TY - JOUR A1 - Blakesley, James C. A1 - Schubert, Marcel A1 - Steyrleuthner, Robert A1 - Chen, Zhihua A1 - Facchetti, Antonio A1 - Neher, Dieter T1 - Time-of-flight measurements and vertical transport in a high electron-mobility polymer JF - Applied physics letters N2 - We investigate charge transport in a high-electron mobility polymer, poly(N, N-bis 2-octyldodecyl-naphthalene-1,4,5,8-bis dicarboximide-2,6-diyl-alt-5,5-2,2-bithiophene) [P(NDI2OD-T2), Polyera ActivInk (TM) N2200]. Time-of-flight measurements reveal electron mobilities approaching those measured in field-effect transistors, the highest ever recorded in a conjugated polymer using this technique. The modest temperature dependence and weak dispersion of the transients indicate low energetic disorder in this material. Steady-state electron-only current measurements reveal a barrier to injection of about 300 meV. We propose that this barrier is located within the P(NDI2OD-T2) film and arises from molecular orientation effects. Y1 - 2011 U6 - https://doi.org/10.1063/1.3657827 SN - 0003-6951 VL - 99 IS - 18 PB - American Institute of Physics CY - Melville ER - TY - JOUR A1 - Turner, Sarah T. A1 - Pingel, Patrick A1 - Steyrleuthner, Robert A1 - Crossland, Edward J. W. A1 - Ludwigs, Sabine A1 - Neher, Dieter T1 - Quantitative analysis of bulk heterojunction films using linear absorption spectroscopy and solar cell performance JF - Advanced functional materials N2 - A fundamental understanding of the relationship between the bulk morphology and device performance is required for the further development of bulk heterojunction organic solar cells. Here, non-optimized (chloroform cast) and nearly optimized (solvent-annealed o-dichlorobenzene cast) P3HT:PCBM blend films treated over a range of annealing temperatures are studied via optical and photovoltaic device measurements. Parameters related to the P3HT aggregate morphology in the blend are obtained through a recently established analytical model developed by F. C. Spano for the absorption of weakly interacting H-aggregates. Thermally induced changes are related to the glass transition range of the blend. In the chloroform prepared devices, the improvement in device efficiency upon annealing within the glass transition range can be attributed to the growth of P3HT aggregates, an overall increase in the percentage of chain crystallinity, and a concurrent increase in the hole mobilities. Films treated above the glass transition range show an increase in efficiency and fill factor not only associated with the change in chain crystallinity, but also with a decrease in the energetic disorder. On the other hand, the properties of the P3HT phase in the solvent-annealed o-dichlorobenzene cast blends are almost indistinguishable from those of the corresponding pristine P3HT layer and are only weakly affected by thermal annealing. Apparently, slow drying of the blend allows the P3HT chains to crystallize into large domains with low degrees of intra- and interchain disorder. This morphology appears to be most favorable for the efficient generation and extraction of charges. KW - Organic electronics KW - morphology KW - solar cells KW - mobility KW - absorption spectroscopy Y1 - 2011 U6 - https://doi.org/10.1002/adfm.201101583 SN - 1616-301X VL - 21 IS - 24 SP - 4640 EP - 4652 PB - Wiley-VCH CY - Weinheim ER - TY - JOUR A1 - Rivnay, Jonathan A1 - Steyrleuthner, Robert A1 - Jimison, Leslie H. A1 - Casadei, Alberto A1 - Chen, Zhihua A1 - Toney, Michael F. A1 - Facchetti, Antonio A1 - Neher, Dieter A1 - Salleo, Alberto T1 - Drastic control of texture in a high performance n-Type polymeric semiconductor and implications for charge transport JF - Macromolecules : a publication of the American Chemical Society N2 - Control of crystallographic texture from mostly face-on to edge-on is observed for the film morphology of the n-type semicrystalline polymer [N,N-9-bis(2-octyldodecyl)naphthalene-1,4,5,8-bis(dicarboximide)-2,6-diy1]alt-5,59-(2,29-bithiophene)}, P(NDI2OD-T2), when annealing the film to the polymer melting point followed by slow cooling to ambient temperature. A variety of X-ray diffraction analyses, including pole figure construction and Fourier transform peak shape deconvolution, are employed to quantify the texture change, relative degree of crystallinity and lattice order. We find that annealing the polymer film to the melt leads to a shift from 77.5% face-on to 94.6% edge-on lamellar texture as well as to a 2-fold increase in crystallinity and a 40% decrease in intracrystallite cumulative disorder. The texture change results in a significant drop in the electron-only diode current density through the film thickness upon melt annealing while little change is observed in the in-plane transport of bottom