Refine
Year of publication
- 2017 (2399) (remove)
Document Type
- Article (1459)
- Doctoral Thesis (301)
- Postprint (249)
- Other (118)
- Part of a Book (93)
- Monograph/Edited Volume (68)
- Review (54)
- Part of Periodical (17)
- Master's Thesis (12)
- Conference Proceeding (9)
Is part of the Bibliography
- yes (2399) (remove)
Keywords
- Germany (16)
- climate change (14)
- Holocene (11)
- climate (11)
- stars: massive (11)
- Genisa (10)
- Geniza (10)
- German (10)
- Jewish Studies (10)
- Jüdische Studien (10)
Institute
- Institut für Biochemie und Biologie (370)
- Institut für Geowissenschaften (297)
- Institut für Physik und Astronomie (281)
- Institut für Chemie (167)
- Department Psychologie (132)
- Department Sport- und Gesundheitswissenschaften (98)
- Institut für Ernährungswissenschaft (84)
- Department Linguistik (74)
- Mathematisch-Naturwissenschaftliche Fakultät (74)
- Sozialwissenschaften (65)
Ti-6Al-4V bridges were additively fabricated by selective laser melting (SLM) under different scanning speed conditions, to compare the effect of process energy density on the residual stress state. Subsurface lattice strain characterization was conducted by means of synchrotron diffraction in energy dispersive mode. High tensile strain gradients were found at the frontal surface for samples in an as-built condition. The geometry of the samples promotes increasing strains towards the pillar of the bridges. We observed that the higher the laser energy density during fabrication, the lower the lattice strains. A relief of lattice strains takes place after heat treatment.
The evolution of the crystal structure and crystallographic texture of porous synthetic cordierite was studied by in situ high-temperature neutron diffraction up to 1373 K, providing the first in situ high-temperature texture measurement of this technologically important material. It was observed that the crystal texture slightly weakens with increasing temperature, concurrently with subtle changes in the crystal structure. These changes are in agreement with previous work, leading the authors to the conclusion that high-temperature neutron diffraction allows reliable crystallographic characterization of materials with moderate texture. It was also observed that structural changes occur at about the glass transition temperature of the cordierite glass (between 973 and 1073 K). Crystal structure refinements were conducted with and without quantitative texture analysis being part of the Rietveld refinement, and a critical comparison of the results is presented, contributing to the sparse body of literature on combined texture and crystal structure refinements.
Stress-induced damage evolution in cast AlSi12CuMgNi alloy with one- and two-ceramic reinforcements
(2017)
Two composites, consisting of an as-cast AlSi12CuMgNi alloy reinforced with 15 vol% Al2O3 short fibres and with 7 vol% Al2O3 short fibres + 15 vol% SiC particles, were studied. Synchrotron computed tomography disclosed distribution, orientation, and volume fraction of the different phases. In-situ compression tests during neutron diffraction in direction parallel to the fibres plane revealed the load partition between phases. Internal damage (fragmentation) of the Si phase and Al2O3 fibres was directly observed in CT reconstructions. Significant debonding between Al matrix and SiC particles was also found. Finally, based on the Maxwell scheme, a micromechanical model was utilized for the new composite with two-ceramic reinforcements; it rationalizes the experimental data and predicts the evolution of all internal stress components in each phase.
In the present study, samples fabricated by varying the deposition hatch length during selective laser melting of nickel based superalloy Inconel 718 were investigated. Microstructure and texture of these samples was characterized using scanning electron microscopy, combined with electron back-scattered diffraction, and residual stress assessment, using neutron diffraction method. Textured columnar grains oriented along the sample building direction were observed in the shorter hatch length processed sample. A ten-fold increase in the hatch length reduced the texture intensity by a factor of two attributed to the formation of finer grains in the longer hatch length sample. Larger gradients of transverse residual stress in the longer hatch length sample were also observed. Along the build direction, compressive stresses in the shorter hatch length and negligible stresses for the longer hatch length specimen were observed. Changes to the temperature gradient (G) in response to the hatch length variation, influenced the G to growth rate (R) ratio and the product GxR, in agreement with the microstructures and textures formed. For the residual stress development, geometry of the part also played an important role. In summary, tailored isotropy could be induced in Inconel 718 by a careful selection of parameters during selective laser melting.
In order to investigate their microcracking behaviour, the microstructures of several beta-eucryptite ceramics, obtained from glass precursor and cerammed to yield different grain sizes and microcrack densities, were characterized by laboratory and synchrotron x-ray refraction and tomography. Results were compared with those obtained from scanning electron microscopy (SEM). In SEM images, the characterized materials appeared fully dense but computed tomography showed the presence of pore clusters. Uniaxial tensile testing was performed on specimens while strain maps were recorded and analyzed by Digital Image Correlation (DIC). X-ray refraction techniques were applied on specimens before and after tensile testing to measure the amount of the internal specific surface (i.e., area per unit volume). X-ray refraction revealed that (a) the small grain size (SGS) material contained a large specific surface, originating from the grain boundaries and the interfaces of TiO2 precipitates; (b) the medium (MGS) and large grain size (LGS) materials possessed higher amounts of specific surface compared to SGS material due to microcracks, which decreased after tensile loading; (c) the precursor glass had negligible internal surface. The unexpected decrease in the internal surface of MGS and LGS after tensile testing is explained by the presence of compressive regions in the DIC strain maps and further by theoretical arguments. It is suggested that while some microcracks merge via propagation, more close mechanically, thereby explaining the observed X-ray refraction results. The mechanisms proposed would allow the development of a strain hardening route in ceramics.
