TY - GEN A1 - Chaabene, Helmi A1 - Prieske, Olaf A1 - Lesinski, Melanie A1 - Sandau, Ingo A1 - Granacher, Urs T1 - Short-term seasonal development of anthropometry, body composition, physical fitness, and sport-specific performance in young olympic weightlifters T2 - Postprints der Universität Potsdam : Humanwissenschaftliche Reihe N2 - The aim of this study is to monitor short-term seasonal development of young Olympic weightlifters’ anthropometry, body composition, physical fitness, and sport-specific performance. Fifteen male weightlifters aged 13.2 ± 1.3 years participated in this study. Tests for the assessment of anthropometry (e.g., body-height, body-mass), body-composition (e.g., lean-body-mass, relative fat-mass), muscle strength (grip-strength), jump performance (drop-jump (DJ) height, countermovement-jump (CMJ) height, DJ contact time, DJ reactive-strength-index (RSI)), dynamic balance (Y-balance-test), and sport-specific performance (i.e., snatch and clean-and-jerk) were conducted at different time-points (i.e., T1 (baseline), T2 (9 weeks), T3 (20 weeks)). Strength tests (i.e., grip strength, clean-and-jerk and snatch) and training volume were normalized to body mass. Results showed small-to-large increases in body-height, body-mass, lean-body-mass, and lower-limbs lean-mass from T1-to-T2 and T2-to-T3 (∆0.7–6.7%; 0.1 ≤ d ≤ 1.2). For fat-mass, a significant small-sized decrease was found from T1-to-T2 (∆13.1%; d = 0.4) and a significant increase from T2-to-T3 (∆9.1%; d = 0.3). A significant main effect of time was observed for DJ contact time (d = 1.3) with a trend toward a significant decrease from T1-to-T2 (∆–15.3%; d = 0.66; p = 0.06). For RSI, significant small increases from T1-to-T2 (∆9.9%, d = 0.5) were noted. Additionally, a significant main effect of time was found for snatch (d = 2.7) and clean-and-jerk (d = 3.1) with significant small-to-moderate increases for both tests from T1-to-T2 and T2-to-T3 (∆4.6–11.3%, d = 0.33 to 0.64). The other tests did not change significantly over time (0.1 ≤ d ≤ 0.8). Results showed significantly higher training volume for sport-specific training during the second period compared with the first period (d = 2.2). Five months of Olympic weightlifting contributed to significant changes in anthropometry, body-composition, and sport-specific performance. However, hardly any significant gains were observed for measures of physical fitness. Coaches are advised to design training programs that target a variety of fitness components to lay an appropriate foundation for later performance as an elite athlete. T3 - Zweitveröffentlichungen der Universität Potsdam : Humanwissenschaftliche Reihe - 685 KW - strength KW - monitoring KW - young athletes KW - weight training KW - somatic variables KW - periodization KW - training load Y1 - 2021 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:kobv:517-opus4-472609 SN - 1866-8364 IS - 685 ER - TY - JOUR A1 - Chaabene, Helmi A1 - Prieske, Olaf A1 - Lesinski, Melanie A1 - Sandau, Ingo A1 - Granacher, Urs T1 - Short-Term Seasonal Development of Anthropometry, Body Composition, Physical Fitness, and Sport-Specific Performance in Young Olympic Weightlifters JF - Sports KW - strength KW - monitoring KW - young athletes KW - weight training KW - somatic variables KW - periodization KW - training load Y1 - 2019 U6 - https://doi.org/10.3390/sports7120242 SN - 2075-4663 VL - 7 IS - 12 PB - MDPI CY - Basel ER - TY - JOUR A1 - Sandau, Ingo A1 - Granacher, Urs T1 - Effects of the barbell load on the acceleration phase during the snatch in elite Olympic weightlifting JF - Sports N2 - The load-depended loss of vertical barbell velocity at the end of the acceleration phase limits the maximum weight that can be lifted. Thus, the purpose of this study was to analyze how increased barbell loads affect the vertical barbell velocity in the sub-phases of the acceleration phase during the snatch. It was hypothesized that the load-dependent velocity loss at the end of the acceleration phase is primarily associated with a velocity loss during the 1st pull. For this purpose, 14 male elite weightlifters lifted seven load-stages from 70-100% of their personal best in the snatch. The load-velocity relationship was calculated using linear regression analysis to determine the velocity loss at 1st pull, transition, and 2nd pull. A group mean data contrast analysis revealed the highest load-dependent velocity loss for the 1st pull (t = 1.85, p = 0.044, g = 0.49 [-0.05, 1.04]) which confirmed our study hypothesis. In contrast to the group mean data, the individual athlete showed a unique response to increased loads during the acceleration sub-phases of the snatch. With the proposed method, individualized training recommendations on exercise selection and loading schemes can be derived to specifically improve the sub-phases of the snatch acceleration phase. Furthermore, the results highlight the importance of single-subject assessment when working with elite athletes in Olympic weightlifting. KW - biomechanics KW - barbell velocity KW - performance KW - training KW - load-velocity KW - relationship Y1 - 2020 U6 - https://doi.org/10.3390/sports8050059 SN - 2075-4663 VL - 8 IS - 5 PB - MDPI CY - Basel ER - TY - GEN A1 - Sandau, Ingo A1 - Granacher, Urs T1 - Effects of the barbell load on the acceleration phase during the snatch in Olympic weightlifting T2 - Postprints der Universität Potsdam : Humanwissenschaftliche Reihe N2 - The load-depended loss of vertical barbell velocity at the end of the acceleration phase limits the maximum weight that can be lifted. Thus, the purpose of this study was to analyze how increased barbell loads affect the vertical barbell velocity in the sub-phases of the acceleration phase during the snatch. It was hypothesized that the load-dependent velocity loss at the end of the acceleration phase is primarily associated with a velocity loss during the 1st pull. For this purpose, 14 male elite weightlifters lifted seven load-stages from 70–100% of