@article{SchoeneKratzSchulzetal.2016, author = {Sch{\"o}ne, Anne-Christin and Kratz, Karl and Schulz, Burkhard and Lendlein, Andreas}, title = {The relevance of hydrophobic segments in multiblock copolyesterurethanes for their enzymatic degradation at the air-water interface}, series = {Polymer : the international journal for the science and technology of polymers}, volume = {102}, journal = {Polymer : the international journal for the science and technology of polymers}, publisher = {Elsevier}, address = {Oxford}, issn = {0032-3861}, doi = {10.1016/j.polymer.2016.09.001}, pages = {92 -- 98}, year = {2016}, abstract = {The interplay of an enzyme with a multiblock copolymer PDLCL containing two segments of different hydrophilicity and degradability is explored in thin films at the air-water interface. The enzymatic degradation was studied in homogenous Langmuir monolayers, which are formed when containing more than 40 wt\% oligo(epsilon-caprolactone) (OCL). Enzymatic degradation rates were significantly reduced with increasing content of hydrophobic oligo(omega-pentadecalactone) (OPDL). The apparent deceleration of the enzymatic process is caused by smaller portion of water-soluble degradation fragments formed from degradable OCL fragments. Beside the film degradation, a second competing process occurs after adding lipase from Pseudomonas cepacia into the subphase, namely the enrichment of the lipase molecules in the polymeric monolayer. The incorporation of the lipase into the Langmuir film is experimentally revealed by concurrent surface area enlargement and by Brewster angle microscopy (BAM). Aside from the ability to provide information about the degradation behavior of polymers, the Langmuir monolayer degradation (LMD) approach enables to investigate polymer-enzyme interactions for non-degradable polymers. (C) 2016 Elsevier Ltd. All rights reserved.}, language = {en} } @article{SchoeneKratzSchulzetal.2016, author = {Sch{\"o}ne, Anne-Christin and Kratz, Karl and Schulz, Burkhard and Lendlein, Andreas}, title = {Polymer architecture versus chemical structure as adjusting tools for the enzymatic degradation of oligo(epsilon-caprolactone) based films at the air-water interface}, series = {Polymer Degradation and Stability}, volume = {131}, journal = {Polymer Degradation and Stability}, publisher = {Elsevier}, address = {Oxford}, issn = {0141-3910}, doi = {10.1016/j.polymdegradstab.2016.07.010}, pages = {114 -- 121}, year = {2016}, abstract = {The enzymatic degradation of oligo(epsilon-caprolactone) (OCL) based films at the air-water interface is investigated by Langmuir monolayer degradation (LMD) experiments to elucidate the influence of the molecular architecture and of the chemical structure on the chain scission process. For that purpose, the interactions of 2D monolayers of two star-shaped poly(epsilon-caprolactone)s (PCLs) and three linear OCL based copolyesterurethanes (P(OCL-U)) with the lipase from Pseudomonas cepacia are evaluated in comparison to linear OCL. While the architecture of star-shaped PCL Langmuir layers slightly influences their degradability compared to OCL films, significantly retarded degradations are observed for P(OCL-U) films containing urethane junction units derived from 2, 2 (4), 4-trimethyl hexamethylene diisocyanate (TMDI), hexamethylene diisocyanate (HDI) or lysine ethyl ester diisocyanate (LDI). The enzymatic degradation of the OCL based 2D structures is related to the presence of hydrophilic groups within the macromolecules rather than to the packing density of the film or to the molecular weight. The results reveal that the LMD technique allows the parallel analysis of both the film/enzyme interactions and the degradation process on the molecular level. (C) 2016 Elsevier Ltd. All rights reserved.