A constitutive model for the nonlinear or "pseudoplastic" mechanical behavior in a linear-elastic solid with thermally induced microcracks is developed and applied to experimental results. The model is termed strain dependent microcrack density approximation (SDMDA) and is an extension of the modified differential scheme that describes the slope of the stress-strain curves of microcracked solids. SDMDA allows a continuous variation in the microcrack density with tensile loading. Experimental uniaxial tensile response of beta-eucryptite glass and ceramics with controlled levels of microcracking is reported. It is demonstrated that SDMDA can well describe the extent of non-linearity in the experimental uniaxial tensile response of beta-eucryptite with varying levels of microcracking. The advantages of the SDMDA are discussed in regard to tensile loading.
A maximum entropy (MaxEnt) method is developed to predict flow rates or pressure gradients in hydraulic pipe networks without sufficient information to give a closed-form (deterministic) solution. This methodology substantially extends existing deterministic flow network analysis methods. It builds on the MaxEnt framework previously developed by the authors. This study uses a continuous relative entropy defined on a reduced parameter set, here based on the external flow rates. This formulation ensures consistency between different representations of the same network. The relative entropy is maximized subject to observable constraints on the mean values of a subset of flow rates or potential differences, the frictional properties of each pipe, and physical constraints arising from Kirchhoff’s first and second laws. The new method is demonstrated by application to a simple one-loop network and a 1,123-node, 1,140-pipe water distribution network in the suburb of Torrens, Australian Capital Territory, Australia.
Building upon the existing literature on emotional memory, the present review examines emerging evidence from brain imaging investigations regarding four research directions: (1) Social Emotional Memory, (2) The Role of Emotion Regulation in the Impact of Emotion on Memory, (3) The Impact of Emotion on Associative or Relational Memory, and (4) The Role of Individual Differences in Emotional Memory. Across these four domains, available evidence demonstrates that emotion-and memory-related medial temporal lobe brain regions (amygdala and hippocampus, respectively), together with prefrontal cortical regions, play a pivotal role during both encoding and retrieval of emotional episodic memories. This evidence sheds light on the neural mechanisms of emotional memories in healthy functioning, and has important implications for understanding clinical conditions that are associated with negative affective biases in encoding and retrieving emotional memories.
Diagnosis and treatment of breast cancer is a very emotionally aversive and stressful life event, which can lead to impaired cognitive functioning and mental health. Breast cancer survivors responding with repressive emotion regulation strategies often show less adaptive coping and adverse outcomes. We investigated cognitive functioning and neural correlates of emotion processing using ERPs. Self-report measures of depression, anxiety, and fatigue, as well as hair cortisol as an index of chronic stress, were assessed. Twenty breast cancer survivors (BCS) and 31 carefully matched healthy controls participated in the study. After neuropsychological testing and subjective assessments, participants viewed 30 neutral, 30 unpleasant, and 30 pleasant pictures, and ERPs were recorded. Recognition memory was tested 1 week later. BCS reported stronger complaints about cognitive impairments and more symptoms of depression, anxiety, and fatigue. Moreover, they showed elevated hair cortisol levels. Except for verbal memory, cognitive functioning was predominantly in the normative range. Recognition memory performance was decreased in cancer survivors, especially for emotional contents. In ERPs, survivors showed smaller late positive potential amplitudes for unpleasant pictures relative to controls in a later time window, which may indicate less elaborative processing of this material. Taken together, we found cognitive impairments in BCS in verbal memory, impaired emotional picture memory accuracy, and reduced neural activity when breast cancer survivors were confronted with unpleasant materials. Further studies and larger sample sizes, however, are needed to evaluate the relationship between altered emotion processing and reduced memory in BCS in order to develop new treatment strategies.
Fixational eye movements show scaling behaviour of the positional mean-squared displacement with a characteristic transition from persistence to antipersistence for increasing time-lag. These statistical patterns were found to be mainly shaped by microsaccades (fast, small-amplitude movements). However, our re-analysis of fixational eye-movement data provides evidence that the slow component (physiological drift) of the eyes exhibits scaling behaviour of the mean-squared displacement that varies across human participants. These results suggest that drift is a correlated movement that interacts with microsaccades. Moreover, on the long time scale, the mean-squared displacement of the drift shows oscillations, which is also present in the displacement auto-correlation function. This finding lends support to the presence of time-delayed feedback in the control of drift movements. Based on an earlier non-linear delayed feedback model of fixational eye movements, we propose and discuss different versions of a new model that combines a self-avoiding walk with time delay. As a result, we identify a model that reproduces oscillatory correlation functions, the transition from persistence to antipersistence, and microsaccades.