TY - JOUR A1 - Piersimoni, Fortunato A1 - Schlesinger, Raphael A1 - Benduhn, Johannes A1 - Spoltore, Donato A1 - Reiter, Sina A1 - Lange, Ilja A1 - Koch, Norbert A1 - Vandewal, Koen A1 - Neher, Dieter T1 - Charge Transfer Absorption and Emission at ZnO/Organic Interfaces JF - The journal of physical chemistry letters N2 - We investigate hybrid charge transfer states (HCTS) at the planar interface between a-NPD and ZnO by spectrally resolved electroluminescence (EL) and external quantum efficiency (EQE) measurements. Radiative decay of HCTSs is proven by distinct emission peaks in the EL spectra of such bilayer devices in the NIR at energies well below the bulk a-NPD or ZnO emission. The EQE spectra display low energy contributions clearly red-shifted with respect to the a-NPD photocurrent and partially overlapping with the EL emission. Tuning of the energy gap between the ZnO conduction band and a-NPD HOMO level (E-int) was achieved by modifying the ZnO surface with self-assembled monolayers based on phosphonic acids. We find a linear dependence of the peak position of the NIR EL on E-int, which unambiguously attributes the origin of this emission to radiative recombination between an electron on the ZnO and a hole on a-NPD. In accordance with this interpretation, we find a strictly linear relation between the open-circuit voltage and the energy of the charge state for such hybrid organicinorganic interfaces. Y1 - 2015 U6 - https://doi.org/10.1021/jz502657z SN - 1948-7185 VL - 6 IS - 3 SP - 500 EP - 504 PB - American Chemical Society CY - Washington ER - TY - JOUR A1 - Lange, Ilja A1 - Reiter, Sina A1 - Paetzel, Michael A1 - Zykov, Anton A1 - Nefedov, Alexei A1 - Hildebrandt, Jana A1 - Hecht, Stefan A1 - Kowarik, Stefan A1 - Woell, Christof A1 - Heimel, Georg A1 - Neher, Dieter T1 - Tuning the work function of polar zinc oxide surfaces using modified phosphonic acid self-assembled monolayers JF - Advanced functional materials N2 - Zinc oxide (ZnO) is regarded as a promising alternative material for transparent conductive electrodes in optoelectronic devices. However, ZnO suffers from poor chemical stability. ZnO also has a moderate work function (WF), which results in substantial charge injection barriers into common (organic) semiconductors that constitute the active layer in a device. Controlling and tuning the ZnO WF is therefore necessary but challenging. Here, a variety of phosphonic acid based self-assembled monolayers (SAMs) deposited on ZnO surfaces are investigated. It is demonstrated that they allow the tuning the WF over a wide range of more than 1.5 eV, thus enabling the use of ZnO as both the hole-injecting and electron-injecting contact. The modified ZnO surfaces are characterized using a number of complementary techniques, demonstrating that the preparation protocol yields dense, well-defined molecular monolayers. KW - ZnO KW - self-assembled monolayers KW - phosphonic acid KW - surface modification KW - electrodes Y1 - 2014 U6 - https://doi.org/10.1002/adfm.201401493 SN - 1616-301X SN - 1616-3028 VL - 24 IS - 44 SP - 7014 EP - 7024 PB - Wiley-VCH CY - Weinheim ER - TY - JOUR A1 - Lange, Ilja A1 - Reiter, Sina A1 - Kniepert, Juliane A1 - Piersimoni, Fortunato A1 - Paetzel, Michael A1 - Hildebrandt, Jana A1 - Brenner, Thomas J. K. A1 - Hecht, Stefan A1 - Neher, Dieter T1 - Zinc oxide modified with benzylphosphonic acids as transparent electrodes in regular and inverted organic solar cell structures JF - Applied physics letters N2 - An approach is presented to modify the work function of solution-processed sol-gel derived zinc oxide (ZnO) over an exceptionally wide range of more than 2.3 eV. This approach relies on the formation of dense and homogeneous self-assembled monolayers based on phosphonic acids with different dipole moments. This allows us to apply ZnO as charge selective bottom electrodes in either regular or inverted solar cell structures, using poly(3-hexylthiophene): phenyl-C71-butyric acid methyl ester as the active layer. These devices compete with or even surpass the performance of the reference on indium tin oxide/poly(3,4-ethylenedioxythiophene) polystyrene sulfonate. Our findings