TY - JOUR A1 - Jia, He A1 - Friebe, Christian A1 - Schubert, Ulrich S. A1 - Zhang, Xiaozhe A1 - Quan, Ting A1 - Lu, Yan A1 - Gohy, Jean-Francois T1 - Core-Shell Nanoparticles with a Redox Polymer Core and a Silica Porous Shell as High-Performance Cathode Material for Lithium-Ion Batteries JF - Energy technology : generation, conversion, storage, distribution N2 - A facile and novel method for the fabrication of core-shell nanoparticles (PTMA@SiO2) based on a poly(2,2,6,6-tetramethylpiperidinyloxy-4-yl methacrylate) (PTMA) core and a porous SiO2 shell is reported. The core-shell nanoparticles are further self-assembled with negatively charged multi-walled carbon nanotubes (MWCNTs), which results in the formation of a free-standing cathode electrode. The porous SiO2 shell not only effectively improves the stability of the linear PTMA redox polymer with low molar mass in organic electrolytes but also leads to the uniform dispersion of PTMA active units in the MWCNTs conductive network. The PTMA@SiO2@MWCNT composite electrode exhibits a specific capacity as high as 73.8 mAh g at 1 C and only 0.11% capacity loss per cycle at a rate of 2 C. KW - composite electrodes KW - core-shell nanoparticles KW - energy storage KW - lithium-ion batteries KW - redox polymers Y1 - 2019 U6 - https://doi.org/10.1002/ente.201901040 SN - 2194-4288 SN - 2194-4296 VL - 8 IS - 3 PB - Wiley-VCH CY - Weinheim ER - TY - JOUR A1 - Jia, He A1 - Quan, Ting A1 - Liu, Xuelian A1 - Bai, Lu A1 - Wang, Jiande A1 - Boujioui, Fadoi A1 - Ye, Ran A1 - Vald, Alexandru A1 - Lu, Yan A1 - Gohy, Jean-Francois T1 - Core-shell nanostructured organic redox polymer cathodes with superior performance JF - Nano Energy N2 - Core-shell nanoparticles stabilized by a cationic surfactant are prepared from the poly(2,2,6,6-tetra-methylpiperidinyloxy-4-yl methacrylate) redox polymer. The nanoparticles are further self-assembled with negatively charged reduced graphene oxide nanosheets and negatively charged mull-walled carbon nanotubes. This results in the formation of a free-standing cathode with a layered nanostructure and a high content of redox polymer that exhibits 100% utilization of the active substance with a measured capacity as high as 105 mAh/g based on the whole weight of the electrode. KW - Nanostructured KW - Redox polymer KW - Organic electrode KW - Lithium ion battery KW - Energy storage Y1 - 2019 U6 - https://doi.org/10.1016/j.nanoen.2019.103949 SN - 2211-2855 SN - 2211-3282 VL - 64 PB - Elsevier CY - Amsterdam ER - TY - JOUR A1 - Jia, He A1 - Gao, Haitao A1 - Mei, Shilin A1 - Kneer, Janosch A1 - Lin, Xianzhong A1 - Ran, Qidi A1 - Wang, Fuxian A1 - Palzer, Stefan A1 - Lu, Yan T1 - Cu2O@PNIPAM core-shell microgels as novel inkjet materials for the preparation of CuO hollow porous nanocubes gas sensing layers JF - Journal of materials chemistry : C, Materials for optical and electronic devices N2 - There has been long-standing interest in developing metal oxide-based sensors with high sensitivity, selectivity, fast response and low material consumption. Here we report for the first time the utilization of Cu2O@PNIPAM core-shell microgels with a nanocube-shaped core structure for construction of novel CuO gas sensing layers. The hybrid microgels show significant improvement in colloidal stability as compared to native Cu2O nanocubes. Consequently, a homogeneous thin film of Cu2O@PNIPAM nanoparticles can be engineered in a quite low solid content (1.5 wt%) by inkjet printing of the dispersion at an optimized viscosity and surface tension. Most importantly, thermal treatment of the Cu2O@PNIPAM microgels forms porous CuO nanocubes, which show much faster response to relevant trace NO2 gases than sensors produced from bare Cu2O nanocubes. This outcome is due to the fact that the PNIPAM shell can successfully hinder the aggregation of CuO nanoparticles during pyrolysis, which enables full utilization of the sensor layers and better access of the gas to active sites. These results point out great potential of such an innovative system as gas sensors with low cost, fast response and high sensitivity. Y1 - 2018 U6 - https://doi.org/10.1039/c8tc01995a SN - 2050-7526 SN - 2050-7534 VL - 6 IS - 27 SP - 7249 EP - 7256 PB - Royal Society of Chemistry CY - Cambridge ER - TY - GEN A1 - Kochovski, Zdravko A1 - Jia, He A1 - Lu, Yan T1 - Morphological study of microgel-based colloidal systems by cryogenic transmission electron microscopy (cryo-TEM) T2 - Abstracts of papers : joint conference / The Chemical Institute of Cananda, CIC, American Chemical Society, ACS Y1 - 2018 SN - 0065-7727 VL - 256 PB - American Chemical Society CY - Washington ER - TY - JOUR A1 - Khodeir, Miriam A1 - Ernould, Bruno A1 - Brassinne, Jeremy A1 - Ghiassinejad, Sina A1 - Jia, He A1 - Antoun, Sayed A1 - Friebe, Christian A1 - Schubert, Ulrich S. A1 - Kochovski, Zdravko A1 - Lu, Yan A1 - Van Ruymbeke, Evelyne A1 - Gohy, Jean-Francois T1 - Synthesis and characterisation of redox hydrogels based on stable nitroxide radicals JF - Soft matter N2 - The principle of encapsulation/release of a guest molecule from stimuli responsive hydrogels (SRHs) is mainly realised with pH, temperature or light stimuli. However, only a limited number of redox responsive hydrogels have been investigated so far. We report here the development of a SRH that can release its guest molecule upon a redox stimulus. To obtain this redox hydrogel, we have introduced into the hydrogel the 2,2,6,6-tetramethyl-1-piperidinyloxy (TEMPO) stable nitroxide radical, which can be reversibly oxidized into an oxoammonium cation (TEMPO+). Water solubility is provided by the presence of the (oligoethyleneglycol)methacrylate (OEGMA) comonomer. Electrochemical and mechanical characterization showed that those gels exhibit interesting physicochemical properties, making them very promising candidates for practical use in a wide range of applications. Y1 - 2019 U6 - https://doi.org/10.1039/c9sm00905a SN - 1744-683X SN - 1744-6848 VL - 15 IS - 31 SP - 6418 EP - 6426 PB - Royal Society of Chemistry CY - Cambridge ER -