Refine
Has Fulltext
- no (37)
Year of publication
Document Type
- Article (37) (remove)
Language
- English (37)
Is part of the Bibliography
- yes (37)
Keywords
Institute
We employ P to S converted waveforms to investigate effects of the hot mantle plume on seismic discontinuities of the crust and upper mantle. We observe the Moho at depths between 13 and 17 km, regionally covered by a strong shallow intracrustal converted phase. Coherent phases on the transverse component indicate either dipping interfaces, 3- D heterogeneities or lower crustal anisotropy. We find anomalies related to discontinuities in the upper mantle down to the transition zone evidently related to the hot mantle plume. Lithospheric thinning is confirmed in greater detail than previously reported by Li et al., and we determine the dimensions of the low-velocity zone within the asthenosphere with greater accuracy. Our study mainly focuses on the temperature-pressure dependent discontinuities of the upper mantle transition zone. Effects of the hot diapir on the depths of mineral phase transitions are verified at both major interfaces at 410 and 660 km. We determine a plume radius of about 200 km at the 660 km discontinuity with a core zone of about 120 km radius. The plume conduit is located southwest of Big Island. A conduit tilted in the northeast direction is required in the upper mantle to explain the observations. The determined positions of deflections of the discontinuities support the hypothesis of decoupled upper and lower mantle convection
A key question for the development of geothermal plants is the seismic detection and monitoring of fluid injections at several kilometers depth. The detection and monitoring limits are controlled by several parameters, for example, the strength of seismic sources, number of receivers, vertical stacking, and noise conditions. For a known reference reflector at 2.66 km depth at a geothermal site in northern Germany the results of a simple surface seismic experiment were therefore combined with numerical forward modeling for different injection scenarios at 3.8 km depth. The underlying idea is that changes of reflectivity from the injection at 3.8 km must be larger than the variance of the measurements to be observable. Assuming that the injection at 3.8 km depth would produce a subhorizontal disklike target with a fracture porosity of 2% or 5% (the critical porosity) the water injection volume has to be at least 443 and 115 m(3), respectively, to be detectable from the surface. If the injection on the other hand does not create subhorizontal but subvertical pathways or only reduces the seismic velocities via the increased pore pressure in the immediate vicinity of the bore hole, the injection is undetectable from the surface. The most promising approach is therefore to move sources and/or receivers closer to the target, that is, the use of borehole instrumentation
Studies of seismic tomography have been highly successful at imaging the deep structure of subduction zones. In a study complementary to these tomographic studies, we use array seismology and reflected waves to image a stagnant slab in the mantle transition zone. Using P and S (SH) waves we find a steeply dipping reflector centred at ca. 400 km depth and ca. 550 km west of the present Mariana subduction zone (at 20N, 140E). The discovery of this anomaly in tomography and independently in array seismology (this paper) helps in understanding the evolution of the Mariana margin. The reflector/stagnant slab may be the remains of the hypothetical North New Guinea Plate, which was theorized to have subducted ca. 50 Ma.
The motion of tectonic plates is accommodated at fault zones. One of the unanswered questions about fault zones relates to the role they play in controlling shallow and local hydrology. This study focuses on the Arava/Araba Fault (AF) zone, the southern portion of the Dead Sea Transform (DST) in the Middle East. We combine seismic and electromagnetic methods (EM) to image the geometry and map the petro-physical properties and water occurrence in the top 100 m of this active fault. For three profiles, P-velocity and resistivity images were derived independently. Using a neural network cluster analysis three classes with similar P-velocity and resistivities could then be determined from these images. These classes correspond to spatial domains of specific material and wetness. The first class occurs primarily east of the fault consisting of 'wet' sand (dunes) and brecciated sediments, whereas the second class composed of similar material located west of the fault is 'dry'. The third class lies at depth below ca. 50 m and is composed of highly deformed and weathered Precambrian rocks that constitute the multi-branch fault zone of the AF at this location. The combination of two independent measurements like seismics and EM linked by a stringent mathematical approach has thus shown the potential to delineate the interplay of lithology and water near active faults.
