TY - JOUR A1 - Al-Sa'di, Mahmoud A1 - Jaiser, Frank A1 - Bagnich, Sergey A. A1 - Unger, Thomas A1 - Blakesley, James C. A1 - Wilke, Andreas A1 - Neher, Dieter T1 - Electrical and optical simulations of a polymer-based phosphorescent organic light-emitting diode with high efficiency JF - Journal of polymer science : B, Polymer physics N2 - A comprehensive numerical device simulation of the electrical and optical characteristics accompanied with experimental measurements of a new highly efficient system for polymer-based light-emitting diodes doped with phosphorescent dyes is presented. The system under investigation comprises an electron transporter attached to a polymer backbone blended with an electronically inert small molecule and an iridium-based green phosphorescent dye which serves as both emitter and hole transporter. The device simulation combines an electrical and an optical model. Based on the known highest occupied molecular orbital (HOMO) and lowest unoccupied molecular orbital (LUMO) levels of all components as well as the measured electrical and optical characteristics of the devices, we model the emissive layer as an effective medium using the dye's HOMO as hole transport level and the polymer LUMO as electron transport level. By fine-tuning the injection barriers at the electron and hole-injecting contact, respectively, in simulated devices, unipolar device characteristics were fitted to the experimental data. Simulations using the so-obtained set of parameters yielded very good agreement to the measured currentvoltage, luminancevoltage characteristics, and the emission profile of entire bipolar light-emitting diodes, without additional fitting parameters. The simulation was used to gain insight into the physical processes and the mechanisms governing the efficiency of the organic light-emitting diode, including the position and extent of the recombination zone, carrier concentration profiles, and field distribution inside the device. The simulations show that the device is severely limited by hole injection, and that a reduction of the hole-injection barrier would improve the device efficiency by almost 50%. KW - conjugated polymers KW - high performance polymers KW - organic electronics KW - organic light-emitting diode KW - simulations KW - TCAD Y1 - 2012 U6 - https://doi.org/10.1002/polb.23158 SN - 0887-6266 VL - 50 IS - 22 SP - 1567 EP - 1576 PB - Wiley-Blackwell CY - Hoboken ER - TY - JOUR A1 - Proctor, Christopher M. A1 - Kim, Chunki A1 - Neher, Dieter A1 - Thuc-Quyen Nguyen, T1 - Nongeminate recombination and charge transport limitations in diketopyrrolopyrrole-based solution-processed small molecule solar cells JF - Advanced functional materials N2 - Charge transport and nongeminate recombination are investigated in two solution-processed small molecule bulk heterojunction solar cells consisting of diketopyrrolopyrrole (DPP)-based donor molecules, mono-DPP and bis-DPP, blended with [6,6]-phenyl-C71-butyric acid methyl ester (PCBM). While the bis-DPP system exhibits a high fill factor (62%) the mono-DPP system suffers from pronounced voltage dependent losses, which limit both the fill factor (46%) and short circuit current. A method to determine the average charge carrier density, recombination current, and effective carrier lifetime in operating solar cells as a function of applied bias is demonstrated. These results and light intensity measurements of the current-voltage characteristics indicate that the mono-DPP system is severely limited by nongeminate recombination losses. Further analysis reveals that the most significant factor leading to the difference in fill factor is the comparatively poor hole transport properties in the mono-DPP system (2 x 10(-5) cm(2) V-1 s(-1) versus 34 x 10(-5) cm(2) V-1 s(-1)). These results suggest that future design of donor molecules for organic photovoltaics should aim to increase charge carrier mobility thereby enabling faster sweep out of charge carriers before they are lost to nongeminate recombination. KW - charge transport KW - solar cells KW - photovoltaic devices KW - organic electronics KW - characterization tools Y1 - 2013 U6 - https://doi.org/10.1002/adfm.201202643 SN - 1616-301X SN - 1616-3028 VL - 23 IS - 28 SP - 3584 EP - 3594 PB - Wiley-VCH CY - Weinheim ER - TY - THES A1 - Pingel, Patrick T1 - Morphology, charge transport properties, and molecular doping of thiophene-based organic semiconducting thin films T1 - Morphologie, Ladungstransporteigenschaften und molekulares Dotieren thiophenbasierter organischer Halbleiterschichten N2 - Organic semiconductors combine the benefits of organic materials, i.e., low-cost production, mechanical flexibility, lightweight, and robustness, with the fundamental semiconductor properties light absorption, emission, and electrical conductivity. This class of material has several advantages over conventional inorganic semiconductors that have led, for instance, to the commercialization of organic light-emitting diodes which can nowadays be found in the displays of TVs and smartphones. Moreover, organic semiconductors will possibly lead to new electronic applications which rely on the unique mechanical and electrical properties of these materials. In order to push the development and the success of organic semiconductors forward, it is essential to understand the fundamental processes in these materials. This thesis concentrates on understanding how the charge transport in thiophene-based semiconductor layers depends on the layer morphology and how the charge transport properties can be intentionally modified by doping these layers with a strong electron acceptor. By means of optical spectroscopy, the layer morphologies of poly(3-hexylthiophene), P3HT, P3HT-fullerene bulk heterojunction blends, and