conversion. Up to 30% of monomer conversion TDFOMA termination rate coefficients are only slightly below MMA low conversion values. The result is suggested to be due to less interactions between the macroradicals compared to nonfluorinated systems.
The influence of the reaction medium (organic solvents, water, ionic liquids, supercritical CO2) on the propagation rate in radical polymerizations has very different causes, e.g., hindered rotational modes, hydrogen bonding, or electron pair donor / acceptor interactions. Depending on the origin of the solvent influence propagation rate coefficients, kp, may be enhanced by up to an order of magnitude associated with changes in the pre-exponential or the activation energy of kp. Contrary, non-specific interactions, size and steric effects lead to rather small changes in the vicinity of the radical chain end and are reflected by modest variations in kp.
In ihrer Vorlesung zeigt Sabine Beuermann, unter welchen Bedingungen Kohlendioxid als Reaktionsmedium für die Herstellung von polymeren Materialien genutzt werden kann. Fluides Kohlendioxid ist ein attraktives Reaktionsmedium, da es ungiftig und nicht brennbar ist. Zudem leistet es einen wichtigen Beitrag zur Entwicklung nachhaltiger chemischer Prozesse, da durch den Einsatz von Kohlendioxid die Verwendung von organischen Lösungsmitteln vermieden werden kann.