Filtern
Dokumenttyp
Sprache
- Englisch (3) (entfernen)
Gehört zur Bibliographie
- ja (3)
Schlagworte
- AFM (3) (entfernen)
Institut
- Institut für Physik und Astronomie (3) (entfernen)
In this paper we report on the interaction between photosensitive azobenzene-containing polymer films and on top adsorbed graphene multilayers. The photosensitive polymer film changes its topography under irradiation with light interference patterns according to their polarization distribution. The multilayer graphene follows the deformation of the polymer film and stretches accordingly. Using confocal Raman microspectroscopy we can detect the appearance of additional peaks in the Raman spectrum of the photosensitive polymer film upon irradiation indicating a molecular interaction at the interface between the graphene multilayer and the polymer matrix. Multi-component analysis of the specific Raman bands shows that the interaction involves the graphene rings and the aromatic rings of the azobenzenes causing the strong adhesion between the two materials.
The thermal behavior of poly(methoxydiethylenglycol acrylate) (PMDEGA) is studied in thin hydrogel films on solid supports and is compared with the behavior in aqueous solution. The PMDEGA hydrogel film thickness is varied from 2 to 422 nm. Initially, these films are homogenous, as measured with optical microscopy, atomic force microscopy, X-ray reflectivity, and grazing-incidence small-angle X-ray scattering (GISAXS). However, they tend to de-wet when stored under ambient conditions. Along the surface normal, no long-ranged correlations between substrate and film surface are detected with GISAXS, due to the high mobility of the polymer at room temperature. The swelling of the hydrogel films as a function of the water vapor pressure and the temperature are probed for saturated water vapor pressures between 2,380 and 3,170 Pa. While the swelling capability is found to increase with water vapor pressure, swelling in dependence on the temperature revealed a collapse phase transition of a lower critical solution temperature type. The transition temperature decreases from 40.6 A degrees C to 36.6 A degrees C with increasing film thickness, but is independent of the thickness for very thin films below a thickness of 40 nm. The observed transition temperature range compares well with the cloud points observed in dilute (0.1 wt.%) and semi-dilute (5 wt.%) solution which decrease from 45 A degrees C to 39 A degrees C with increasing concentration.
The correlations between the chemical structures of the 2,5-diphenyl-1,3,4-oxadiazole compounds and their corresponding vapour deposited film structures on Si/SiO2 were systematically investigated with AFM, XSR and IR for the first time. The result shows that the film structure depends strongly on the substrate temperature (Ts). For the compounds with ether bridge group, the film periodicity depends linearly on the length of the aliphatic chain. The films based on those oxadiazols have ordered structure in the investigated substrate temperature region, while die amide bridged compounds form ordered film only at high Ts due to the formation of intermolecular H-bond. The tilt angle of most molecules is determined by the pi-pi complexes between the molecules. The intermolecular interaction between head groups leads to the structural transformation during the thermal treatment after deposition. All the ether bridged oxadiazoles form films with bilayer structure, while amide bridged oxadiazole form film bilayer structure only when the molecule has a head group.