highlight the potential of properly modified ZnO as electron or hole extracting electrodes in hybrid optoelectronic devices. (C) 2015 AIP Publishing LLC. Y1 - 2015 U6 - https://doi.org/10.1063/1.4916182 SN - 0003-6951 SN - 1077-3118 VL - 106 IS - 11 PB - American Institute of Physics CY - Melville ER - TY - JOUR A1 - Lange, Ilja A1 - Kniepert, Juliane A1 - Pingel, Patrick A1 - Dumsch, Ines A1 - Allard, Sybille A1 - Janietz, Silvia A1 - Scherf, Ullrich A1 - Neher, Dieter T1 - Correlation between the open circuit voltage and the energetics of organic bulk heterojunction solar cells JF - The journal of physical chemistry letters N2 - A detailed investigation of the open circuit voltage (V-OC) of organic bulk heterojunction solar cells comprising three different donor polymers and two different fullerene-based acceptors is presented. Bias amplified charge extraction (BACE) is combined with Kelvin Probe measurements to derive information on the relevant energetics in the blend. On the example of P3HT:PC70BM the influence of composition and preparation conditions on the relevant transport levels will be shown. Moderate upward shifts of the P3HT HOMO depending on crystallinity are observed, but contrarily to common believe, the dependence of V-OC on blend composition and thermal history is found to be largely determined by the change in the PCBM LUMO energy. Following this approach, we quantified the energetic contribution to the V-OC in blends with fluorinated polymers or higher adduct fullerenes. Y1 - 2013 U6 - https://doi.org/10.1021/jz401971e SN - 1948-7185 VL - 4 IS - 22 SP - 3865 EP - 3871 PB - American Chemical Society CY - Washington ER - TY - JOUR A1 - Lange, Ilja A1 - Blakesley, James C. A1 - Frisch, Johannes A1 - Vollmer, Antje A1 - Koch, Norbert A1 - Neher, Dieter T1 - Band bending in conjugated polymer layers JF - Physical review letters N2 - We use the Kelvin probe method to study the energy-level alignment of four conjugated polymers deposited on various electrodes. Band bending is observed in all polymers when the substrate work function exceeds critical values. Through modeling, we show that the band bending is explained by charge transfer from the electrodes into a small density of states that extends several hundred meV into the band gap. The energetic spread of these states is correlated with charge-carrier mobilities, suggesting that the same states also govern charge transport in the bulk of these polymers. Y1 - 2011 U6 - https://doi.org/10.1103/PhysRevLett.106.216402 SN - 0031-9007 VL - 106 IS - 21 PB - American Physical Society CY - College Park ER - TY - THES A1 - Lange, Ilja T1 - Energetische Struktur von Schichten organischer Halbleiter und ihr fundamentaler Einfluss auf die physikalischen Eigenschaften organischer elektronischer Bauteile Y1 - 2014 ER - TY - JOUR A1 - Kniepert, Juliane A1 - Lange, Ilja A1 - van der Kaap, Niels J. A1 - Koster, L. Jan Anton A1 - Neher, Dieter T1 - A conclusive view on charge generation, recombination, and extraction in As-prepared and annealed P3HT:PCBM blends: combined experimental and simulation work JF - dvanced energy materials N2 - Time-delayed collection field (TDCF) and bias-amplified charge extraction (BACE) are applied to as-prepared and annealed poly(3-hexylthiophene):[6,6]-phenyl C-71 butyric acid methyl ester (P3HT:PCBM) blends coated from chloroform. Despite large differences in fill factor, short-circuit current, and power conversion efficiency, both blends exhibit a negligible dependence of photogeneration on the electric field and strictly bimolecular recombination (BMR) with a weak dependence of the BMR coefficient on charge density. Drift-diffusion simulations are performed using the measured coefficients and mobilities, taking into account bimolecular recombination and the possible effects of surface recombination. The excellent agreement between the simulation and the experimental data for an intensity range covering two orders of magnitude indicates that a field-independent generation rate and a density-independent recombination coefficient describe the current-voltage characteristics of the annealed P3HT: PCBM devices, while the