Refine
Has Fulltext
- no (26)
Document Type
- Article (26) (remove)
Language
- English (26) (remove)
Is part of the Bibliography
- yes (26)
Keywords
- LCST (2)
- RAFT polymerization (2)
- polyzwitterions (2)
- Block copolymer (1)
- Block copolymers (1)
- Dehydration (1)
- In-situ neutron reflectivity (1)
- Light scattering (1)
- Responsive polymer (1)
- SANS (1)
- Schizophrenic self-assembly (1)
- Sulfobetaine methacrylate (1)
- Thermosensitivity (1)
- UCST (1)
- Vacuum drying (1)
- amphiphile (1)
- anti-fouling materials (1)
- block copolymer (1)
- block copolymers (1)
- colloidal aggregation (1)
- cononsolvency (1)
- critical solution temperature (1)
- degradable polymers (1)
- dynamic light scattering (1)
- fluorescent dyemonomers (1)
- hydrolysis (1)
- interaction potential (1)
- inverse micelles (1)
- lower (1)
- lower critical solution temperature (1)
- macrosurfactant (1)
- macrosurfactants (1)
- metathesis (1)
- micelles (1)
- molecular thermometers (1)
- naphthalimide (1)
- phase behavior (1)
- poly(N-vinylcaprolactam) (1)
- polyacrylamide (1)
- polymer amphiphile (1)
- polymer degradation (1)
- polymer solutions (1)
- polymeric sensors (1)
- polysulfabetaine (1)
- polysulfobetaine (1)
- polysulfobetaines (1)
- polyzwitterion (1)
- responsive systems (1)
- ring-opening polymerization (1)
- salting-in (1)
- self-assembled micelles (1)
- solvatochromism (1)
- stability (1)
- sulfoxide (1)
- sustainable chemistry (1)
- thermo-responsive polymers (1)
- thermoplastics (1)
- thermoresponsive polymers (1)
- thermoresponsive self-assembly (1)
- upper critical solution temperature (UCST) (1)
- water-soluble polymers (1)
Institute
The effect of chain architecture on the swelling and thermal response of thin films obtained from an amphiphilic three-arm star-shaped thermo-responsive block copolymer poly(methoxy diethylene glycol acrylate)-block-polystyrene ((PMDEGA-b-PS)(3)) is investigated by in situ neutron reflectivity (NR) measurements. The PMDEGA and PS blocks are micro-phase separated with randomly distributed PS nanodomains. The (PMDEGA-b-PS)(3) films show a transition temperature (TT) at 33 degrees C in white light interferometry. The swelling capability of the (PMDEGA-b-PS)(3) films in a D2O vapor atmosphere is better than that of films from linear PS-b-PMDEGA-b-PS triblock copolymers, which can be attributed to the hydrophilic end groups and limited size of the PS blocks in (PMDEGA-b-PS)(3). However, the swelling kinetics of the as-prepared (PMDEGA-b-PS)(3) films and the response of the swollen film to a temperature change above the TT are significantly slower than that in the PS-b-PMDEGA-b-PS films, which may be related to the conformation restriction by the star-shape. Unlike in the PS-b-PMDEGA-b-PS films, the amount of residual D2O in the collapsed (PMDEGA-b-PS)(3) films depends on the final temperature. It decreases from (9.7 +/- 0.3)% to (7.0 +/- 0.3)% or (6.0 +/- 0.3)% when the final temperatures are set to 35 degrees C, 45 degrees C and 50 degrees C, respectively. This temperature-dependent reduction of embedded D2O originates from the hindrance of chain conformation from the star-shaped chain architecture.
Based on diblock copolymers, a pair of "schizophrenic" micellar systems is designed by combining a nonionic and thermoresponsive block with a zwitterionic block, which is thermoresponsive and salt-sensitive. The nonionic block is poly(N-isopropylacrylamide) (PNIPAM) or poly(N-isopropylmethacrylamide) (PNIPMAM) and exhibits a lower critical solution temperature (LCST) behavior in aqueous solution. The zwitterionic block is a polysulfobetaine, i.e., poly(4((3-methacrylamidopropyl)dimethylammonio)butane-1-sulfonate) (PSBP), and has an upper critical solution temperature (UCST) behavior with the clearing point decreasing with increasing salt concentration. The PSBP-b-PNIPAM and PSBP-b-PNIPMAM diblock copolymers are prepared by successive reversible addition-fragmentation chain transfer (RAFT) polymerizations. The PSBP block is chosen such that the clearing point of the homopolymer is significantly higher in pure water than the cloud point of PNIPAM or PNIPMAM. Using turbidimetry, H-1 NMR, and small-angle neutron scattering, we investigate the overall phase behavior as well as the structure and interaction between the micelles and the intermediate phase, both in salt-free D2O and in 0.004 M NaBr in D2O in a wide temperature range. We find that PSBP-b-PNIPAM at 50 g L-1 in salt-free D2O is turbid in the entire temperature range. It forms spherical micelles below the cloud point of PNIPAM and cylindrical micelles above. Similar behavior is observed for PSBP-b-PNIPMAM at 50 g L-1 in salt-free D2O with a slight and smooth increase of the light transmission below the cloud point of PNIPMAM and an abrupt decrease above. Upon addition of 0.004 M NaBr, the UCST-type cloud point of the PSBP-block is notably decreased, and an intermediate regime is encountered below the cloud point of PNIPMAM, where the light transmission is slightly enhanced. In this regime, the polymer solution exhibits behavior typical for polyelectrolyte solutions. Thus, double thermosensitive and salt-sensitive behavior with "schizophrenic" micelle formation is found, and the width of the intermediate regime, where both blocks are hydrophilic, can be tuned by the addition of electrolyte.