Fault zones are the locations where motion of tectonic plates, often associated with earthquakes, is accommodated. Despite a rapid increase in the understanding of faults in the last decades, our knowledge of their geometry, petrophysical properties, and controlling processes remains incomplete. The central questions addressed here in our study of the Dead Sea Transform (DST) in the Middle East are as follows: (1) What are the structure and kinematics of a large fault zone? (2) What controls its structure and kinematics? (3) How does the DST compare to other plate boundary fault zones? The DST has accommodated a total of 105 km of left-lateral transform motion between the African and Arabian plates since early Miocene (similar to 20 Ma). The DST segment between the Dead Sea and the Red Sea, called the Arava/Araba Fault (AF), is studied here using a multidisciplinary and multiscale approach from the mu m to the plate tectonic scale. We observe that under the DST a narrow, subvertical zone cuts through crust and lithosphere. First, from west to east the crustal thickness increases smoothly from 26 to 39 km, and a subhorizontal lower crustal reflector is detected east of the AF. Second, several faults exist in the upper crust in a 40 km wide zone centered on the AF, but none have kilometer-size zones of decreased seismic velocities or zones of high electrical conductivities in the upper crust expected for large damage zones. Third, the AF is the main branch of the DST system, even though it has accommodated only a part (up to 60 km) of the overall 105 km of sinistral plate motion. Fourth, the AF acts as a barrier to fluids to a depth of 4 km, and the lithology changes abruptly across it. Fifth, in the top few hundred meters of the AF a locally transpressional regime is observed in a 100-300 m wide zone of deformed and displaced material, bordered by subparallel faults forming a positive flower structure. Other segments of the AF have a transtensional character with small pull-aparts along them. The damage zones of the individual faults are only 5-20 m wide at this depth range. Sixth, two areas on the AF show mesoscale to microscale faulting and veining in limestone sequences with faulting depths between 2 and 5 km. Seventh, fluids in the AF are carried downward into the fault zone. Only a minor fraction of fluids is derived from ascending hydrothermal fluids. However, we found that on the kilometer scale the AF does not act as an important fluid conduit. Most of these findings are corroborated using thermomechanical modeling where shear deformation in the upper crust is localized in one or two major faults; at larger depth, shear deformation occurs in a 20-40 km wide zone with a mechanically weak decoupling zone extending subvertically through the entire lithosphere.
To address one of the central questions of plate tectonics-How do large transform systems work and what are their typical features?-seismic investigations across the Dead Sea Transform (DST), the boundary between the African and Arabian plates in the Middle East, were conducted for the first time. A major component of these investigations was a combined reflection/ refraction survey across the territories of Palestine, Israel and Jordan. The main results of this study are: (1) The seismic basement is offset by 3-5 km under the DST, (2) The DST cuts through the entire crust, broadening in the lower crust, (3) Strong lower crustal reflectors are imaged only on one side of the DST, (4) The seismic velocity sections show a steady increase in the depth of the crust-mantle transition (Moho) from 26 km at the Mediterranean to 39 km under the Jordan highlands, with only a small but visible, asymmetric topography of the Moho under the DST. These observations can be linked to the left-lateral movement of 105 km of the two plates in the last 17 Myr, accompanied by strong deformation within a narrow zone cutting through the entire crust. Comparing the DST and the San Andreas Fault (SAF) system, a strong asymmetry in subhorizontal lower crustal reflectors and a deep reaching deformation zone both occur around the DST and the SAF. The fact that such lower crustal reflectors and deep deformation zones are observed in such different transform systems suggests that these structures are possibly fundamental features of large transform plate boundaries
We investigate the crust, upper mantle and mantle transition zone of the Cape Verde hotspot by using seismic P and S receiver functions from several tens of local seismograph stations. We find a strong discontinuity at a depth of similar to 10 km underlain by a similar to 15-km thick layer with a high (similar to 1.9) Vp/Vs velocity ratio. We interpret this discontinuity and the underlying layer as the fossil Moho, inherited from the pre-hotspot era, and the plume-related magmatic underplate. Our uppermost-mantle models are very different from those previously obtained for this region: our S velocity is much lower and there are no indications of low densities. Contrary to previously published arguments for the standard transition zone thickness our data indicate that this thickness under the Cape Verde islands is up to similar to 30 km less than in the ambient mantle. This reduction is a combined effect of a depression of the 410-km discontinuity and an uplift of the 660-km discontinuity. The uplift is in contrast to laboratory data and some seismic data on a negligible dependence of depth of the 660-km discontinuity on temperature in hotspots. A large negative pressure-temperature slope which is suggested by our data implies that the 660-km discontinuity may resist passage of the plume.
Our data reveal beneath the islands a reduction of S velocity of a few percent between 470-km and 510-km depths. The low velocity layer in the upper transition zone under the Cape Verde archipelago is very similar to that previously found under the Azores and a few other hotspots. In the literature there are reports on a regional 520-km discontinuity, the impedance of which is too large to be explained by the known phase transitions. Our observations suggest that the 520-km discontinuity may present the base of the low-velocity layer in the transition zone.
P receiver functions from 23 stations of the SASE experiment in southern Africa are inverted simultaneously with SKS waveforms for azimuthal anisotropy in the upper mantle. Our analysis resolves the long-standing issue of depth dependence and origins of anisotropy beneath southern Africa. In the uppermost mantle we observe anisotropy with a nearly E-W fast direction, parallel to the trend of the Limpopo belt. This anisotropy may be frozen since the Archean. At a depth of 160 km the fast direction of anisotropy changes to 40 degrees and becomes close to the recent plate motion direction. This transition is nearly coincident in depth with activation of dominant glide systems in olivine and with a pronounced change in other properties of the upper mantle. Another large change in the fast direction of anisotropy corresponds to the previously found low-S-velocity layer atop the 410-km discontinuity. Citation: Vinnik, L., S. Kiselev, M. Weber, S. Oreshin, and L. Makeyeva (2012), Frozen and active seismic anisotropy beneath southern Africa, Geophys. Res. Lett., 39, L08301, doi: 10.1029/2012GL051326.