Refine
Has Fulltext
- no (38)
Year of publication
Document Type
- Article (38) (remove)
Is part of the Bibliography
- yes (38)
Keywords
- Maltose-modified poly(ethyleneimine) (2)
- Ring tensiometry (2)
- gold nanoparticles (2)
- microemulsion (2)
- mu-DSC (2)
- polyelectrolyte (2)
- Bentonite clay (1)
- Biomineralization (1)
- Bone repair material (1)
- Calcium phosphates (1)
Institute
This paper is focused on the synthesis and characterization of hydrophobically modified polyelectrolytes and their use as reducing as well as stabilizing agents for the formation of gold nanoparticles. Commercially available poly(acrylic acid) has been hydrophobically modified with various degrees of grafting of butylamine introduced randomly along the chain. Different analytical methods are performed, i.e., IR and H-1-NMR spectroscopy in combination with elemental analysis to determine the degree of grafting. The modified polymers can successfully be used for the controlled single-step synthesis and stabilization of gold nanoparticles. The process of nanoparticle formation is investigated by means of UV-vis spectroscopy. The size and shape of the particles obtained in the presence of unmodified or modified polyelectrolytes are characterized by dynamic light scattering, zeta potential measurements and transmission electron microscopy. The polyelectrolytes were involved in the crystallization process of the nanoparticles, and in the presence of hydrophobic microdomains at the particle surface, a better stabilization at higher temperature can be observed
The influence of branched poly(ethyleneimine) on the phase behavior of the system sodium dodecylsulfate/toluene-pentanol (1:1)/water has been studied. The isotropic microemulsions still exist when water is replaced with aqueous solutions of PEI (up to 30% in weight), but their stability is significantly influenced. From a polymer concentration of 20 wt%, the polymer enhances the solubilization of water in oil, changes the sign of the spontaneous curvature of the surfactant film, and induces an inversion of the microemulsion type from water-in-oil (L-2) to oil-in-water (L-1), by the formation of a bicontinuous channel. Further investigations show that the addition of polymer in the L-2 phase changes the droplet-droplet interactions as the conductivity drops and the percolation disappears. In the bicontinuous channel, higher viscosities can be detected, as well as a weak percolation followed by a steep increase of the conductivity, which can be related to evident structural changes in the system. DSC measurements allow then to follow the changes of the water properties in the system, from interfacial-water in the L-2 phase to free-water in the sponge-like phase. Finally, all the measurements performed permit to characterize the structural transitions in the system and to understand the role of the added polymer.
Polymer-modified bicontinuous microemulsions used as a template for the formation of nanorods
(2009)
This article is focused on the characterization of the poly(ethylene glycol) (PEG)-induced bicontinuous microemulsion of the pseudo-ternary system sodium dodecylsulfate (SDS)/xylene-pentanol/water by means of differential scanning calorimetry, rheology, and conductometry. The influence of the polymer concentration (cp) and the molecular weight (Mw) on the microstructure of the microemulsion was investigated using Cryo scanning electron microscopy. It was found that an increase of cp influences the structure of the sponge-like phase significantly. These polymer-modified microemulsions can be used as a template phase for the formation of BaSO4 nanorods, where individual nanoparticles (5nm in size) are ordered along the polymer backbone.
By dropping a NaH2PO4 center dot H2O precursor solution to a CaCl2 solution at 90 degrees C under continuous stirring in presence of two biopolymers, i.e. gelatin (G) and chitosan (C), supramolecular calcium phosphate (CP) card house structures are formed. Light microscopic investigations in combination with scanning electron microscopy show that the GC-based flower-like structure is constructed from very thin CP platelets. Titration experiments indicate that H-bonding between both biopolymers is responsible for the synergistic effect in presence of both polymers. Gelatin chitosan water complexes play an important role with regard to supramolecular ordering. FTIR spectra in combination with powder X-ray diffraction show that after burning off all organic components (heating up >600 degrees C) dicalcium and tricalcium phosphate crystallites are formed. From high resolution transmission electron microscopy (HR-TEM) it is obvious to conclude, that individual crystal platelets are dicalcium phosphates, which build up ball-like supramolecular structures. The results reveal that the GC guided crystal growth leads to nano-porous supramolecular structures, potentially attractive candidates for bone repair. (c) 2015 Elsevier B.V. All rights reserved.
This Letter is focused on the one-pot formation of CdS nanoparticles in aqueous medium in presence of polyethyleneimine (PEI). Quantum dots can be obtained by adding a pre-cooled aqueous Na2S solution to a pre-cooled aqueous CdCl2 solution dropwise in presence of PEI.
Field flow fractionation in combination with TEM experiments show a time dependent agglomeration of individual quantum dots from 1.6 nm up to 3.2 nm in size. The hyperbranched PEI of moderate molar mass (>20000 g/mol) is an excellent polymer to prevent a further increase of the particle size. Therefore, stable fluorescent PEI-capped CdS quantum dots are available.
Pickering emulsions with two types of nanoparticles, i.e., superparamagnetic magnetite nanoparticles dispersed in n-hexane and gold nanoparticles dispersed in water, were formed by rigorous mixing in presence of surface active polymeric surfactants. Monodisperse magnetite nanoparticles with a mean particle size of 4 nm were obtained by a microwave-assisted synthesis in n-hexane in presence of oleic acid, and gold nanoparticles were produced in aqueous solution in presence of the hyperbranched poly(ethyleneimine) (PEI) or sodium citrate as reducing and stabilizing agent. After mixing the prepared nanoparticle dispersions in presence of the Pluronics an intermediate gel-like phase is formed. The Pickering emulsion droplets in the intermediate phase are stabilized by both types of nanoparticles, as to be seen by cryo-SEM micrographs. After separating, solvent evaporation and redispersion in water highly ordered Pluronic-stabilized superparamagnetic magnetite nanoparticle aggregates with embedded gold nanoparticles can be obtained.