@article{EvsevleevMishurovaCabezaetal.2018,
  author    = {Evsevleev, Sergei and Mishurova, Tatiana and Cabeza, Sandra and Koos, R. and Sevostianov, Igor and Garc{\´e}s, Gonzales and Requena, Guillermo and Fernandez, R. and Bruno, Giovanni},
  title     = {The role of intermetallics in stress partitioning and damage evolution of AlSil2CuMgNi alloy},
  series = {Materials Science and Engineering: A-Structural materials: properties, microstructure and processing},
  volume    = {736},
  journal   = {Materials Science and Engineering: A-Structural materials: properties, microstructure and processing},
  publisher = {Elsevier},
  address   = {Lausanne},
  issn      = {0921-5093},
  doi       = {10.1016/j.msea.2018.08.070},
  pages     = {453 -- 464},
  year      = {2018},
  abstract  = {Load partitioning between phases in a cast AlSi12CuMgNi alloy was investigated by in-situ compression test during neutron diffraction experiments. Computed tomography (CT) was used to determine volume fractions of eutectic Si and intermetallic (IM) phases, and to assess internal damage after ex-situ compression tests. The CT reconstructed volumes showed the interconnectivity of IM phases, which build a 3D network together with eutectic Si. Large stresses were found in IMs, revealing their significant role as a reinforcement for the alloy. An existing micromechanical model based on Maxwell scheme was extended to the present case, assuming the alloy as a three-phase composite (Al matrix, eutectic Si, IM phases). The model agrees well with the experimental data. Moreover, it allows predicting the principal stresses in each phase, while experiments can only determine stress differences between the axial and radial sample directions. Finally, we showed that the addition of alloying elements not only allowed developing a 3D interconnected network, but also improved the strength of the Al matrix, and the ability of the alloy constituents to bear mechanical load.},
  language  = {en}
}
@article{MishurovaArtztHaubrichetal.2018,
  author    = {Mishurova, Tatiana and Artzt, Katia and Haubrich, Jan and Requena, Guillermo and Bruno, Giovanni},
  title     = {New aspects about the search for the most relevant parameters optimizing SLM materials},
  series = {Additive manufacturing},
  volume    = {25},
  journal   = {Additive manufacturing},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {2214-8604},
  doi       = {10.1016/j.addma.2018.11.023},
  pages     = {325 -- 334},
  year      = {2018},
  abstract  = {While the volumetric energy density is commonly used to qualify a process parameter set, and to quantify its influence on the microstructure and performance of additively manufactured (AM) materials and components, it has been already shown that this description is by no means exhaustive. In this work, new aspects of the optimization of the selective laser melting process are investigated for AM Ti-6Al-4V. We focus on the amount of near-surface residual stress (RS), often blamed for the failure of components, and on the porosity characteristics (amount and spatial distribution). First, using synchrotron x-ray diffraction we show that higher RS in the subsurface region is generated if a lower energy density is used. Second, we show that laser de-focusing and sample positioning inside the build chamber also play an eminent role, and we quantify this influence. In parallel, using X-ray Computed Tomography, we observe that porosity is mainly concentrated in the contour region, except in the case where the laser speed is small. The low values of porosity (less than 1\%) do not influence RS.},
  language  = {en}
}