gated thin film transistors. This suggests that the texture change is prevalent in the film interior and that either the (bottom) surface structure is different from the interior structure or the intracrystalline order and texture play a secondary role in transistor transport for this material. Y1 - 2011 U6 - https://doi.org/10.1021/ma200864s SN - 0024-9297 VL - 44 IS - 13 SP - 5246 EP - 5255 PB - American Chemical Society CY - Washington ER - TY - JOUR A1 - Ilnytskyi, Jaroslav M. A1 - Neher, Dieter A1 - Saphiannikova, Marina T1 - Opposite photo-induced deformations in azobenzene-containing polymers with different molecular architecture molecular dynamics study JF - The journal of chemical physics : bridges a gap between journals of physics and journals of chemistr N2 - Photo-induced deformations in azobenzene-containing polymers (azo-polymers) are central to a number of applications, such as optical storage and fabrication of diffractive elements. The microscopic nature of the underlying opto-mechanical coupling is yet not clear. In this study, we address the experimental finding that the scenario of the effects depends on molecular architecture of the used azo-polymer. Typically, opposite deformations in respect to the direction of light polarization are observed for liquid crystalline and amorphous azo-polymers. In this study, we undertake molecular dynamics simulations of two different models that mimic these two types of azo-polymers. We employ hybrid force field modeling and consider only trans-isomers of azobenzene, represented as Gay-Berne sites. The effect of illumination on the orientation of the chromophores is considered on the level of orientational hole burning and emphasis is given to the resulting deformation of the polymer matrix. We reproduce deformations of opposite sign for the two models being considered here and discuss the relevant microscopic mechanisms in both cases. KW - amorphous state KW - light polarisation KW - liquid crystal polymers KW - molecular dynamics method KW - optical hole burning KW - photochemistry Y1 - 2011 U6 - https://doi.org/10.1063/1.3614499 SN - 0021-9606 VL - 135 IS - 4 PB - American Institute of Physics CY - Melville ER - TY - JOUR A1 - Kniepert, Juliane A1 - Schubert, Marcel A1 - Blakesley, James C. A1 - Neher, Dieter T1 - Photogeneration and recombination in P3HT/PCBM solar cells probed by time-delayed collection field experiments JF - The journal of physical chemistry letters N2 - Time-delayed collection field (TDCF) experiments are performed on bulk heterojunction solar cells comprised of a blend of poly(3-hexylthiophene) and [6,6]-phenyl C-71 butyric acid methyl ester. TDCF is analogous to a pump-probe experiment using optical excitation and an electrical probe with a resolution of < 100 ns. The number of free charge carriers extracted after a short delay is found to be independent of the electric field during illumination. Also, experiments performed with a variable delay between the optical excitation and the electrical probe do not reveal any evidence for the generation of charge via field-assisted dissociation of bound long-lived polaron pairs. Photocurrent transients are well fitted by computational drift diffusion simulations with only direct generation of free charge carriers. With increasing delay times between pump and probe, two loss mechanisms are identified; first, charge-carriers are swept out of the device by the internal electric field, and second, bimolecular recombination of the remaining carriers takes place with a reduced recombination coefficient. Y1 - 2011 U6 - https://doi.org/10.1021/jz200155b SN - 1948-7185 VL - 2 IS - 7 SP - 700 EP - 705 PB - American Chemical Society CY - Washington ER - TY - JOUR A1 - Kuehn, Sergei A1 - Pingel, Patrick A1 - Breusing, Markus A1 - Fischer, Thomas A1 - Stumpe, Joachim A1 - Neher, Dieter A1 - Elsaesser, Thomas T1 - High-Resolution Near-Field Optical Investigation of Crystalline Domains in Oligomeric PQT-12 Thin Films JF - Advanced functional materials N2 - The structure and morphology on different length scales dictate both the electrical and optical properties of organic semiconductor thin films. Using a combination of spectroscopic methods, including scanning near-field optical microscopy, we study the domain structure and packing quality of highly crystalline thin films of oligomeric PQT-12 with 100 nanometer spatial resolution. The pronounced optical anisotropy of these layers measured by polarized light microscopy facilitates the identification of regions with uniform molecular orientation. We find that a hierarchical order on three different length scales exists in these layers, made up of distinct well-ordered dichroic areas at the ten-micrometer-scale, which are sub-divided into domains