530 Physik
Refine
Has Fulltext
- yes (7)
Year of publication
- 2008 (7) (remove)
Document Type
- Doctoral Thesis (5)
- Habilitation Thesis (1)
- Master's Thesis (1)
Is part of the Bibliography
- yes (7)
Keywords
- Atom chip (1)
- Attraktorrekonstruktion (1)
- Benetzungsübergang (1)
- Coherence (1)
- Datenanalyse (1)
- Feedback control (1)
- Fouriertransformation (1)
- Frequenzkonversion (1)
- Global coupling (1)
- Knospung (1)
Institute
Phase Space Reconstruction is a method that allows to reconstruct the phase space of a system using only an one dimensional time series as input. It can be used for calculating Lyapunov-exponents and detecting chaos. It helps to understand complex dynamics and their behavior. And it can reproduce datasets which were not measured. There are many different methods which produce correct reconstructions such as time-delay, Hilbert-transformation, derivation and integration. The most used one is time-delay but all methods have special properties which are useful in different situations. Hence, every reconstruction method has some situations where it is the best choice. Looking at all these different methods the questions are: Why can all these different looking methods be used for the same purpose? Is there any connection between all these functions? The answer is found in the frequency domain : Performing a Fourier transformation all these methods getting a similar shape: Every presented reconstruction method can be described as a multiplication in the frequency domain with a frequency-depending reconstruction function. This structure is also known as a filter. From this point of view every reconstructed dimension can be seen as a filtered version of the measured time series. It contains the original data but applies just a new focus: Some parts are amplified and other parts are reduced. Furthermore I show, that not every function can be used for reconstruction. In the thesis three characteristics are identified, which are mandatory for the reconstruction function. Under consideration of these restrictions one gets a whole bunch of new reconstruction functions. So it is possible to reduce noise within the reconstruction process itself or to use some advantages of already known reconstructions methods while suppressing unwanted characteristics of it.
Computational cosmology
(2008)
“Computational Cosmology” is the modeling of structure formation in the Universe by means of numerical simulations. These simulations can be considered as the only “experiment” to verify theories of the origin and evolution of the Universe. Over the last 30 years great progress has been made in the development of computer codes that model the evolution of dark matter (as well as gas physics) on cosmic scales and new research discipline has established itself. After a brief summary of cosmology we will introduce the concepts behind such simulations. We further present a novel computer code for numerical simulations of cosmic structure formation that utilizes adaptive grids to efficiently distribute the work and focus the computing power to regions of interests, respectively. In that regards we also investigate various (numerical) effects that influence the credibility of these simulations and elaborate on the procedure of how to setup their initial conditions. And as running a simulation is only the first step to modelling cosmological structure formation we additionally developed an object finder that maps the density field onto galaxies and galaxy clusters and hence provides the link to observations. Despite the generally accepted success of the cold dark matter cosmology the model still inhibits a number of deviations from observations. Moreover, none of the putative dark matter particle candidates have yet been detected. Utilizing both the novel simulation code and the halo finder we perform and analyse various simulations of cosmic structure formation investigating alternative cosmologies. These include warm (rather than cold) dark matter, features in the power spectrum of the primordial density perturbations caused by non-standard inflation theories, and even modified Newtonian dynamics. We compare these alternatives to the currently accepted standard model and highlight the limitations on both sides; while those alternatives may cure some of the woes of the standard model they also inhibit difficulties on their own. During the past decade simulation codes and computer hardware have advanced to such a stage where it became possible to resolve in detail the sub-halo populations of dark matter halos in a cosmological context. These results, coupled with the simultaneous increase in observational data have opened up a whole new window on the concordance cosmogony in the field that is now known as “Near-Field Cosmology”. We will present an in-depth study of the dynamics of subhaloes and the development of debris of tidally disrupted satellite galaxies.1 Here we postulate a new population of subhaloes that once passed close to the centre of their host and now reside in the outer regions of it. We further show that interactions between satellites inside the radius of their hosts may not be negliable. And the recovery of host properties from the distribution and properties of tidally induced debris material is not as straightforward as expected from simulations of individual satellites in (semi-)analytical host potentials.
