TY - JOUR A1 - Herfurth, Christoph A1 - Laschewsky, Andre A1 - Noirez, Laurence A1 - von Lospichl, Benjamin A1 - Gradzielski, Michael T1 - Thermoresponsive (star) block copolymers from one-pot sequential RAFT polymerizations and their self-assembly in aqueous solution JF - Polymer : the international journal for the science and technology of polymers N2 - A series of hydrophobically end-capped linear triblock copolymers as well as of three-arm and four-arm star block copolymers was synthesized in a one-pot procedure from N,N-dimethylacrylamide (DMA) and N, N-diethylacrylamide (DEA). The sequential reversible addition-fragmentation chain transfer (RAFT) polymerization of these monomers via the R-approach using bi-, tri- and tetrafunctional chain transfer agents (CrAs) bearing hydrophobic dodecyl moieties proceeded in a well-controlled manner up to almost quantitative conversion. Polymers with molar masses up to 150 kDa, narrow molar mass distribution (PDI <= 1.3) and high end group functionality were obtained, which are thermoresponsive in aqueous solution showing a LCST (lower critical solution temperature) transition. The temperature-dependent associative behavior of the polymers was examined using turbidimetry, static and dynamic light scattering (SLS, DLS), and small angle neutron scattering (SANS) for structural analysis. At 25 degrees C, the polymers form weak transient networks, and rather small hydrophobic domains are already present for polymer concentrations of 5 wt%. However, when heating above the LCST transition (35-40 degrees C) of the PDEA blocks, the enhanced formation of hydrophobic domains is observed by means of light and neutron scattering. These domains have a size of about 12-15 nm and must be effectively physically cross-linked as they induce high viscosity for the more concentrated samples. SANS shows that these domains are ordered as evidenced by the appearance of a correlation peak. The copolymer architecture affects in particular the extent of ordering as the four-arm star block copolymer shows much more repulsive interactions compared to the analogous copolymers with a lower number of arms. (C) 2016 Elsevier Ltd. All rights reserved. KW - RAFT polymerization KW - Block copolymers KW - Thermosensitivity KW - LCST KW - SANS KW - Light scattering Y1 - 2016 U6 - https://doi.org/10.1016/j.polymer.2016.09.089 SN - 0032-3861 SN - 1873-2291 VL - 107 SP - 422 EP - 433 PB - Elsevier CY - Oxford ER - TY - JOUR A1 - de Molina, Paula Malo A1 - Herfurth, Christoph A1 - Laschewsky, André A1 - Gradzielski, Michael T1 - Structure and dynamics of networks in mixtures of hydrophobically modified telechelic multiarm polymers and oil in water microemulsions JF - Langmuir N2 - The structural and dynamical properties of oil-in-water (O/W) microemulsions (MEs) modified with telechelic polymers of different functionality (e.g., number of hydrophobically modified arms, f) were studied by means of dynamic light scattering (DLS), small-angle neutron scattering (SANS), and high frequency rheology measurements as a function of the polymer architecture and the amount of added polymer. For this purpose, we employed tailor-made hydrophobically end-capped poly(N,N-dimethylacrylamide) star polymers of a variable number of endcaps, f, of different alkyl chain lengths, synthesized by the reversible addition-fragmentation chain transfer method. The addition of the different end-capped polymers to an uncharged ME of O/W droplets leads to a large enhancement of the viscosity of the systems. SANS experiments show that the O/W ME droplets are not changed upon the addition of the polymer, and its presence only changes the interdroplet interactions. The viscosity increases largely upon addition of a polymer, and this enhancement depends pronouncedly on the alkyl length of the hydrophobic sticker as it controls the residence time in a ME droplet. Similarly, the high frequency modulus G(0) depends on the amount of added polymer but not on the sticker length. G(0) was found to be directly proportional to f - 1. The onset of network formation is shifted to a lower number of stickers per ME droplet with increasing f, and the network formation becomes more effective. Thus, the dynamics of network formation are controlled by the polymer architecture. The effect on the dynamics seen by DLS is even more pronounced. Upon increasing the polymer concentration, slower relaxation modes appear that become especially pronounced with increasing number of arms. The relaxation dynamics are correlated to the rheological relaxation, and both are controlled by the polymer architecture. Y1 - 2012 U6 - https://doi.org/10.1021/la303673a SN - 0743-7463 VL - 28 IS - 45 SP - 15994 EP - 16006 PB - American Chemical Society CY - Washington ER - TY - JOUR A1 - Herfurth, Christoph A1 - Voll, Dominik A1 - Buller, Jens A1 - Weiss, Jan A1 - Barner-Kowollik, Christopher A1 - Laschewsky, André T1 - Radical addition fragmentation