TY  - GEN
A1  - Behrens, Karsten
A1  - Balischewski, Christian
A1  - Sperlich, Eric
A1  - Menski, Antonia Isabell
A1  - Balderas-Valadez, Ruth Fabiola
A1  - Pacholski, Claudia
A1  - Günter, Christina
A1  - Lubahn, Susanne
A1  - Kelling, Alexandra
A1  - Taubert, Andreas
T1  - Mixed chloridometallate(ii) ionic liquids with tunable color and optical response for potential ammonia sensors
T2  - Zweitveröffentlichungen der Universität Potsdam : Mathematisch-Naturwissenschaftliche Reihe
N2  - Eight d-metal-containing N-butylpyridinium ionic liquids (ILs) with the nominal composition (C4Py)2[Ni0.5M0.5Cl4] or (C4Py)2[Zn0.5M0.5Cl4] (M = Cu, Co, Mn, Ni, Zn; C4Py = N-butylpyridinium) were synthesized, characterized, and investigated for their optical properties. Single crystal and powder X-ray analysis shows that the compounds are isostructural to existing examples based on other d-metal ions. Inductively coupled plasma optical emission spectroscopy measurements confirm that the metal/metal ratio is around 50 : 50. UV-Vis spectroscopy shows that the optical absorption can be tuned by selection of the constituent metals. Moreover, the compounds can act as an optical sensor for the detection of gases such as ammonia as demonstrated via a simple prototype setup.
T3  - Zweitveröffentlichungen der Universität Potsdam : Mathematisch-Naturwissenschaftliche Reihe - 1316 
Y1  - 2023
U6  - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:kobv:517-opus4-587512
SN  - 1866-8372
IS  - 1316
SP  - 35072
EP  - 35082
ER  - 
TY  - JOUR
A1  - Balischewski, Christian
A1  - Behrens, Karsten
A1  - Zehbe, Kerstin
A1  - Günter, Christina
A1  - Mies, Stefan
A1  - Sperlich, Eric
A1  - Kelling, Alexandra
A1  - Taubert, Andreas
T1  - Ionic liquids with more than one metal
BT  - optical and rlectrochemical properties versus d-block metal vombinations
JF  - Chemistry - a European journal
N2  - Thirteen N-butylpyridinium salts, including three monometallic [C4Py](2)[MCl4], nine bimetallic [C4Py](2)[(M1-xMxCl4)-M-a-Cl-b] and one trimetallic compound [C4Py](2)[(M1-y-zMyMz (c) Cl4)-M-a-M-b] (M=Co, Cu, Mn; x=0.25, 0.50 or 0.75 and y=z=0.33), were synthesized and their structure and thermal and electrochemical properties were studied. All compounds are ionic liquids (ILs) with melting points between 69 and 93 degrees C. X-ray diffraction proves that all ILs are isostructural. The conductivity at room temperature is between 10(-4) and 10(-8) S cm(-1). Some Cu-based ILs reach conductivities of 10(-2) S cm(-1), which is, however, probably due to IL dec. This correlates with the optical bandgap measurements indicating the formation of large bandgap semiconductors. At elevated temperatures approaching the melting points, the conductivities reach up to 1.47x10(-1) S cm(-1) at 70 degrees C. The electrochemical stability windows of the ILs are between 2.5 and 3.0 V.
KW  - bandgap
KW  - electrochemistry
KW  - ionic liquids
KW  - metal-containing ionic
KW  - liquids
KW  - tetrahalido metallates
Y1  - 2020
U6  - https://doi.org/10.1002/chem.202003097
SN  - 0947-6539
SN  - 1521-3765
VL  - 26
IS  - 72
SP  - 17504
EP  - 17513
PB  - Wiley-VCH
CY  - Weinheim
ER  - 
TY  - JOUR
A1  - Behrens, Karsten
A1  - Balischewski, Christian
A1  - Sperlich, Eric
A1  - Menski, Antonia Isabell
A1  - Balderas-Valadez, Ruth Fabiola
A1  - Pacholski, Claudia
A1  - Günter, Christina
A1  - Lubahn, Susanne
A1  - Kelling, Alexandra
A1  - Taubert, Andreas
T1  - Mixed chloridometallate(ii) ionic liquids with tunable color and optical response for potential ammonia sensors
JF  - RSC Advances
N2  - Eight d-metal-containing N-butylpyridinium ionic liquids (ILs) with the nominal composition (C4Py)2[Ni0.5M0.5Cl4] or (C4Py)2[Zn0.5M0.5Cl4] (M = Cu, Co, Mn, Ni, Zn; C4Py = N-butylpyridinium) were synthesized, characterized, and investigated for their optical properties. Single crystal and powder X-ray analysis shows that the compounds are isostructural to existing examples based on other d-metal ions. Inductively coupled plasma optical emission spectroscopy measurements confirm that the metal/metal ratio is around 50 : 50. UV-Vis spectroscopy shows that the optical absorption can be tuned by selection of the constituent metals. Moreover, the compounds can act as an optical sensor for the detection of gases such as ammonia as demonstrated via a simple prototype setup.
