Refine
Year of publication
Document Type
- Article (20)
- Postprint (4)
- Other (2)
- Part of a Book (1)
Keywords
Institute
Quality attributes of fruit determine its acceptability by the retailer and consumer. The objective of this work was to investigate the potential of absorption (μa) and reduced scattering (μs’) coefficients of European pear to analyze its fruit flesh firmness and soluble solids content (SSC). The absolute reference values, μa* (cm−1) and μs’* (cm−1), of pear were invasively measured, employing multi-spectral photon density wave (PDW) spectroscopy at preselected wavelengths of 515, 690, and 940 nm considering two batches of unripe and overripe fruit. On eight measuring dates during fruit development, μa and μs’ were analyzed non-destructively by means of laser light backscattering imaging (LLBI) at similar wavelengths of 532, 660, and 830 nm by means of fitting according to Farrell’s diffusion theory, using fix reference values of either μa* or μs’*. Both, the μa* and the μa as well as μs’* and μs’ showed similar trends. Considering the non-destructively measured data during fruit development, μa at 660 nm decreased 91 till 141 days after full bloom (dafb) from 1.49 cm−1 to 0.74 cm−1 due to chlorophyll degradation. At 830 nm, μa only slightly decreased from 0.41 cm−1 to 0.35 cm−1. The μs’ at all wavelengths revealed a decreasing trend as the fruit developed. The difference measured at 532 nm was most pronounced decreasing from 24 cm−1 to 10 cm−1, while at 660 nm and 830 nm values decreased from 15 cm−1 to 13 cm−1 and from 10 cm−1 to 8 cm−1, respectively. When building calibration models with partial least-squares regression analysis on the optical properties for non-destructive analysis of the fruit SSC, μa at 532 nm and 830 nm resulted in a correlation coefficient of R = 0.66, however, showing high measuring uncertainty. The combination of all three wavelengths gave an enhanced, encouraging R = 0.89 for firmness analysis using μs’ in the freshly picked fruit.
We present a fluorescence excitation-emission-matrix spectrometer with superior data acquisition rates over previous instruments. Light from a white light emitting diode (LED) source is dispersed onto a digital micromirror array (DMA) and encoded using binary n-size Walsh functions ("barcodes"). The encoded excitation light is used to irradiate the liquid sample and its fluorescence is dispersed and detected using a conventional array spectrometer. After exposure to excitation light encoded in n different ways, the 2-dimensional excitation-emission-matrix (EEM) spectrum is obtained by inverse Hadamard transformation. Using this technique we examined the kinetics of the fluorescence of rhodamine B as a function of temperature and the acid-driven demetalation of chlorophyll into pheophytin-a. For these experiments, EEM spectra with 31 excitation channels and 2048 emission channels were recorded every 15 s. In total, data from over 3000 EEM spectra were included in this report. It is shown that the increase in data acquisition rate can be as high as [{n(n + 1)}/2]-fold over conventional EEM spectrometers. Spectral acquisition rates of more than two spectra per second were demonstrated.
We describe an in-fiber interferometer based on a gas-filled hollow-core photonic crystal fiber. Expressions for the sensitivity, figure of merit and refractive index resolution are derived, and values are experimentally measured and theoretically validated using mode field calculations. The refractive indices of nine monoatomic and molecular gases are measured with a resolution of delta(ns) < 10(-6). (C)2016 Optical Society of America
We report on the fabrication, modeling, and experimental verification of the emission of fiber lenses fabricated on multimode fibers in different media. Concave fiber lenses with a radius of 150 mu m were fabricated onto a multimode silica fiber (100 mu m core) by grinding and polishing against a ruby sphere template. In our theoretical model we assume that the fiber guides light from a Lambertian light source and that the emission cone is governed solely by the range of permitted emission angles. We investigate concave and convex lenses at 532 nm with different radii and in a variety of surrounding media from air (n(0) = 1.00) to sapphire (n(0) = 1.77). It was found that noticeable focusing or defocusing effects of a silica fiber lens in ethanol (n(0) = 1.36) and dimethyl sulfoxide (DMSO) (n(0) = 1.48) are only observed when the fiber lens radius was less than the fiber diameter.