their personal best in the snatch. The load–velocity relationship was calculated using linear regression analysis to determine the velocity loss at 1st pull, transition, and 2nd pull. A group mean data contrast analysis revealed the highest load-dependent velocity loss for the 1st pull (t = 1.85, p = 0.044, g = 0.49 [−0.05, 1.04]) which confirmed our study hypothesis. In contrast to the group mean data, the individual athlete showed a unique response to increased loads during the acceleration sub-phases of the snatch. With the proposed method, individualized training recommendations on exercise selection and loading schemes can be derived to specifically improve the sub-phases of the snatch acceleration phase. Furthermore, the results highlight the importance of single-subject assessment when working with elite athletes in Olympic weightlifting. T3 - Zweitveröffentlichungen der Universität Potsdam : Humanwissenschaftliche Reihe - 681 KW - biomechanics KW - barbell velocity KW - performance KW - training KW - load–velocity relationship Y1 - 2020 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:kobv:517-opus4-471599 SN - 1866-8364 IS - 681 ER - TY - JOUR A1 - Sandau, Ingo A1 - Chaabene, Helmi A1 - Granacher, Urs T1 - Concurrent validity of barbell force measured from video-based barbell kinematics during the snatch in male elite weightlifters JF - PLOS ONE / Public Library of Science N2 - This study examined the concurrent validity of an inverse dynamic (force computed from barbell acceleration [reference method]) and a work-energy (force computed from work at the barbell [alternative method]) approach to measure the mean vertical barbell force during the snatch using kinematic data from video analysis. For this purpose, the acceleration phase of the snatch was analyzed in thirty male medal winners of the 2018 weightlifting World Championships (age: 25.2±3.1 years; body mass: 88.9±28.6 kg). Vertical barbell kinematics were measured using a custom-made 2D real-time video analysis software. Agreement between the two computational approaches was assessed using Bland-Altman analysis, Deming regression, and Pearson product-moment correlation. Further, principal component analysis in conjunction with multiple linear regression was used to assess whether individual differences related to the two approaches are due to the waveforms of the acceleration time-series data. Results indicated no mean difference (p > 0.05; d = −0.04) and an extremely large correlation (r = 0.99) between the two approaches. Despite the high agreement, the total error of individual differences was 8.2% (163.0 N). The individual differences can be explained by a multiple linear regression model (R2adj = 0.86) on principal component scores from the principal component analysis of vertical barbell acceleration time-series waveforms. Findings from this study indicate that the individual errors of force measures can be associated with the inverse dynamic approach. This approach uses vertical barbell acceleration data from video analysis that is prone to error. Therefore, it is recommended to use the work-energy approach to compute mean vertical barbell force as this approach did not rely on vertical barbell acceleration. KW - Acceleration KW - Linear regression analysis KW - Velocity KW - Principal component analysis KW - Kinematics KW - Motion KW - Scanning electron microscopy KW - Computer Software Y1 - 2021 U6 - https://doi.org/10.1371/journal.pone.0254705 SN - 1932-6203 VL - 16 IS - 7 PB - PLOS CY - San Francisco ER - TY - GEN A1 - Sandau, Ingo A1 - Chaabene, Helmi A1 - Granacher, Urs T1 - Concurrent validity of barbell force measured from video-based barbell kinematics during the snatch in male elite weightlifters T2 - Postprints der Universität Potsdam : Humanwissenschaftliche Reihe N2 - This study examined the concurrent validity of an inverse dynamic (force computed from barbell acceleration [reference method]) and a work-energy (force computed from work at the barbell [alternative method]) approach to measure the mean vertical barbell force during the snatch using kinematic data from video analysis. For this purpose, the acceleration phase of the snatch was analyzed in thirty male medal winners of the 2018 weightlifting World Championships (age: 25.2±3.1 years; body mass: 88.9±28.6 kg). Vertical barbell kinematics were measured using a custom-made 2D real-time video analysis software. Agreement between the two computational approaches was assessed using Bland-Altman analysis, Deming regression, and Pearson product-moment correlation. Further, principal component analysis in conjunction with multiple linear regression was used to assess whether individual differences related to the two approaches are due to the waveforms of the acceleration time-series data. Results indicated no mean difference (p > 0.05; d = −0.04) and an extremely large correlation (r = 0.99) between the two approaches. Despite the high agreement, the total error of individual differences was 8.2% (163.0 N). The individual differences can be explained by a multiple linear regression model (R2adj = 0.86) on principal component scores from the principal component analysis of vertical barbell acceleration time-series waveforms. Findings from this study indicate that the individual errors of force measures can be associated with the inverse dynamic approach. This approach uses vertical barbell acceleration data from video analysis that is prone to error. Therefore, it is recommended to use the work-energy approach to compute mean vertical barbell force as this approach did not rely on vertical barbell acceleration. T3 - Zweitveröffentlichungen der Universität Potsdam : Humanwissenschaftliche Reihe - 716 KW - Acceleration KW - Linear regression analysis KW - Velocity KW - Principal component analysis KW - Kinematics KW - Motion KW - Scanning electron microscopy KW - Computer Software Y1 - 2021 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:kobv:517-opus4-521678 SN - 1866-8364 IS - 716 ER -