Y1  - 2022
U6  - https://doi.org/10.1039/d2ra05581c
SN  - 2046-2069
VL  - 12
SP  - 35072
EP  - 35082
PB  - RSC
CY  - London
ER  - 
TY  - JOUR
A1  - Balischewski, Christian
A1  - Bhattacharyya, Biswajit
A1  - Sperlich, Eric
A1  - Günter, Christina
A1  - Beqiraj, Alkit
A1  - Klamroth, Tillmann
A1  - Behrens, Karsten
A1  - Mies, Stefan
A1  - Kelling, Alexandra
A1  - Lubahn, Susanne
A1  - Holtzheimer, Lea
A1  - Nitschke, Anne
A1  - Taubert, Andreas
T1  - Tetrahalidometallate(II) ionic liquids with more than one metal
BT  - the effect of bromide versus chloride
JF  - Chemistry - a European journal
N2  - Fifteen N-butylpyridinium salts - five monometallic [C4Py](2)[MBr4] and ten bimetallic [C4Py](2)[(M0.5M0.5Br4)-M-a-Br-b] (M=Co, Cu, Mn, Ni, Zn) - were synthesized, and their structures and thermal and electrochemical properties were studied. All the compounds are ionic liquids (ILs) with melting points between 64 and 101 degrees C. Powder and single-crystal X-ray diffraction show that all ILs are isostructural. The electrochemical stability windows of the ILs are between 2 and 3 V. The conductivities at room temperature are between 10(-5) and 10(-6) S cm(-1). At elevated temperatures, the conductivities reach up to 10(-4) S cm(-1) at 70 degrees C. The structures and properties of the current bromide-based ILs were also compared with those of previous examples using chloride ligands, which illustrated differences and similarities between the two groups of ILs.
KW  - electrochemistry
KW  - ionic liquids
KW  - metal-containing ionic liquids;
KW  - N-butylpyridinium bromide
KW  - tetrahalidometallates
Y1  - 2022
U6  - https://doi.org/10.1002/chem.202201068
SN  - 1521-3765
VL  - 28
IS  - 64
PB  - Wiley-VCH
CY  - Weinheim
ER  - 
TY  - JOUR
A1  - Balischewski, Christian
A1  - Choi, Hyung-Seok
A1  - Behrens, Karsten
A1  - Beqiraj, Alkit
A1  - Körzdörfer, Thomas
A1  - Gessner, Andre
A1  - Wedel, Armin
A1  - Taubert, Andreas
T1  - Metal sulfide nanoparticle synthesis with ionic liquids state of the art and future perspectives
JF  - ChemistryOpen
N2  - Metal sulfides are among the most promising materials for a wide variety of technologically relevant applications ranging from energy to environment and beyond. Incidentally, ionic liquids (ILs) have been among the top research subjects for the same applications and also for inorganic materials synthesis. As a result, the exploitation of the peculiar properties of ILs for metal sulfide synthesis could provide attractive new avenues for the generation of new, highly specific metal sulfides for numerous applications. This article therefore describes current developments in metal sulfide nano-particle synthesis as exemplified by a number of highlight examples. Moreover, the article demonstrates how ILs have been used in metal sulfide synthesis and discusses the benefits of using ILs over more traditional approaches. Finally, the article demonstrates some technological challenges and how ILs could be used to further advance the production and specific property engineering of metal sulfide nanomaterials, again based on a number of selected examples.