The thermoresponsive behavior of two diblock copolymers PS-b-PNIPAM and PS-b-PMDEGA, which both comprise a hydrophobic polystyrene (PS) block but different thermoresponsive blocks, also differing in length, poly(N-isopropylacrylamide) (PNIPAM) and poly(methoxy diethylene glycol acrylate) (PMDEGA), respectively, was comparatively investigated in a wide temperature range. Concentrated aqueous solutions containing 25 wt % polymer were studied by small-angle X-ray scattering (SAXS), differential scanning calorimetry (DSC), and broadband dielectric spectroscopy (BDS). DSC measurements show that, during the demixing phase transition, the hydration number per oligo(ethylene glycol) side chain in the PS-b-PMDEGA solution decreases rather gradually, even up to 20 °C above the onset of the transition, i.e., the cloud point (CP). In contrast, the PS-b-PNIPAM solution exhibits an abrupt, stepwise dehydration behavior at its CP, indicated by the sharp, narrow endothermic peak. BDS measurements suggest that the organization of the expelled water during the phase transition and the subsequent evolution of the micellar aggregates are different for the two copolymers. In the PS-b-PMDEGA solution, the long-range charge transport process changes significantly at its CP and strong interfacial polarization processes appear, probably due to charge accumulation at the interfaces between the micellar aggregates and the aqueous medium. On the contrary, in the PS-b-PNIPAM solution, the phase transition has only a marginal effect on the long-range conduction process and is accompanied by a reduction in the high-frequency (1 MHz) dielectric permittivity, ε′. The latter effect is attributed to the reduced polarization strength of local chain modes due to an enhancement of intra- and interchain hydrogen bonds (HBs) in the polymer-rich phase during the water detaching process. Surprisingly, our BDS measurements indicate that prior to both the demixing and remixing processes the local chain mobility increases temporally. Our dielectric studies suggest that for PS-b-PNIPAM the water detaching process initiates a few degrees below CP and that the local chain mobility and intra- and/or interchain HBs of the PNIPAM blocks may control its thermoresponsive behavior. Dielectric “jump” experiments show that the kinetics of micellar aggregation in the PS-b-PMDEGA solution is slower than that in the PS-b-PNIPAM solution and is independent of the target temperature within the two-phase region. From the experimental point of view, it is shown that the dielectric susceptibility, especially, the dielectric permittivity, ε′, is a well-suited probe for monitoring both the reversible changes in the molecular dipolar bond polarizability and the long-range interfacial polarization at the phase transition.
A 2-fold thermoresponsive diblock copolymer PSPP430-b-PNIPAM(200) consisting of a zwitterionic polysulfobetaine (PSPP) block and a nonionic poly(N-isopropylacrylamide) (PNIPAM) block is prepared by successive RAFT polymerizations. In aqueous solution, the corresponding homopolymers PSPP and PNIPAM feature both upper and lower critical solution temperature (UCST and LCST) behavior, respectively. The diblock copolymer exhibits thermally induced "schizophrenic" aggregation behavior in aqueous solutions. Moreover, the ion sensitivity of the, cloud point of the zwitterionic PSPP block to both the ionic strength and the nature of the salt offers the possibility to create switchable systems which respond sensitively to changes of the temperature and of the electrolyte type and concentration. The diblock copolymer solutions in D2O are investigated by means of turbidimetry and small-angle neutron scattering (SANS) with respect to the phase behavior and the self-assembled structures in dependence on temperature and electrolyte content. Marked, differences of the aggregation below the UCST-type and above the LCST-type transition are observed. The addition of a small amount of NaBr (0.004 M) does not affect the overall behavior, and only the UCST-type transition and aggregate structures are slightly altered, reflecting the well-known ion sensitivity of the zwitterionic PSPP block.
Several series of presumed dual thermo-responsive diblock copolymers consisting of one non-ionic and one zwitterionic block were synthesized via consecutive reversible addition-fragmentation chain transfer (RAFT) polymerization. For all copolymers, poly(N-isopropylmethacrylamide) was chosen as non-ionic block that shows a coil-to-globule collapse transition of the lower critical solution temperature (LCST) type. In contrast, the chemical structure of zwitterionic blocks, which all belonged to the class of poly(sulfobetaine methacrylate)s, was varied broadly, in order to tune their coil-to-globule collapse transition of the upper critical solution temperature (UCST) type. All polymers were labeled with a solvatochromic fluorescent end-group. The dual thermo-responsive behavior and the resulting multifarious temperature-dependent self-assembly in aqueous solution were mapped by temperature resolved turbidimetry, H-1 NMR spectroscopy, dynamic light scattering (DLS), and fluorescence spectroscopy. Depending on the relative positions between the UCST-type and LCST-type transition temperatures, as well as on the width of the window in-between, all the four possible modes of stimulus induced micellization can be realized. This includes classical induced micellization due to a transition from a double hydrophilic, or respectively, from a double hydrophobic to an amphiphilic state, as well as "schizophrenic" behavior, where the core- and shell-forming blocks are inverted. The exchange of the roles of the hydrophilic and hydrophobic block in the amphiphilic states is possible through a homogeneous intermediate state or a heterogeneous one. (C) 2017 Elsevier Ltd. All rights reserved.