chain transfer (RAFT) polymerization of ferrocenyl (meth)acrylates JF - Journal of polymer science : A, Polymer chemistry N2 - We report on the controlled free radical homopolymerization of 1-ferrocenylethyl acrylate as well as of three new ferrocene bearing monomers, namely 4-ferrocenylbutyl acrylate, 2-ferrocenylamido-2-methylpropyl acrylate, and 4-ferrocenylbutyl methacrylate, by the RAFT technique. For comparison, the latter monomer was polymerized using ATRP, too. The ferrocene containing monomers were found to be less reactive than their analogues free of ferrocene. The reasons for the low polymerizability are not entirely clear. As the addition of free ferrocene to the reaction mixture did not notably affect the polymerizations, sterical hindrance by the bulky ferrocene moiety fixed on the monomers seems to be the most probable explanation. Molar masses found for 1-ferrocenylethyl acrylate did not exceed 10,000 g mol(-1), while for 4-ferrocenylbutyl (meth) acrylate molar masses of 15,000 g mol(-1) could be obtained. With PDIs as low as 1.3 in RAFT polymerization of the monomers, good control over the polymerization was achieved. KW - ferrocene KW - living radical polymerization (LRP) KW - monomers KW - radical addition fragmentation chain transfer (RAFT) KW - radical polymerization KW - redox polymers KW - synthesis Y1 - 2012 U6 - https://doi.org/10.1002/pola.24994 SN - 0887-624X VL - 50 IS - 1 SP - 108 EP - 118 PB - Wiley-Blackwell CY - Malden ER - TY - JOUR A1 - de Molina, Paula Malo A1 - Ihlefeldt, Franziska Stefanie A1 - Prevost, Sylvain A1 - Herfurth, Christoph A1 - Appavou, Marie-Sousai A1 - Laschewsky, André A1 - Gradzielski, Michael T1 - Phase Behavior of Nonionic Microemulsions with Multi-end-capped Polymers and Its Relation to the Mesoscopic Structure JF - Langmuir N2 - The polymer architecture of telechelic or associative polymers has a large impact on the bridging of self-assembled structures. This Work presents: the phase behavior, small angle neutron scattering (SANS), dynamic light scattering (DLS), and fluorescence correlation spectroscopy (FCS) of a nonionic oil-in-water (O/W) microemulsion with hydrophobically end-capped multiarm polymers With functionalities f = 2, 3, and 4. For high polymer concentrations and large average interdroplet distance relative to the end-to-end distance of the polymer, d/R-ee; the system phase separates into a dense, highly connected droplet network phase, in equilibrium with a dilute phase. The extent of the two-phase region is larger for polymers With similar length but higher f. The Interaction potential between the droplets in the presence of polymer has both a repulsive and an attractive contribution as a result of the counterbalancing effects of the exclusion by polymer chains and bridging between droplets. This study experimentally demonstrates that higher polymer functionalities induce a stronger attractive force between droplets, which is responsible for a more extended phase separation region., and correlate with lower Collective droplet diffusivities and higher amplitude of the second relaxation time in DLS. The viscosity and the droplet self-diffusion obtained from FCS, however, are dominated by the end-capped chain concentration. Y1 - 2015 U6 - https://doi.org/10.1021/acs.langmuir.5b00817 SN - 0743-7463 VL - 31 IS - 18 SP - 5198 EP - 5209 PB - American Chemical Society CY - Washington ER - TY - JOUR A1 - Herfurth, Christoph A1 - de Molina, Paula Malo A1 - Wieland, Christoph A1 - Rogers, Sarah A1 - Gradzielski, Michael A1 - Laschewsky, André T1 - One-step RAFT synthesis of well-defined amphiphilic star polymers and their self-assembly in aqueous solution JF - Polymer Chemistry N2 - Multifunctional chain transfer agents for RAFT polymerisation were designed for the one-step synthesis of amphiphilic star polymers. Thus, hydrophobically end-capped 3- and 4-arm star polymers, as well as linear ones for reference, were made of the hydrophilic monomer N,N-dimethylacrylamide (DMA) in high yield with molar masses up to 150 000 g mol(-1), narrow molar mass distribution (PDI <= 1.2) and high end group functionality (similar to 90%). The associative telechelic polymers form transient networks of interconnected aggregates in aqueous solution, thus acting as efficient viscosity enhancers and rheology modifiers, eventually forming hydrogels. The combination of dynamic light scattering (DLS), small angle neutron scattering (SANS) and rheology experiments revealed that several molecular parameters control the structure and therefore the physical properties of the aggregates. In addition to the size of the hydrophilic block (maximum length for connection) and the length of the hydrophobic alkyl chain ends (stickiness), the number of arms (functionality) proved to be a key parameter. Y1 - 2012 U6 - https://doi.org/10.1039/c2py20126g SN - 1759-9954 VL - 3 IS - 6 SP - 1606 EP - 1617 PB - Royal Society of Chemistry CY - Cambridge ER -