Refine
Has Fulltext
- no (40)
Year of publication
Language
- English (40)
Is part of the Bibliography
- yes (40)
Keywords
Institute
- Institut für Geowissenschaften (40) (remove)
To address one of the central questions of plate tectonics-How do large transform systems work and what are their typical features?-seismic investigations across the Dead Sea Transform (DST), the boundary between the African and Arabian plates in the Middle East, were conducted for the first time. A major component of these investigations was a combined reflection/ refraction survey across the territories of Palestine, Israel and Jordan. The main results of this study are: (1) The seismic basement is offset by 3-5 km under the DST, (2) The DST cuts through the entire crust, broadening in the lower crust, (3) Strong lower crustal reflectors are imaged only on one side of the DST, (4) The seismic velocity sections show a steady increase in the depth of the crust-mantle transition (Moho) from 26 km at the Mediterranean to 39 km under the Jordan highlands, with only a small but visible, asymmetric topography of the Moho under the DST. These observations can be linked to the left-lateral movement of 105 km of the two plates in the last 17 Myr, accompanied by strong deformation within a narrow zone cutting through the entire crust. Comparing the DST and the San Andreas Fault (SAF) system, a strong asymmetry in subhorizontal lower crustal reflectors and a deep reaching deformation zone both occur around the DST and the SAF. The fact that such lower crustal reflectors and deep deformation zones are observed in such different transform systems suggests that these structures are possibly fundamental features of large transform plate boundaries
A seismological network was operated at the junction of the aseismic Walvis Ridge with the northwestern Namibian coast. We mapped crustal thickness and bulk V-p/V-s ratio by the H-k analysis of receiver functions. In the Damara Belt, the crustal thickness is similar to 35km with a V-p/V-s ratio of <1.75. The crust is similar to 30km thick at the coast in the Kaoko Belt. Strong variations in crustal thickness and V-p/V-s ratios are found at the landfall of the Walvis Ridge. Here and at similar to 150km northeast of the coast, the crustal thickness increases dramatically reaching 44km and the V-p/V-s ratios are extremely high (similar to 1.89). These anomalies are interpreted as magmatic underplating produced by the mantle plume during the breakup of Gondwana. The area affected by the plume is smaller than 300km in diameter, possibly ruling out the existence of a large plume head under the continent during the breakup.
Upwelling hot mantle plumes are thought to disintegrate continental lithosphere and are considered to be drivers of active continental breakup. The formation of the Walvis Ridge during the opening of the South Atlantic is related to a putative plume-induced breakup. We investigated the crustal structure of the Walvis Ridge (southeast Atlantic Ocean) at its intersection with the continental margin and searched for anomalies related to the possible plume head. The overall structure we identify suggests that no broad plume head existed during opening of the South Atlantic and anomalous mantle melting occurred only locally. We therefore question the importance of a plume head as a driver of continental breakup and further speculate that the hotspot was present before the rifting, leaving a track of kimberlites in the African craton.
The causes for the formation of large igneous provinces and hotspot trails are still a matter of considerable dispute. Seismic tomography and other studies suggest that hot mantle material rising from the core-mantle boundary (CMB) might play a significant role in the formation of such hotspot trails. An important area to verify this concept is the South Atlantic region, with hotspot trails that spatially coincide with one of the largest low-velocity regions at the CMB, the African large low shear-wave velocity province. The Walvis Ridge started to form during the separation of the South American and African continents at ca. 130 Ma as a consequence of Gondwana breakup. Here, we present the first deep-seismic sounding images of the crustal structure from the landfall area of the Walvis Ridge at the Namibian coast to constrain processes of plume-lithosphere interaction and the formation of continental flood basalts (Parana and Etendeka continental flood basalts) and associated intrusive rocks. Our study identified a narrow region (<100 km) of high-seismic-velocity anomalies in the middle and lower crust, which we interpret as a massive mafic intrusion into the northern Namibian continental crust. Seismic crustal reflection imaging shows a flat Moho as well as reflectors connecting the high-velocity body with shallow crustal structures that we speculate to mark potential feeder channels of the Etendeka continental flood basalt. We suggest that the observed massive but localized mafic intrusion into the lower crust results from similar-sized variations in the lithosphere (i.e., lithosphere thickness or preexisting structures).
