Refine
Year of publication
Document Type
- Article (2406) (remove)
Keywords
- Conformational analysis (14)
- biomaterials (13)
- nanoparticles (13)
- fluorescence (12)
- Palladium (11)
- singlet oxygen (11)
- Fluorescence (10)
- SERS (10)
- block copolymers (10)
- conformational analysis (10)
Institute
- Institut für Chemie (2406) (remove)
pH sensing in living cells represents one of the most prominent topics in biochemistry and physiology. In this study we performed one-photon and two-photon time-domain fluorescence lifetime imaging with a laser-scanning microscope using the time-correlated single-photon counting technique for imaging intracellular pH levels. The suitability of different commercial fluorescence dyes for lifetime-based pH sensing is discussed on the basis of in vitro as well of in situ measurements. Although the tested dyes are suitable for intensity-based ratiometric measurements, for lifetime- based techniques in the time-domain so far only BCECF seems to meet the requirements of reliable intracellular pH recordings in living cells.
Molecule-detective
(2006)
Biosensors are analytical devices incorporating biological material (receptor) intimately associated with or integrated within a physicochernical transducer. Advantages are the high selectivity for analyte detection. Examples given comprise the very successful commercial blood glucose biosensors made for the self-control by the diabetic patients. Other biosensors are part of an analytic system, including the sensor chips Of surface plasmon resonance or interferometry based devices, piezoelectric or reflectometric sensors capable of direct measurement of mass changes, and thermometric and other reagentless sensors. The development of nanotubes-based devices allows for significant enhancment of the signal-to-noise ratio of the biosensors. A milestone on the way towards miniaturization and parallelization of biosensors is the recently developed and prize-winning electronic DNA chip
The crude methanol extract of the seeds of Derris trifoliata showed potent and dose dependent larvicidal activity against the 2nd instar larvae of Aedes aegypti. From this extract two unusual rotenoid derivatives, a rotenoloid (named 7a-O-methyl-12a-hydroxydeguelol) and a spirohomooxarotenoid (named spiro-13-homo-13-oxaelliptone), were isolated and characterised. In addition a rare natural chromanone (6,7-dimethoxy-4-chromanone) and the known rotenoids rotenone, tephrosin and dehydrodeguelin were identified. The structures were assigned on the basis of spectroscopic evidence. The larvicidal activity of the crude extract is mainly due to rotenone. (c) 2006 Elsevier Ltd. All rights reserved
The complexes [(HgCl2)(2)((ch)(2)30S(4)O(6))] (1), [HgCl,(mn21S(2)O(5))] (2), [HgCl2(ch18S(2)O(4))] (3) and [HgI(meb12S(2)O(2))](2)[Hg2I6] (4) have been synthesized, characterized and their crystal structures were determined. In [(HgCl2)(2)((ch)(2)3OS(4)O(6))] two HgCl2 units are discretely bonded within the ligand cavity of the 30-membered dichinoxaline-tetrathia-30-crown-10 ((ch)(2)30S(4)O(6)) forming a binuclear complex. HgCl2 forms I : I "in-cavity" complexes with the 21-membered maleonitrile-dithia-21-crown-7(mn21S(2)O(5)) ligand and the 18-membered chinoxaline- dithia-18-crown-6 (ch18S(2)O(4)) ligand, respectively. The 12-membered 4-methyl-benzo-dithia-12-crown-4 (meb12S(2)O(2)) ligand gave with two equivalents HgI2 the compound [HgI(meb12S(2)O(2))](2)[Hg2I6]. In the cation [HgI(meb12S(2)O(2))](+) meb12S(2)O(2) forms with the cation HgI+ a half-sandwich complex
The electronic effects of the 5- and 6-membered heterocyclic rings on the C=N-N unit of five different hydrazone derivatives of pyridine-2-, -3- and -4-carbaldehydes, pyrrole-2-carbaldehyde, furan-2- and -3-carbaldehydes and thiophene-2- and -3-carbaldehydes have been studied with the aid of 13C and 15N NMR measurements together with the natural bond orbital (NBO) analysis. As model compounds are used the corresponding substituted benzaldehyde derivatives. The polarization of the C=N unit of the hydrazone functionality of the heteroaryl derivatives occurs in an analogous manner with that of phenyl derivatives. The electron-withdrawing heteroaryl groups destabilize and the electron-donating groups stabilize the positive charge development at the CN carbon while the effect on the negative charge development is opposite. The 15N NMR chemical shift of the C=N and C=N-N nitrogens and the NBO charges at C=N-N unit can be correlated with the replacement substituent constants of the heteroaryl groups. 13C NMR shifts of the C=N carbon of N,N- dialkylhydrazones of the heteroarenecarbaldehydes can be correlated with a dual parameter equation possessing the polar substituent constant ;* of the heteroaryl group and the electronegativity of the heteroatom as variables.