oligomeric polyquaterthiophene, oligo-PQT-12, are studied as a function of temperature, molecular weight, and processing conditions. The analyses rely on the decomposition of the absorption contributions from the ordered and the disordered parts of the layers. The ordered-phase spectra are analyzed using Spano’s model. It is figured out that the fraction of aggregated chains and the interconnectivity of these domains is fundamental to a high charge carrier mobility. In P3HT layers, such structures can be grown with high-molecular weight, long P3HT chains. Low and medium molecular weight P3HT layers do also contain a significant amount of chain aggregates with high intragrain mobility; however, intergranular connectivity and, therefore, efficient macroscopic charge transport are absent. In P3HT-fullerene blend layers, a highly crystalline morphology that favors the hole transport and the solar cell efficiency can be induced by annealing procedures and the choice of a high-boiling point processing solvent. Based on scanning near-field and polarization optical microscopy, the morphology of oligo-PQT-12 layers is found to be highly crystalline which explains the rather high field-effect mobility in this material as compared to low molecular weight polythiophene fractions. On the other hand, crystalline dislocations and grain boundaries are identified which clearly limit the charge carrier mobility in oligo-PQT-12 layers. The charge transport properties of organic semiconductors can be widely tuned by molecular doping. Indeed, molecular doping is a key to highly efficient organic light-emitting diodes and solar cells. Despite this vital role, it is still not understood how mobile charge carriers are induced into the bulk semiconductor upon the doping process. This thesis contains a detailed study of the doping mechanism and the electrical properties of P3HT layers which have been p-doped by the strong molecular acceptor tetrafluorotetracyanoquinodimethane, F4TCNQ. The density of doping-induced mobile holes, their mobility, and the electrical conductivity are characterized in a broad range of acceptor concentrations. A long-standing debate on the nature of the charge transfer between P3HT and F4TCNQ is resolved by showing that almost every F4TCNQ acceptor undergoes a full-electron charge transfer with a P3HT site. However, only 5% of these charge transfer pairs can dissociate and induce a mobile hole into P3HT which contributes electrical conduction. Moreover, it is shown that the left-behind F4TCNQ ions broaden the density-of-states distribution for the doping-induced mobile holes, which is due to the longrange Coulomb attraction in the low-permittivity organic semiconductors. N2 - Organische Halbleiter kombinieren die molekulare Vielfalt und Anpassbarkeit, die mechanische Flexibilität und die preisgünstige Herstellung und Verarbeitung von Kunststoffen mit fundamentalen Halbleitereigenschaften wie Lichtabsorption und -emission und elektrischer Leitfähigkeit. Unlängst finden organische Leuchtdioden Anwendung in den Displays von TV-Geräten und Smartphones. Für die weitere Entwicklung und den Erfolg organischer Halbleiter ist das Verständnis derer physikalischer Grundlagen unabdingbar. Ein für viele Bauteile fundamentaler Prozess ist der Transport von Ladungsträgern in der organischen Schicht. Die Ladungstransporteigenschaften werden maßgeblich durch die Struktur dieser Schicht bestimmt, z.B. durch den Grad der molekularen Ordnung, die molekulare Verbindung von kristallinen Domänen und durch Defekte der molekularen Packung. Mittels optischer Spektroskopie werden in dieser Arbeit die temperatur-, molekulargewichts- und lösemittelabhängigen Struktureigenschaften poly- und oligothiophenbasierter Schichten untersucht. Dabei basiert die Analyse der Absorptionsspektren auf der Zerlegung in die spezifischen Anteile geordneten und ungeordneten Materials. Es wird gezeigt, dass sich hohe Ladungsträgerbeweglichkeiten dann erreichen lassen, wenn der Anteil der geordneten Bereiche und deren molekulare Verbindung in den Schichten möglichst hoch und die energetische Unordnung in diesen Bereichen möglichst klein ist. Der Ladungstransport in organischen Halbleitern kann außerdem gezielt beeinflusst werden, indem die Ladungsträgerdichte und die elektrische Leitfähigkeit durch molekulares Dotieren, d.h. durch das Einbringen von Elektronenakzeptoren oder -donatoren, eingestellt werden. Obwohl der Einsatz dotierter Schichten essentiell für effiziente Leuchtdioden und Solarzellen ist, ist der Mechanismus, der zur Erzeugung freier Ladungsträger im organischen Halbleiter führt, derzeit unverstanden. In dieser Arbeit wird der Ladungstransfer zwischen dem prototypischen Elektronendonator P3HT und dem Akzeptor F4TCNQ untersucht. Es wird gezeigt, dass, entgegen verbreiteter Vorstellungen, fast alle F4TCNQ-Akzeptoren einen ganzzahligen Ladungstransfer mit P3HT eingehen, aber nur 5% dieser Paare dissoziieren und einen beweglichen Ladungsträger erzeugen, der zur elektrischen Leitfähigkeit beiträgt. Weiterhin wird gezeigt, dass die zurückgelassenen F4TCNQ-Akzeptorionen Fallenzustände für die beweglichen Ladungsträger darstellen und so die Ladungsträgerbeweglichkeit in P3HT bei schwacher Dotierung absinkt. Die elektrischen Kenngrößen Ladungsträgerkonzentration, Beweglichkeit und Leitfähigkeit von F4TCNQ-dotierten P3HT-Schichten werden in dieser Arbeit erstmals in weiten Bereichen verschiedener Akzeptorkonzentrationen untersucht. KW - Polythiophen KW - organische Elektronik KW - molekulares Dotieren KW - organischer Halbleiter KW - Morphologie KW - polythiohene KW - organic electronics KW - molecular doping KW - organic semiconductor KW - morphology Y1 - 2013 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:kobv:517-opus-69805 ER -