Giant vesicles may contain several spatial compartments formed by phase separation within their enclosed aqueous solution. This phenomenon might be related to molecular crowding, fractionation and protein sorting in cells. To elucidate this process we used two chemically dissimilar polymers, polyethylene glycol (PEG) and dextran, encapsulated in giant vesicles. The dynamics of the phase separation of this polymer solution enclosed in vesicles is studied by concentration quench, i.e. exposing the vesicles to hypertonic solutions. The excess membrane area, produced by dehydration, can either form tubular structures (also known as tethers) or be utilized to perform morphological changes of the vesicle, depending on the interfacial tension between the coexisting phases and those between the membrane and the two phases. Membrane tube formation is coupled to the phase separation process. Apparently, the energy released from the phase separation is utilized to overcome the energy barrier for tube formation. The tubes may be absorbed at the interface to form a 2-demensional structure. The membrane stored in the form of tubes can be retracted under small tension perturbation. Furthermore, a wetting transition, which has been reported only in a few experimental systems, was discovered in this system. By increasing the polymer concentration, the PEG-rich phase changed from complete wetting to partial wetting of the membrane. If sufficient excess membrane area is available in the vesicle where both phases wet the membrane, one of the phases will bud off from the vesicle body, which leads to the separation of the two phases. This wetting-induced budding is governed by the surface energy and modulated by the membrane tension. This was demonstrated by micropipette aspiration experiments on vesicles encapsulating two phases. The budding of one phase can significantly decrease the surface energy by decreasing the contact area between the coexisting phases. The elasticity of the membrane allows it to adjust its tension automatically to balance the pulling force exerted by the interfacial tension of the two liquid phases at the three-phase contact line. The budding of the phase enriched with one polymer may be relevant to the selective protein transportation among lumens by means of vesicle in cells.
Microfabricated solid-state surfaces, also called atom chip', have become a well-established technique to trap and manipulate atoms. This has simplified applications in atom interferometry, quantum information processing, and studies of many-body systems. Magnetic trapping potentials with arbitrary geommetries are generated with atom chip by miniaturized current-carrying conductors integrated on a solid substrate. Atoms can be trapped and cooled to microKelvin and even nanoKelvin temperatures in such microchip trap. However, cold atoms can be significantly perturbed by the chip surface, typically held at room temperature. The magnetic field fluctuations generated by thermal currents in the chip elements may induce spin flips of atoms and result in loss, heating and decoherence. In this thesis, we extend previous work on spin flip rates induced by magnetic noise and consider the more complex geometries that are typically encountered in atom chips: layered structures and metallic wires of finite cross-section. We also discuss a few aspects of atom chips traps built with superconducting structures that have been suggested as a means to suppress magnetic field fluctuations. The thesis describes calculations of spin flip rates based on magnetic Green functions that are computed analytically and numerically. For a chip with a top metallic layer, the magnetic noise depends essentially on the thickness of that layer, as long as the layers below have a much smaller conductivity. Based on this result, scaling laws for loss rates above a thin metallic layer are derived. A good agreement with experiments is obtained in the regime where the atom-surface distance is comparable to the skin depth of metal. Since in the experiments, metallic layers are always etched to separate wires carrying different currents, the impact of the finite lateral wire size on the magnetic noise has been taken into account. The local spectrum of the magnetic field near a metallic microstructure has been investigated numerically with the help of boundary integral equations. The magnetic noise significantly depends on polarizations above flat wires with finite lateral width, in stark contrast to an infinitely wide wire. Correlations between multiple wires are also taken into account. In the last part, superconducting atom chips are considered. Magnetic traps generated by superconducting wires in the Meissner state and the mixed state are studied analytically by a conformal mapping method and also numerically. The properties of the traps created by superconducting wires are investigated and compared to normal conducting wires: they behave qualitatively quite similar and open a route to further trap miniaturization, due to the advantage of low magnetic noise. We discuss critical currents and fields for several geometries.
In biological cells, the long-range intracellular traffic is powered by molecular motors which transport various cargos along microtubule filaments. The microtubules possess an intrinsic direction, having a 'plus' and a 'minus' end. Some molecular motors such as cytoplasmic dynein walk to the minus end, while others such as conventional kinesin walk to the plus end. Cells typically have an isopolar microtubule network. This is most pronounced in neuronal axons or fungal hyphae. In these long and thin tubular protrusions, the microtubules are arranged parallel to the tube axis with the minus ends pointing to the cell body and the plus ends pointing to the tip. In such a tubular compartment, transport by only one motor type leads to 'motor traffic jams'. Kinesin-driven cargos accumulate at the tip, while dynein-driven cargos accumulate near the cell body. We identify the relevant length scales and characterize the jamming behaviour in these tube geometries by using both Monte Carlo simulations and analytical calculations. A possible solution to this jamming problem is to transport cargos with a team of plus and a team of minus motors simultaneously, so that they can travel bidirectionally, as observed in cells. The presumably simplest mechanism for such bidirectional transport is provided by a 'tug-of-war' between the two motor teams which is governed by mechanical motor interactions only. We develop a stochastic tug-of-war model and study it with numerical and analytical calculations. We find a surprisingly complex cooperative motility behaviour. We compare our results to the available experimental data, which we reproduce qualitatively and quantitatively.
