TY - JOUR A1 - Kofod, Guggi A1 - Risse, Sebastian A1 - Stoyanov, Hristiyan A1 - McCarthy, Denis N. A1 - Sokolov, Sergey A1 - Krähnert, Ralph T1 - Broad-spectrum enhancement of polymer composite dielectric constant at ultra low volume fractions of silica-supported copper nanoparticles JF - ACS nano N2 - A new strategy for the synthesis of high permittivity polymer composites is demonstrated based on well-defined spatial distribution of ultralow amounts of conductive nanoparticles. The spatial distribution Was realized by immobilizing Cu nanoparticles within the pore system of Alia microspheres, preventing direct contact between individual Cu particles. Both Cu-loaded and unloaded silica microspheres were-then used as fillers in polymer composites prepared with thermoplastic SEBS rubber is the matrix. With a metallic Cu content of about 0.26 vol % In the compoilte, a relative increase of 94% In real permittivity was obtained. No Cu-induced relaxations were observed in the dielectric spectrum within the studied frequency range of 0.1 Hz to 1 MHz. When related to the amount of conductive nanoparticles, the obtained composites achieve the highest broad spectrum enhancement of permittivity ever reported for a polymer based composite. KW - nanocomposite KW - broad-spectrum permittivity enhancement KW - metal nanoparticles KW - uniform spatial arrangement Y1 - 2011 U6 - https://doi.org/10.1021/nn103097q SN - 1936-0851 VL - 5 IS - 3 SP - 1623 EP - 1629 PB - American Chemical Society CY - Washington ER - TY - JOUR A1 - Taubert, Andreas A1 - Leroux, Fabrice A1 - Rabu, Pierre A1 - de Zea Bermudez, Veronica T1 - Advanced hybrid nanomaterials JF - Beilstein journal of nanotechnology KW - colloidal chemistry KW - environmental remediation KW - hybrid nanomaterials KW - nanocomposite KW - nanofillers KW - nanomedicine KW - nanostructures KW - polymer fillers KW - pore templating KW - smart materials Y1 - 2019 U6 - https://doi.org/10.3762/bjnano.10.247 SN - 2190-4286 VL - 10 SP - 2563 EP - 2567 PB - Beilstein-Institut zur Förderung der Chemischen Wissenschaften CY - Frankfurt am Main ER - TY - JOUR A1 - Unuabonah, Emmanuel Iyayi A1 - Nöske, Robert A1 - Weber, Jens A1 - Günter, Christina A1 - Taubert, Andreas T1 - New micro/mesoporous nanocomposite material from low-cost sources for the efficient removal of aromatic and pathogenic pollutants from water JF - Beilstein journal of nanotechnology N2 - A new micro/mesoporous hybrid clay nanocomposite prepared from kaolinite clay, Carica papaya seeds, and ZnCl2 via calcination in an inert atmosphere is presented. Regardless of the synthesis temperature, the specific surface area of the nanocomposite material is between approximate to 150 and 300 m(2)/g. The material contains both micro- and mesopores in roughly equal amounts. X-ray diffraction, infrared spectroscopy, and solid-state nuclear magnetic resonance spectroscopy suggest the formation of several new bonds in the materials upon reaction of the precursors, thus confirming the formation of a new hybrid material. Thermogravimetric analysis/differential thermal analysis and elemental analysis confirm the presence of carbonaceous matter. The new composite is stable up to 900 degrees C and is an efficient adsorbent for the removal of a water micropollutant, 4-nitrophenol, and a pathogen, E. coli, from an aqueous medium, suggesting applications in water remediation are feasible. KW - 4-nitrophenol KW - Carica papaya seeds KW - clay KW - E. coli KW - micro/mesoporous KW - nanocomposite KW - water remediation Y1 - 2019 U6 - https://doi.org/10.3762/bjnano.10.11 SN - 2190-4286 VL - 10 SP - 119 EP - 131 PB - Beilstein-Institut zur Förderung der Chemischen Wissenschaften CY - Frankfurt, Main ER - TY - JOUR A1 - Pilar Yeste, Maria A1 - Carlos Hernandez-Garrido, Juan A1 - Kumke, Michael Uwe A1 - Alvarado, Sarah A1 - Cauqui, Miguel Angel A1 - Juan Calvino, Jose A1 - Primus, Philipp-Alexander T1 - Low-temperature growth of reactive pyrochlore nanostructures on Zirconia-supported ceria BT - implications for improved