Fault zones are the locations where motion of tectonic plates, often associated with earthquakes, is accommodated. Despite a rapid increase in the understanding of faults in the last decades, our knowledge of their geometry, petrophysical properties, and controlling processes remains incomplete. The central questions addressed here in our study of the Dead Sea Transform (DST) in the Middle East are as follows: (1) What are the structure and kinematics of a large fault zone? (2) What controls its structure and kinematics? (3) How does the DST compare to other plate boundary fault zones? The DST has accommodated a total of 105 km of left-lateral transform motion between the African and Arabian plates since early Miocene (similar to 20 Ma). The DST segment between the Dead Sea and the Red Sea, called the Arava/Araba Fault (AF), is studied here using a multidisciplinary and multiscale approach from the mu m to the plate tectonic scale. We observe that under the DST a narrow, subvertical zone cuts through crust and lithosphere. First, from west to east the crustal thickness increases smoothly from 26 to 39 km, and a subhorizontal lower crustal reflector is detected east of the AF. Second, several faults exist in the upper crust in a 40 km wide zone centered on the AF, but none have kilometer-size zones of decreased seismic velocities or zones of high electrical conductivities in the upper crust expected for large damage zones. Third, the AF is the main branch of the DST system, even though it has accommodated only a part (up to 60 km) of the overall 105 km of sinistral plate motion. Fourth, the AF acts as a barrier to fluids to a depth of 4 km, and the lithology changes abruptly across it. Fifth, in the top few hundred meters of the AF a locally transpressional regime is observed in a 100-300 m wide zone of deformed and displaced material, bordered by subparallel faults forming a positive flower structure. Other segments of the AF have a transtensional character with small pull-aparts along them. The damage zones of the individual faults are only 5-20 m wide at this depth range. Sixth, two areas on the AF show mesoscale to microscale faulting and veining in limestone sequences with faulting depths between 2 and 5 km. Seventh, fluids in the AF are carried downward into the fault zone. Only a minor fraction of fluids is derived from ascending hydrothermal fluids. However, we found that on the kilometer scale the AF does not act as an important fluid conduit. Most of these findings are corroborated using thermomechanical modeling where shear deformation in the upper crust is localized in one or two major faults; at larger depth, shear deformation occurs in a 20-40 km wide zone with a mechanically weak decoupling zone extending subvertically through the entire lithosphere.
We employ P to S converted waveforms to investigate effects of the hot mantle plume on seismic discontinuities of the crust and upper mantle. We observe the Moho at depths between 13 and 17 km, regionally covered by a strong shallow intracrustal converted phase. Coherent phases on the transverse component indicate either dipping interfaces, 3- D heterogeneities or lower crustal anisotropy. We find anomalies related to discontinuities in the upper mantle down to the transition zone evidently related to the hot mantle plume. Lithospheric thinning is confirmed in greater detail than previously reported by Li et al., and we determine the dimensions of the low-velocity zone within the asthenosphere with greater accuracy. Our study mainly focuses on the temperature-pressure dependent discontinuities of the upper mantle transition zone. Effects of the hot diapir on the depths of mineral phase transitions are verified at both major interfaces at 410 and 660 km. We determine a plume radius of about 200 km at the 660 km discontinuity with a core zone of about 120 km radius. The plume conduit is located southwest of Big Island. A conduit tilted in the northeast direction is required in the upper mantle to explain the observations. The determined positions of deflections of the discontinuities support the hypothesis of decoupled upper and lower mantle convection
Receiver functions (RF) are used to investigate the upper mantle structure beneath the Eifel, the youngest volcanic area of Central Europe. Data from 96 teleseismic events recorded by 242 seismological stations from permanent and a temporary network has been analysed. The temporary network operated from 1997 November to 1998 June and covered an area of approximately 400 x 250 km(2) centred on the Eifel volcanic fields. The average Moho depth in the Eifel is approximately 30 km, thinning to ca. 28 km under the Eifel volcanic fields. RF images suggest the existence of a low velocity zone at about 60-90 km depth under the West Eifel. This observation is supported by P- and S-wave tomographic results and absorption (but the array aperture limits the resolution of the tomographic methods to the upper 400 km). There are also indications for a zone of elevated velocities at around 200 km depth, again in agreement with S-wave and absorption tomographic results. This anomaly is not visible