Depletion-induced flocculation of concentrated emulsions probed by photon density wave spectroscopy
(2020)
Stable, creaming-free oil in water emulsions with high volume fractions of oil (phi = 0.05-0.40, density matched to water) and polysorbate 80 as an emulsifier were characterized without dilution by Photon Density Wave spectroscopy measuring light absorption and scattering behavior, the latter serving as the basis for droplet size distribution analysis. The emulsion with phi = 0.10 was used to investigate flocculation processes induced by xanthan as a semi-flexible linear nonabsorbing polymer. Different time regimes in the development of the reduced scattering coefficient mu(s)' could be identified. First, a rapid, temperature-dependent change in mu(s)' during the depletion process was observed. Second, the further decrease of mu(s)' follows a power law in analogy to a spinodal demixing behavior, as described by the Cahn-Hilliard theory.
Monte-Carlo calculations are carried out to simulate the light transport in dense materials. Focus lies on the calculation of diffuse light transmission through films of scattering and absorbing media considering additionally the effect of dependent scattering. Different influences like interaction type between particles, particle size, composition etc. can be studied by this program. Simulations in this study show major influences on the diffuse transmission. Further simulations are carried out to model a sunscreen film and study best compositions of this film and will be presented.
In many technical materials and commercial products like sunscreen or paint high particle and absorber concentrations are present. An important parameter for slabs of these materials is the diffuse transmission of light, which quantifies the total amount of directly and diffusely transmitted light. Due to the high content of scattering particles not only multiple scattering but also additional dependent scattering occurs. Hence, simple analytical models cannot be applied to calculate the diffuse transmission. In this work a Monte-Carlo program for the calculation of the diffuse transmission of light through dispersions in slab-like geometry containing high concentrations of scattering particles and absorbers is presented and discussed in detail. Mie theory is applied for the calculation of the scattering properties of the samples. Additionally, dependent scattering is considered in two different models, the well-known hard sphere model in the Percus-Yevick approximation (HSPYA) and the Yukawa model in the Mean Spherical Approximation (YMSA). Comparative experiments will show the accurateness of the program as well as its applicability to real samples [1]. (C) 2014 Elsevier Ltd. All rights reserved.
Die Inline-Bestimmung von Teilchengroeßen in Emulsionen und Suspensionen stellt besondere Anforderungen an die Messtechnik, da auch bei sehr hohen Teilchenkonzentrationen im Prozess verduennungsfreie Analytik betrieben werden soll. Neben einer Klaerung der Begriffe atline, online und in-line gibt der Beitrag eine Einfuehrung in die mathematische Beschreibung von Groeßenverteilungen. Als Inline-Techniken werden Photonendichtewellen-Spektroskopie, Focused Beam Reflectance Measurement und Ultraschallextinktion-Spektroskopie diskutiert und ihre sehr unterschiedlichen physikalischen Messprinzipien erlaeutert. Auch wird kurz erklaert, wie Teilchengroeßen aus den Messresultaten erhalten werden. Die wesentlichen Charakteristika dieser drei Methoden werden abschließend im ueberblick dargestellt.
In turbid biogenic liquid material, like blood or milk, quantitative optical analysis is often strongly hindered by multiple light scattering resulting from cells, particles, or droplets. Here, optical attenuation is caused by losses due to absorption as well as scattering of light. Fiber-based Photon Density Wave (PDW) spectroscopy is a very promising method for the precise measurement of the optical properties of such materials. They are expressed as absorption and reduced scattering coefficients (mu (a) and mu (s)', respectively) and are linked to the chemical composition and physical properties of the sample. As a process analytical technology, PDW spectroscopy can sense chemical and/or physical processes within such turbid biogenic liquids, providing new scientific insight and process understanding. Here, for the first time, several bioprocesses are analyzed by PDW spectroscopy and the resulting optical coefficients are discussed with respect to established mechanistic models of the chosen processes. As model systems, enzymatic casein coagulation in milk, temperature-induced starch hydrolysis in beer mash, and oxy- as well as deoxygenation of human donor blood were investigated by PDW spectroscopy. The findings indicate that also for very complex biomaterials (i.e., not well-defined model materials like monodisperse polymer dispersions), obtained optical coefficients allow for the assessment of a structure/process relationship and thus for a new analytical access to biogenic liquid material. This is of special relevance as PDW spectroscopy data are obtained without any dilution or calibration, as often found in conventional spectroscopic approaches.