performance of the as-prepared blend is shown to be limited by space charge effects due to a low hole mobility. Finally, even though the bimolecular recombination coefficient is small, surface recombination is found to be a negligible loss mechanism in these solar cells. Y1 - 2014 U6 - https://doi.org/10.1002/aenm.201301401 SN - 1614-6832 SN - 1614-6840 VL - 4 IS - 7 PB - Wiley-VCH CY - Weinheim ER - TY - JOUR A1 - Kniepert, Juliane A1 - Lange, Ilja A1 - Heidbrink, Jan A1 - Kurpiers, Jona A1 - Brenner, Thomas J. K. A1 - Koster, L. Jan Anton A1 - Neher, Dieter T1 - Effect of Solvent Additive on Generation, Recombination, and Extraction in PTB7:PCBM Solar Cells: A Conclusive Experimental and Numerical Simulation Study JF - The journal of physical chemistry : C, Nanomaterials and interfaces N2 - Time-delayed collection field (TDCF), bias-assisted charge extraction (BACE), and space charge-limited current (SCLC) measurements are combined with complete numerical device simulations to unveil the effect of the solvent additive 1,8-diiodooctane (DIO) on the performance of PTB7:PCBM bulk heterojunction solar cells. DIO is shown to increase the charge generation rate, reduce geminate and bimolecular recombination, and increase the electron mobility. In total, the reduction of loss currents by processing with the additive raises the power conversion efficiency of the PTB7:PCBM blend by a factor of almost three. The lower generation rates and higher geminate recombination losses in devices without DIO are consistent with a blend morphology comprising large fullerene clusters embedded within a PTB7-rich matrix, while the low electron mobility suggests that these fullerene clusters are themselves composed of smaller pure fullerene aggregates separated by disordered areas. Our device simulations show unambiguously that the effect of the additive on the shape of the currentvoltage curve (J-V) cannot be ascribed to the variation of only the mobility, the recombination, or the field dependence of generation. It is only when the changes of all three parameters are taken into account that the simulation matches the experimental J-V characteristics under all illumination conditions and for a wide range of voltages. Y1 - 2015 U6 - https://doi.org/10.1021/jp512721e SN - 1932-7447 VL - 119 IS - 15 SP - 8310 EP - 8320 PB - American Chemical Society CY - Washington ER - TY - JOUR A1 - Albrecht, Steve A1 - Schaefer, Sebastian A1 - Lange, Ilja A1 - Yilmaz, Seyfullah A1 - Dumsch, Ines A1 - Allard, Sybille A1 - Scherf, Ullrich A1 - Hertwig, Andreas A1 - Neher, Dieter T1 - Light management in PCPDTBT:PC70BM solar cells: A comparison of standard and inverted device structures JF - Organic electronics : physics, materials and applications N2 - We compare standard and inverted bulk heterojunction solar cells composed of PCPDTBT:PC70BM blends. Inverted devices comprising 100 nm thick active layers exhibited short circuit currents of 15 mA/cm(2), 10% larger than in corresponding standard devices. Modeling of the optical field distribution in the different device stacks proved that this enhancement originates from an increased absorption of incident light in the active layer. Internal quantum efficiencies (IQEs) were obtained from the direct comparison of experimentally derived and modeled currents for different layer thicknesses, yielding IQEs of similar to 70% for a layer thickness of 100 nm. Simulations predict a significant increase of the light harvesting efficiency upon increasing the layer thickness to 270 nm. However, a continuous deterioration of the photovoltaic properties with layer thickness was measured for both device architectures, attributed to incomplete charge extraction. On the other hand, our optical modeling suggests that inverted devices based on PCPDTBT should be able to deliver high power conversion efficiencies (PCEs) of more than 7% provided that recombination losses can be reduced. KW - Organic solar cells KW - Inverted solar cells KW - PCPDTBT KW - Low band-gap KW - Optical modeling Y1 - 2012 U6 - https://doi.org/10.1016/j.orgel.2011.12.019 SN - 1566-1199 VL - 13 IS - 4 SP - 615 EP - 622 PB - Elsevier CY - Amsterdam ER -