Refine
Year of publication
Document Type
- Doctoral Thesis (18)
- Article (10)
- Postprint (6)
- Bachelor Thesis (1)
- Monograph/Edited Volume (1)
Is part of the Bibliography
- yes (36) (remove)
Keywords
- remote sensing (36) (remove)
Within a research project about future sustainable water management options in the Elbe River basin, quasi-natural discharge scenarios had to be provided. The semi-distributed eco-hydrological model SWIM was utilised for this task. According to scenario simulations driven by the stochastical climate model STAR, the region would get distinctly drier. However, this thesis focuses on the challenge of meeting the requirement of high model fidelity even for smaller sub-basins. Usually, the quality of the simulations is lower at inner points than at the outlet. Four research paper chapters and the discussion chapter deal with the reasons for local model deviations and the problem of optimal spatial calibration. Besides other assessments, the Markov Chain Monte Carlo method is applied to show whether evapotranspiration or precipitation should be corrected to minimise runoff deviations, principal component analysis is used in an unusual way to evaluate local precipitation alterations by land cover changes, and remotely sensed surface temperatures allow for an independent view on the evapotranspiration landscape. The overall insight is that spatially explicit hydrological modelling of such a large river basin requires a lot of local knowledge. It probably needs more time to obtain such knowledge as is usually provided for hydrological modelling studies.
Water fluxes in highly impounded regions are heavily dependent on reservoir properties. However, for large and remote areas, this information is often unavailable. In this study, the geometry and volume of small surface reservoirs in the semi-arid region of Brazil were estimated using terrain and shape attributes extracted by remote sensing. Regression models and data classification were used to predict the volumes, at different water stages, of 312 reservoirs for which topographic information is available. The power function used to describe the reservoir shapes tends to overestimate the volumes; therefore, a modified shape equation was proposed. Among the methods tested, four were recommended based on performance and simplicity, for which the mean absolute percentage errors varied from 24 to 39%, in contrast to the 94% error achieved with the traditional method. Despite the challenge of precisely deriving the flooded areas of reservoirs, water management in highly reservoir-dense environments should benefit from volume prediction based on remote sensing.
Forest structure is a crucial component in the assessment of whether a forest is likely to act as a carbon sink under changing climate. Detailed 3D structural information about the tundra–taiga ecotone of Siberia is mostly missing and still underrepresented in current research due to the remoteness and restricted accessibility. Field based, high-resolution remote sensing can provide important knowledge for the understanding of vegetation properties and dynamics. In this study, we test the applicability of consumer-grade Unmanned Aerial Vehicles (UAVs) for rapid calculation of stand metrics in treeline forests. We reconstructed high-resolution photogrammetric point clouds and derived canopy height models for 10 study sites from NE Chukotka and SW Yakutia. Subsequently, we detected individual tree tops using a variable-window size local maximum filter and applied a marker-controlled watershed segmentation for the delineation of tree crowns. With this, we successfully detected 67.1% of the validation individuals. Simple linear regressions of observed and detected metrics show a better correlation (R2) and lower relative root mean square percentage error (RMSE%) for tree heights (mean R2 = 0.77, mean RMSE% = 18.46%) than for crown diameters (mean R2 = 0.46, mean RMSE% = 24.9%). The comparison between detected and observed tree height distributions revealed that our tree detection method was unable to representatively identify trees <2 m. Our results show that plot sizes for vegetation surveys in the tundra–taiga ecotone should be adapted to the forest structure and have a radius of >15–20 m to capture homogeneous and representative forest stands. Additionally, we identify sources of omission and commission errors and give recommendations for their mitigation. In summary, the efficiency of the used method depends on the complexity of the forest’s stand structure.
Forest structure is a crucial component in the assessment of whether a forest is likely to act as a carbon sink under changing climate. Detailed 3D structural information about the tundra–taiga ecotone of Siberia is mostly missing and still underrepresented in current research due to the remoteness and restricted accessibility. Field based, high-resolution remote sensing can provide important knowledge for the understanding of vegetation properties and dynamics. In this study, we test the applicability of consumer-grade Unmanned Aerial Vehicles (UAVs) for rapid calculation of stand metrics in treeline forests. We reconstructed high-resolution photogrammetric point clouds and derived canopy height models for 10 study sites from NE Chukotka and SW Yakutia. Subsequently, we detected individual tree tops using a variable-window size local maximum filter and applied a marker-controlled watershed segmentation for the delineation of tree crowns. With this, we successfully detected 67.1% of the validation individuals. Simple linear regressions of observed and detected metrics show a better correlation (R2) and lower relative root mean square percentage error (RMSE%) for tree heights (mean R2 = 0.77, mean RMSE% = 18.46%) than for crown diameters (mean R2 = 0.46, mean RMSE% = 24.9%). The comparison between detected and observed tree height distributions revealed that our tree detection method was unable to representatively identify trees <2 m. Our results show that plot sizes for vegetation surveys in the tundra–taiga ecotone should be adapted to the forest structure and have a radius of >15–20 m to capture homogeneous and representative forest stands. Additionally, we identify sources of omission and commission errors and give recommendations for their mitigation. In summary, the efficiency of the used method depends on the complexity of the forest’s stand structure.