KW  - Ionic liquids
KW  - ionic liquid crystals
KW  - ionic liquid precursors
KW  - metal
KW  - sulfides
KW  - catalysis
KW  - electrochemistry
KW  - energy materials
KW  - LED
KW  - solar
KW  - cells
Y1  - 2021
U6  - https://doi.org/10.1002/open.202000357
SN  - 2191-1363
VL  - 10
IS  - 2
SP  - 272
EP  - 295
PB  - Wiley-VCH
CY  - Weinheim
ER  - 
TY  - GEN
A1  - Taubert, Andreas
A1  - Balischewski, Christian
A1  - Hentrich, Doreen
A1  - Elschner, Thomas
A1  - Eidner, Sascha
A1  - Günter, Christina
A1  - Behrens, Karsten
A1  - Heinze, Thomas
T1  - Water-soluble cellulose derivatives are sustainable additives for biomimetic calcium phosphate mineralization
N2  - The effect of cellulose-based polyelectrolytes on biomimetic calcium phosphate mineralization is described. Three cellulose derivatives, a polyanion, a polycation, and a polyzwitterion were used as additives. Scanning electron microscopy, X-ray diffraction, IR and Raman spectroscopy show that, depending on the composition of the starting solution, hydroxyapatite or brushite precipitates form. Infrared and Raman spectroscopy also show that significant amounts of nitrate ions are incorporated in the precipitates. Energy dispersive X-ray spectroscopy shows that the Ca/P ratio varies throughout the samples and resembles that of other bioinspired calcium phosphate hybrid materials. Elemental analysis shows that the carbon (i.e., polymer) contents reach 10% in some samples, clearly illustrating the formation of a true hybrid material. Overall, the data indicate that a higher polymer concentration in the reaction mixture favors the formation of polymer-enriched materials, while lower polymer concentrations or high precursor concentrations favor the formation of products that are closely related to the control samples precipitated in the absence of polymer. The results thus highlight the potential of (water-soluble) cellulose derivatives for the synthesis and design of bioinspired and bio-based hybrid materials.
T3  - Zweitveröffentlichungen der Universität Potsdam : Mathematisch-Naturwissenschaftliche Reihe - 354 
KW  - cellulose
KW  - polyamine
KW  - polyammonium salt
KW  - polycarboxylate
KW  - polyzwitterion
KW  - calcium phosphate
KW  - biomineralization
KW  - brushite
KW  - hydroyxapatite
KW  - biomaterial
Y1  - 2017
U6  - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:kobv:517-opus4-400453
ER  - 
TY  - JOUR
A1  - Taubert, Andreas
A1  - Balischewski, Christian
A1  - Hentrich, Doreen
A1  - Elschner, Thomas
A1  - Eidner, Sascha
A1  - Günter, Christina
A1  - Behrens, Karsten
A1  - Heinze, Thomas
T1  - Water-Soluble Cellulose Derivatives Are Sustainable Additives for Biomimetic Calcium Phosphate Mineralization
JF  - Inorganics : open access journal
N2  - The effect of cellulose-based polyelectrolytes on biomimetic calcium phosphate mineralization is described. Three cellulose derivatives, a polyanion, a polycation, and a polyzwitterion were used as additives. Scanning electron microscopy, X-ray diffraction, IR and Raman spectroscopy show that, depending on the composition of the starting solution, hydroxyapatite or brushite precipitates form. Infrared and Raman spectroscopy also show that significant amounts of nitrate ions are incorporated in the precipitates. Energy dispersive X-ray spectroscopy shows that the Ca/P ratio varies throughout the samples and resembles that of other bioinspired calcium phosphate hybrid materials. Elemental analysis shows that the carbon (i.e., polymer) contents reach 10% in some samples, clearly illustrating the formation of a true hybrid material. Overall, the data indicate that a higher polymer concentration in the reaction mixture favors the formation of polymer-enriched materials, while lower polymer concentrations or high precursor concentrations favor the formation of products that are closely related to the control samples precipitated in the absence of polymer. The results thus highlight the potential of (water-soluble) cellulose derivatives for the synthesis and design of bioinspired and bio-based hybrid materials.
KW  - cellulose
KW  - polyamine
KW  - polyammonium salt
KW  - polycarboxylate
KW  - polyzwitterion
KW  - calcium phosphate
KW  - biomineralization
KW  - brushite
KW  - hydroyxapatite
KW  - biomaterial
Y1  - 2016
U6  - https://doi.org/10.3390/inorganics4040033
SN  - 2304-6740
VL  - 4
PB  - MDPI
CY  - Basel
ER  -