in P-wave tomography and could be due to S-wave anisotropy. The RF anomalies at the Moho, at 60-90 km, and near 200 km depth have a lateral extent of about 100 km. The 410 km discontinuity under the Eifel is depressed by 15-25 km, which could be explained by a maximum temperature increase of +200 degrees C to +300 degrees C. In the 3-D RF image of the Eifel Plume we also notice two additional currently unexplained conversions between 410 and 550 km depth. They could represent remnants of previous subduction or anomalies due to delayed phase changes. The lateral extent of these conversions and the depression of the 410 km discontinuity is about 200 km. The 660 km discontinuity does not show any depth deviation from its expected value. Our observations are consistent with interpretation in terms of an upper mantle plume but they do not rule out connections to processes at larger depth
An analysis of the shear (S) waves recorded during the wide-angle reflection/refraction (WRR) experiment as part of the DESERT project crossing the Dead Sea Transform (DST) reveals average crustal S-wave velocities of 3.3-3.5 km s(-1) beneath the WRR profile. Together with average crustal P-wave velocities of 5.8-6.1 km s(-1) from an already published study this provides average crustal Poisson's ratios of 0.26-0.27 (V-p/V-s = 1.76-1.78) below the profile. The top two layers consisting predominantly of sedimentary rocks have S- wave velocities of 1.8-2.7kms(-1) and Poisson's ratios of 0.25-0.31 (V-p/V-s = 1.73-1.91). Beneath these two layers the seismic basement has average S- wave velocities of around 3.6 km s(-1) east of the DST and about 3.7 km s(-1) west of the DST and Poisson's ratios of 0.24-0.25 (V-p/V-s = 1.71-1.73). The lower crust has an average S-wave velocity of about 3.75 km s(-1) and an average Poisson's ratio of around 0.27 (V-p/V-s = 1.78). No Sn phase refracted through the uppermost mantle was observed. The results provide for the first time information from controlled source data on the crustal S-wave velocity structure for the region west of the DST in Israel and Palestine and agree with earlier results for the region east of the DST in the Jordanian highlands. A shear wave splitting study using SKS waves has found evidence for crustal anisotropy beneath the WRR profile while a receiver function study has found evidence for a lower crustal, high S-wave velocity layer east of the DST below the profile. Although no evidence was found in the S-wave data for either feature, the S-wave data are not incompatible with crustal anisotropy being present as the WRR profile only lies 30 degrees off the proposed symmetry axis of the anisotropy where the difference in the two S-wave velocities is still very small. In the case of the lower crustal, high S-wave velocity layer, if the velocity change at the top of this layer comprises a small first-order discontinuity underlain by a 2 km thick transition zone, instead of just a large first-order discontinuity, then both the receiver function data and the WRR data presented here can be satisfied. Finally, the S-wave velocities and Poisson's ratios which have been derived in this study are typical of continental crust and do not require extensional processes to explain them
We report on a receiver function study of the crust and upper mantle within DESERT, a multidisciplinary geophysical project to study the lithosphere across the Dead Sea Transform (DST). A temporary seismic network was operated on both sides of the DST between 2000 April and 2001 June. The depth of the Moho increases smoothly from about 30 to 34-38 km towards the east across the DST, with significant north-south variations east of the DST. These Moho depth estimates from receiver functions are consistent with results from steep-and wide-angle controlled-source techniques. Steep-angle reflections and receiver functions reveal an additional discontinuity in the lower crust, but only east of the DST. This leads to the conclusion that the internal crustal structure east and west of the DST is different. The P to S converted phases from both discontinuities at 410 and 660 km are delayed by 2 s with respect to the IASP91 global reference model. This would indicate that the transition zone is consistent with the global average, but the upper mantle above 410 km is 3-4 per cent slower than the standard earth model
Seismic tomography, imaging of seismic scatterers, and magnetotelluric soundings reveal a sharp lithologic contrast along a similar to 10 km long segment of the Arava Fault (AF), a prominent fault of the southern Dead Sea Transform (DST) in the Middle East. Low seismic velocities and resistivities occur on its western side and higher values east of it, and the boundary between the two units coincides partly with a seismic scattering image. At 1 - 4 km depth the boundary is offset to the east of the AF surface trace, suggesting that at least two fault strands exist, and that slip occurred on multiple strands throughout the margin's history. A westward fault jump, possibly associated with straightening of a fault bend, explains both our observations and the narrow fault zone observed by others