with different molecular in-plane orientation. These serve as a template for the formation of smaller needle-like crystallites at the layer surface. A high degree of crystalline order is believed to be the cause of the rather high field-effect mobility of these layers of 10(-3) cm 2 V(-1) s(-1), whereas it is limited by the presence of domain boundaries at macroscopic distances. Y1 - 2011 U6 - https://doi.org/10.1002/adfm.201001978 SN - 1616-301X VL - 21 IS - 5 SP - 860 EP - 868 PB - Wiley-Blackwell CY - Malden ER - TY - JOUR A1 - Blakesley, James C. A1 - Neher, Dieter T1 - Relationship between energetic disorder and open-circuit voltage in bulk heterojunction organic solar cells JF - Physical review : B, Condensed matter and materials physics N2 - We simulate organic bulk heterojunction solar cells. The effects of energetic disorder are incorporated through a Gaussian or exponential model of density of states. Analytical models of open-circuit voltage (V(OC)) are derived from the splitting of quasi-Fermi potentials. Their predictions are backed up by more complex numerical device simulations including effects such as carrier-density-dependent charge-carrier mobilities. It is predicted that the V(OC) depends on: (1) the donor-acceptor energy gap; (2) charge-carrier recombination rates; (3) illumination intensity; (4) the contact work functions (if not in the pinning regime); and (5) the amount of energetic disorder. A large degree of energetic disorder, or a high density of traps, is found to cause significant reductions in V(OC). This can explain why V(OC) is often less than expected in real devices. Energetic disorder also explains the nonideal temperature and intensity dependence of V(OC) and the superbimolecular recombination rates observed in many real bulk heterojunction solar cells. Y1 - 2011 U6 - https://doi.org/10.1103/PhysRevB.84.075210 SN - 1098-0121 VL - 84 IS - 7 PB - American Physical Society CY - College Park ER - TY - JOUR A1 - Lange, Ilja A1 - Blakesley, James C. A1 - Frisch, Johannes A1 - Vollmer, Antje A1 - Koch, Norbert A1 - Neher, Dieter T1 - Band bending in conjugated polymer layers JF - Physical review letters N2 - We use the Kelvin probe method to study the energy-level alignment of four conjugated polymers deposited on various electrodes. Band bending is observed in all polymers when the substrate work function exceeds critical values. Through modeling, we show that the band bending is explained by charge transfer from the electrodes into a small density of states that extends several hundred meV into the band gap. The energetic spread of these states is correlated with charge-carrier mobilities, suggesting that the same states also govern charge transport in the bulk of these polymers. Y1 - 2011 U6 - https://doi.org/10.1103/PhysRevLett.106.216402 SN - 0031-9007 VL - 106 IS - 21 PB - American Physical Society CY - College Park ER - TY - JOUR A1 - Bagnich, Sergey A. A1 - Unger, Th. A1 - Jaiser, Frank A1 - Neher, Dieter A1 - Thesen, M. W. A1 - Krüger, H. T1 - Efficient green electrophosphorescence based on ambipolar nonconjugated polymers evaluation of transport and emission properties JF - Journal of applied physics N2 - New materials for polymer organic light-emitting diodes based on a polymer matrix doped with phosphorescent dyes are presented. The matrix system is based on a polystyrene backbone bearing either electron or hole transporting units at the 4-position of each repeat unit. Random copolymers and polymer blend systems of the homopolymers are prepared, both with 62 wt.% electron transporting and 38 wt.% hole transporting moieties. Adding a green electrophosphorescent dye to the polymer matrix leads to efficient electroluminescence with a maximum current efficiency of 35 cd/A and a maximum external quantum efficiency of up to 10%. The mobilities of electrons and holes in the dye-doped copolymer, as measured by transient electroluminescence, are around 5 x 10(-5) and 5 x 10(-6) cm(2)/Vs, respectively, while the blend of the two homopolymers exhibits slightly lower mobilities of both types of carriers. Despite the pronounced imbalance of charge transport, the device performance is almost entirely limited by the phosphorescence efficiency of the dye, implying balanced flow of holes and electrons into the active region. Also, devices made with either the copolymer or the blend yielded very similar device efficiencies, despite the noticeable difference in electron and hole mobility. It is proposed that electrons are efficiently blocked at the interlayer and that the so-formed space charge assists the balanced injection of holes. Y1 - 2011 U6 - https://doi.org/10.1063/1.3618681 SN - 0021-8979 SN - 1089-7550 VL - 110 IS - 3 PB - American Institute of Physics CY - Melville ER -