catalytic behavior JF - ACS applied nano materials N2 - The use of a catalyst support for the design of nanoscale heterogeneous catalysts based on cerium oxide offers vast possibilities for future catalyst development, particularly with regard to an increased focus on the use of renewable biogas and an emerging hydrogen economy. In this study, zirconia-supported ceria catalysts were synthesized, activated by using different thermochemical treatments, and characterized by way of temperature-programmed reduction (TPR), oxygen storage capacity, Xray diffraction, electron microscopy, and luminescence spectroscopy using Eu3+ as a spectroscopic probe. Through reduction-oxidation pretreatment routines, reactive pyrochlore structures were created at temperatures as low as 600 degrees C and identified through TPR and electron microscopy experiments. A structural relationship and alignment of the crystal planes is revealed in high-resolution scanning transmission electron microscopy experiments through the digital diffraction patterns. Low-temperature pretreatment induces the formation of reactive pyrochlore domains under retention of the surface area of the catalyst system, and no further morphological changes are detected. Furthermore, the formation of pyrochlore domains achieved through severe reduction and mild reoxidation (SRMO) treatments is reversible. Over multiple alternating SRMO and severe reduction and severe reoxidation (SRSO) treatments, europium spectroscopy and TPR results indicate that pyrochlore structures are recreated over consecutive treatments, whenever the mild oxidation step at 500 degrees C is the last treatment (SRMO, SRMO-SRSO-SRMO, etc.). KW - pyrochlore KW - nanocomposite KW - ceria KW - zirconia KW - supported catalyst KW - oxygen KW - storage capacity Y1 - 2022 U6 - https://doi.org/10.1021/acsanm.2c00416 SN - 2574-0970 VL - 5 IS - 5 SP - 6316 EP - 6326 PB - American Chemical Society CY - Washington ER - TY - JOUR A1 - He, Yushuang A1 - Wang, Feipeng A1 - He, Li A1 - Wang, Qiang A1 - Li, Jian A1 - Qian, Yihua A1 - Gerhard, Reimund A1 - Plath, Ronald T1 - An insight Into the role of Nano-Alumina on DC Flashover-Resistance and surface charge variation of Epoxy Nanocomposites JF - IEEE transactions on dielectrics and electrical insulation N2 - The addition of nano-Al2O3 has been shown to enhance the breakdown voltage of epoxy resin, but its flashover results appeared with disputation. This work concentrates on the surface charge variation and dc flashover performance of epoxy resin with nano-Al2O3 doping. The dispersion of nano-Al2O3 in epoxy is characterized by scanning electron microscopy (SEM) and atomic force microscopy (AFM). The dc flashover voltages of samples under either positive or negative polarity are measured with a finger-electrode system, and the surface charge variations before and after flashovers were identified from the surface potential mapping. The results evidence that nano-Al2O3 would lead to a 16.9% voltage drop for the negative flashovers and a 6.8% drop for positive cases. It is found that one-time flashover clears most of the accumulated surface charges, regardless of positive or negative. As a result, the ground electrode is neighbored by an equipotential zone enclosed with low-density heterocharges. The equipotential zone tends to be broadened after 20 flashovers. The nano-Al2O3 is noticed as beneficial to downsize the equipotential zone due to its capability on charge migration, which is reasonable to maintain flashover voltage at a high level after multiple flashovers. Hence, nano-Al2O3 plays a significant role in improving epoxy with high resistance to multiple flashovers. KW - surface morphology KW - Epoxy resins KW - Electric potential KW - Surface treatment KW - Doping KW - Epoxy resin KW - multiple KW - flashover KW - nanocomposite KW - surface charge Y1 - 2022 U6 - https://doi.org/10.1109/TDEI.2022.3173510 SN - 1070-9878 SN - 1558-4135 VL - 29 IS - 3 SP - 1022 EP - 1029 PB - Inst. of Electr. and Electronics Engineers CY - Piscataway ER -