In the present dissertation paper an approach which ensures an efficient control of such diverse systems as noisy or chaotic oscillators and neural ensembles is developed. This approach is implemented by a simple linear feedback loop. The dissertation paper consists of two main parts. One part of the work is dedicated to the application of the suggested technique to a population of neurons with a goal to suppress their synchronous collective dynamics. The other part is aimed at investigating linear feedback control of coherence of a noisy or chaotic self-sustained oscillator. First we start with a problem of suppressing synchronization in a large population of interacting neurons. The importance of this task is based on the hypothesis that emergence of pathological brain activity in the case of Parkinson's disease and other neurological disorders is caused by synchrony of many thousands of neurons. The established therapy for the patients with such disorders is a permanent high-frequency electrical stimulation via the depth microelectrodes, called Deep Brain Stimulation (DBS). In spite of efficiency of such stimulation, it has several side effects and mechanisms underlying DBS remain unclear. In the present work an efficient and simple control technique is suggested. It is designed to ensure suppression of synchrony in a neural ensemble by a minimized stimulation that vanishes as soon as the tremor is suppressed. This vanishing-stimulation technique would be a useful tool of experimental neuroscience; on the other hand, control of collective dynamics in a large population of units represents an interesting physical problem. The main idea of suggested approach is related to the classical problem of oscillation theory, namely the interaction between a self-sustained (active) oscillator and a passive load (resonator). It is known that under certain conditions the passive oscillator can suppress the oscillations of an active one. In this thesis a much more complicated case of active medium, which itself consists of thousands of oscillators is considered. Coupling this medium to a specially designed passive oscillator, one can control the collective motion of the ensemble, specifically can enhance or suppress it. Having in mind a possible application in neuroscience, the problem of suppression is concentrated upon. Second, the efficiency of suggested suppression scheme is illustrated by considering more complex case, i.e. when the population of neurons generating the undesired rhythm consists of two non-overlapping subpopulations: the first one is affected by the stimulation, while the collective activity is registered from the second one. Generally speaking, the second population can be by itself both active and passive; both cases are considered here. The possible applications of suggested technique are discussed. Third, the influence of the external linear feedback on coherence of a noisy or chaotic self-sustained oscillator is considered. Coherence is one of the main properties of self-oscillating systems and plays a key role in the construction of clocks, electronic generators, lasers, etc. The coherence of a noisy limit cycle oscillator in the context of phase dynamics is evaluated by the phase diffusion constant, which is in its turn proportional to the width of the spectral peak of oscillations. Many chaotic oscillators can be described within the framework of phase dynamics, and, therefore, their coherence can be also quantified by the way of the phase diffusion constant. The analytical theory for a general linear feedback, considering noisy systems in the linear and Gaussian approximation is developed and validated by numerical results.
Im Rahmen der vorliegenden Arbeit ist es erstmals gelungen, mit einem ps-Pumplaser (10 ps) Weißlicht mit einer spektralen Breite von mehr als einer optischen Oktave in einer mikrostrukturierten Faser (MSF) bei einer Pumpwellenlänge von 1064 nm zu generieren. Es ließ sich, abgesehen von nichtkonvertierten Resten der Pumpstrahlung, ein unstrukturiertes und zeitlich stabiles Weißlichtspektrum von 700 nm bis 1650 nm generieren. Die maximale Ausgangsleistung dieser Weißlichtstrahlung betrug 3,1 W. Es konnten sehr gute Einkoppeleffizienzen von maximal 62 % erzielt werden. Die an der Weißlichterzeugung beteiligten dispersiven und nichtlinear optischen Effekte, wie z.B. Selbstphasenmodulation, Vierwellenmischung, Modulationsinstabilitäten oder Solitoneneffekte, werden detailliert theoretisch untersucht und erläutert. Die Arbeit beinhaltet ebenfalls eine umfangreiche Beschreibung der Wirkungsweise und Eigenschaften von mikrostrukturierten Fasern mit einem festen Faserkern. Aufgrund der großen Variationsvielfalt des mikrostrukturierten Fasermantels und der damit verbundenen Wellenleitereigenschaften ergeben sich, insbesondere für die Anwendung in der nichtlinearen Optik, eine Reihe von interessanten Eigenschaften. Es wurden insgesamt vier verschiedene mikrostrukturierte Fasern experimentell untersucht. Für die Interpretation der experimentellen Ergebnisse ist die Pulsausbreitung der ps-Pumppulse in einer dispersiven, nichtlinear optischen Faser anhand der verallgemeinerten nichtlinearen Schrödinger-Gleichung berechnet worden. Durch einen Vergleich der Berechnungen mit den Messdaten ließen sich verstärkte Modulationsinstabilitäten und verschiedene Solitoneneffekte als hauptsächlich für die Weißlichterzeugung bei ps-Anregungspulsen verantwortlich identifizieren. Auf der Basis der durchgeführten Untersuchungen wurde in Kooperation mit der Fa. Jenoptik Laser, Optik, Systeme GmbH eine kompakte und leistungsstarke Weißlichtquelle entwickelt. Diese wurde erfolgreich in einer Kohärenztomographiemessung (Optical Coherence Tomography - OCT) getestet: Es konnte in ex vivo-Untersuchungen gezeigt werden, dass sich mit dieser ps-Weißlichtquelle eine hohe Eindringtiefe von ca. 400 µm in die Netzhaut eines Affen erreichen lässt.