In den letzten Jahren wurden relativ komplexe Erosionsmodelle entwickelt, deren Teilprozesse immer mehr auf physikalisch begründeten Ansätzen beruhen. Damit verbunden ist eine höhere Anzahl aktueller Eingangsparameter, deren Bestimmung im Feld arbeits- und kostenaufwendig ist. Zudem werden die Parameter punktuell, also an bestimmten Stellen und nicht flächenhaft wie bei der Fernerkundung, erfasst. Im Rahmen dieser Arbeit wird gezeigt, wie Satellitendaten als relativ kostengünstige Ergänzung oder Alternative zur konventionellen Parametererhebung genutzt werden können. Dazu werden beispielhaft der Blattflächenindex (LAI) und der Bedeckungsgrad für das physikalisch begründete Erosionsmodell EROSION 3D abgeleitet. Im Mittelpunkt des Interesses steht dabei das Aufzeigen von existierenden Methoden, die die Basis für eine operationelle Bereitstellung solcher Größen nicht nur für Erosions- sondern allgemein für Prozessmodelle darstellen. Als Untersuchungsgebiet dient das primär landwirtschaftlich genutzte Einzugsgebiet des Mehltheuer Baches, das sich im Sächsischen Lößgefilde befindet und für das Simulationsrechnungen mit konventionell erhobenen Eingangsparametern für 29 Niederschlagsereignisse im Jahr 1999 vorliegen [MICHAEL et al. 2000]. Die Fernerkundungsdatengrundlage bilden Landsat-5-TM-Daten vom 13.03.1999, 30.04.1999 und 19.07.1999. Da die Vegetationsparameter für alle Niederschlagsereignisse vorliegen sollen, werden sie basierend auf der Entwicklung des LAI zeitlich interpoliert. Dazu erfolgt zunächst die Ableitung des LAI für alle vorhandenen Fruchtarten nach den semi-empirischen Modellen von CLEVERS [1986] und BARET & GUYOT [1991] mit aus der Literatur entnommenen Koeffizienten. Des Weiteren wird eine Methode untersucht, nach der die Koeffizienten für das Clevers-Modell aus den TM-Daten und einem vereinfachten Wachstumsmodell bestimmt werden. Der Bedeckungsgrad wird nach ROSS [1981] aus dem LAI ermittelt. Die zeitliche Interpolation des LAI wird durch die schlagbezogene Anpassung eines vereinfachten Wachstumsmodells umgesetzt, das dem hydrologischen Modell SWIM [KRYSANOVA et al. 1999] entstammt und in das durchschnittliche Tagestemperaturen eingehen. Mit den genannten Methoden bleiben abgestorbene Pflanzenteile unberücksichtigt. Im Vergleich zur konventionellen terrestrischen Parametererhebung ermöglichen sie eine differenziertere Abbildung räumlicher Variabilitäten und des zeitlichen Verlaufes der Vegetationsparameter. Die Simulationsrechnungen werden sowohl mit den direkten Bedeckungsgraden aus den TM-Daten (pixelbezogen) als auch mit den zeitlich interpolierten Bedeckungsgraden für alle Ereignisse (schlagbezogen) durchgeführt. Bei beiden Vorgehensweisen wird im Vergleich zur bisherigen Abschätzung eine Verbesserung der räumlichen Verteilung der Parameter und somit eine räumliche Umverteilung von Erosions- und Depositionsflächen erreicht. Für die im Untersuchungsgebiet vorliegende räumliche Heterogenität (z. B. Schlaggröße) bieten Landsat-TM-Daten eine ausreichend genaue räumliche Auflösung. Damit wird nachgewiesen, dass die satellitengestützte Fernerkundung im Rahmen dieser Untersuchungen sinnvoll einsetzbar ist. Für eine operationelle Bereitstellung der Parameter mit einem vertretbaren Aufwand ist es erforderlich, die Methoden weiter zu validieren und möglichst weitestgehend zu automatisieren.
Groundwater recharge (GWR) is one of the most challenging water fluxes to estimate, as it relies on observed data that are often limited in many developing countries.
This study developed an innovative water budget method using satellite products for estimating the spatially distributed GWR at monthly and annual scales in tropical wet sedimentary regions despite cloudy conditions.
The distinctive features proposed in this study include the capacity to address 1) evapotranspiration estimations in tropical wet regions frequently overlaid by substantial cloud cover; and 2) seasonal root-zone water storage estimations in sedimentary regions prone to monthly variations.
The method also utilises satellite-based information of the precipitation and surface runoff. The GWR was estimated and validated for the hydrologically contrasting years 2016 and 2017 over a tropical wet sedimentary region located in North-eastern Brazil, which has substantial potential for groundwater abstraction.
This study showed that applying a cloud-cleaning procedure based on monthly compositions of biophysical data enables the production of a reasonable proxy for evapotranspiration able to estimate groundwater by the water budget method.
The resulting GWR rates were 219 (2016) and 302 (2017) mm yr(-1), showing good correlations (CC = 0.68 to 0.83) and slight underestimations (PBIAS =-13 to-9%) when compared with the referenced estimates obtained by the water table fluctuation method for 23 monitoring wells. Sensitivity analysis shows that water storage changes account for +19% to-22% of our monthly evaluation.
The satellite-based approach consistently demonstrated that the consideration of cloud-cleaned evapotranspiration and root-zone soil water storage changes are essential for a proper estimation of spatially distributed GWR in tropical wet sedimentary regions because of their weather seasonality and cloudy conditions.