The report shows that simple LbL deposition of positively charged chitosan and negatively charged heparin can be used to efficiently modify the native surface of both NiTi and Ti without any previous treatments. Moreover, mineralization of the polymer multilayers with calcium phosphate leads to surfaces with low contact angles around 70 and 20 degrees for NiTi and Ti, respectively. This suggests that a polymer multilayer/calcium phosphate hybrid coating could be useful for making NiTi or Ti implants that are at the same time antibacterial (via the chitosan), suppress blood clot formation (via the heparin), and favor fast endothelialization (via the improved surface hydrophilicity compared to the respective neat material).
Metal ion induced self-assembly of the rigid ligand 1,4-bis(2,2':6',2 ''-terpyridine- 4'-yl) benzene (1) with Fe(II), Co(II), Ni(II) and Zn(II) acetate in aqueous solution results in extended, rigid- rod like metallosupramolecular coordination polyelectrolytes (MEPE-1). Under the current experimental conditions the molar masses range from 1000 g mol(-1) up to 500 000 g mol(-1). The molar mass depends on concentration, stoichiometry, metal-ion and time. In addition, we present viscosity measurements, small angle neutron scattering and AFM data. We introduce a protocol to precisely control the stoichiometry during self-assembly using conductometry. The protocol can be used with different terpyridine ligands and the above-mentioned metal ions and is of paramount importance to obtain meaningful and reproducible results. As a control experiment we studied the mononuclear 4'- (phenyl)2,2':6',2 ''-terpyridine (3) complex with Ni(II) and Zn(II) and the flexible ligand 1,3- bis[4'-oxa(2,2': 6',2 ''-terpyridinyl)] propane (2) with Ni(II) acetate (Ni-MEPE-2). This ligand does not form extended macroassemblies but likely ring-like structures with 3 to 4 repeat units. Through spin- coating of Ni-MEPE-1 on a solid surface we can image the MEPEs in real space by AFM. SANS measurements of Fe-MEPE-1 verify the extended rigid-rod type structure of the MEPEs in aqueous solution.
Homoleptic Ni-II and Fe-II complexes of the "large-surface" phenanthroline-type ligand 1,12-diazaperylene (dap), [Ni(dap)(3)](BF4)(2) (1) and [Fe(dap)(3)](PF6)(2) (2), respectively, were synthesized. In the crystal structure the complex cation [M(dap)(3)](2+) (M = Ni, Fe) exhibits C-3 symmetry and interacts with three other cations by pi-pi stacking. It forms a new metalla-supramolecular assembly with a honeycomb structure containing nanochannels running parallel to the crystallographic c axis. Aggregation by pi-pi stacking between metal complexes of "large-surface" ligands should give new perspectives for inorganic supramolecular chemistry.
A short and convenient synthesis of metallochlorin-C-60 dyads based on a Heck-type hetero coupling at the 3(2) position of a chlorin is described. p-Bromobenzaldehyde was treated with Zn-metalated 13(2)- demethoxycarbonylmethylpheophorbide a, using a palladium acetate/LiCl catalyst mixture under phase-transfer conditions in DMF at 70 degrees C. The resulting asymmetric olefin was obtained in a high trans/cis ratio. The desired trans isomer was separated and subsequently transformed into a donor-acceptor dyad by a 1,3-dipolar cycloaddition to C-60 in the presence of sarcosine in refluxing toluene. The resulting dyads are expected to undergo efficient photoinduced electron transfer and can potentially be utilized in solar energy conversion devices.
The new tetrathiacrown ethers maleonitrile-tetrathia-12-crown-4 (mn12S(4)) and maleonitrile-tetrathia-13-crown- 4 (mn13S(4)) have been prepared and characterised by X-ray crystallographic analysis. These crown ethers form 2:1, 3:2 and 1: 1 complexes with AgY (Y = BF4, PF6). The crystal structures of [Ag(mn12S(4))(2)]BF4 (3a), [Ag(mn13S(4))(2)]BF4 (4a) and [Ag-2(mn13S(4))(3)](PF6)(2) (6b) have been determined. Compound 3a contains the centrosymmetric sandwich complex cation [Ag(mn12S(4))(2)](+) where each mn12S(4) ligand is coordinated to the Ag centre in an endo manner through all four S atoms. The 2:1 complex [Ag(mn12S(4))(2)](+) is the first sandwich complex with a tetrathiacrown ether and the first complex with an octa(thioether) coordination sphere. The crystal structure of compound 4a also reveals a 2:1 complex. This complex, [Ag(mnl3S(4))(2)](+), exhibits a half-sandwich structure. One mn13S(4) ligand coordinates to Ag+ by all four S donor atoms and the other 13S(4) crown by only one S atom. Compound 6b contains a dinuclear Ag complex. The Ag complexes 3a,b-8a,b were also studied by electrospray ionisation mass spectrometry. Collision-induced dissociation (CID) was used to compare the relative stability of 2:1 complexes [AgL2]+ and 1:1 complexes [AgL](+) (L = mn12S(4), mn13S(4)). The C-13 NMR chemical shifts of 2:1 and 1:1 Ag complexes and their corresponding free ligands were also estimated and compared. The free energy of the barrier of ring inversion (Delta G(double dagger)) for [Ag(mn12S(4))(2)](+) was determined to be 64 kJmol(-1).