}, language = {en} } @article{SarauliBorowskiPetersetal.2016, author = {Sarauli, David and Borowski, Anja and Peters, Kristina and Schulz, Burkhard and Fattakhova-Rohlfing, Dina and Leimk{\"u}hler, Silke and Lisdat, Fred}, title = {Investigation of the pH-Dependent Impact of Sulfonated Polyaniline on Bioelectrocatalytic Activity of Xanthine Dehydrogenase}, series = {ACS catalysis}, volume = {6}, journal = {ACS catalysis}, publisher = {American Chemical Society}, address = {Washington}, issn = {2155-5435}, doi = {10.1021/acscatal.6b02011}, pages = {7152 -- 7159}, year = {2016}, abstract = {We report on the pH-dependent bioelectrocatalytic activity of the redox enzyme xanthine dehydrogenase (XDH) in the presence of sulfonated polyaniline PMSA1 (poly(2-methoxyaniline-5-sulfonic acid)-co-aniline). Ultraviolet-visible (UV-vis) spectroscopic measurements with both components in solution reveal electron transfer from the hypoxanthine (HX)-reduced enzyme to the polymer. The enzyme shows bioelectrocatalytic activity on indium tin oxide (ITO) electrodes, when the polymer is present. Depending on solution pH, different processes can be identified. It can be demonstrated that not only product-based communication with the electrode but also efficient polymer-supported bioelectrocatalysis occur. Interestingly, substrate dependent catalytic currents can be obtained in acidic and neutral solutions, although the highest activity of XDH with natural reaction partners is in the alkaline region. Furthermore, operation of the enzyme electrode without addition of the natural cofactor of XDH is feasible. Finally, macroporous ITO electrodes have been used as an immobilization platform for the fabrication of HX-sensitive electrodes. The study shows that the efficient polymer/enzyme interaction can be advantageously combined with the open structure of an electrode material of controlled pore size, resulting in good processability, stability, and defined signal transfer in the presence of a substrate.}, language = {en} } @article{HamaciucBrumaKoepnicketal.2001, author = {Hamaciuc, E. and Bruma, Maria and K{\"o}pnick, Thomas and Kaminorz, Yvette and Schulz, Burkhard}, title = {Synthesis and Study of New Silicon-containing Polyoxadiazoles}, year = {2001}, abstract = {A series of new poly-1,3,4-oxadiazoles has been synthesized by polycondensation reaction of hydrazine sulfate with a mixture of a dicarboxylic acid containing unsaturated bonds and a dicarboxylic acid containing silicon, by using methanesulfonic acid/phosphorus pentoxide as a reaction medium. These polymers were highly thermostable but they were only soluble in strong inorganic acids such as sulfuric or methanesulfonic ones. An alternative way was followed by using the corresponding dihydrazides containing unsaturated bonds and the corresponding diacid chloride containing silicon that reacted in N-methylpyrrolidinone (NMP) to give soluble silicon-containing unsaturated polyhydrazides, which were cyclodehydrated either by thermal or chemical treatment to give the corresponding polyoxadiazoles. Very thin coatings of polyhydrazides and polyoxadiazoles were deposited onto silicon wafers and they showed a very smooth surface, free of pinholes, when studied by atomic force microscopy (AFM). Some polyoxadiazole films showed strong blue photoluminescence.}, language = {en} } @article{KaminorzSchulzBrehmer2000, author = {Kaminorz, Yvette and Schulz, Burkhard and Brehmer, Ludwig}, title = {Optical and Electrical Properties of Substituted 2,5-Diphenyl-1,3,4-Oxadiazoles}, year = {2000}, abstract = {New substituted 2,5-diphenyl-1,3,4-oxadiazoles are reported as luminescent materials in light emitting diodes LEDs . The investigated new oxadiazoles show efficient blue and green emission in single layer devices. The combination with a hole transporting and red emitting polythiophene led to a white emission with higher quantum efficiency (QE).}, language = {en} } @article{KarageorgievStillerPrescheretal.2000, author = {Karageorgiev, Peter and Stiller, Burkhard and Prescher, Dietrich and Dietzel, Birgit and Schulz, Burkhard and Brehmer, Ludwig}, title = {Modification of the surface potential of azobenzene-containing langmuir-blodgett films in the near field of a scanning kelvin microscope tip by irradiation}, year = {2000}, language = {en} } @article{GieblerSchulzReicheetal.1999, author = {Giebler, Rainer and Schulz, Burkhard and Reiche, J{\"u}rgen and Brehmer, Ludwig and W{\"u}hn, Mario and W{\"o}ll, Christoph and Smith, Andrew Phillip and Urquhart, Steven G. and Ade, Harald W. and Unger, Wolfgang E. S.}, title = {Near-edge x-ray absorption fine structure spectroscopy on ordered films of an amphiphilic derivate of 2,5- Diphenyl-1,3,4-oxadiazole}, year = {1999}, abstract = {The surfaces of ordered films formed from an amphiphilic derivative of 2,5-diphenyl-1,3,4-oxadiazole by the Langmuir-Blodgett (LB) technique and organic molecular beam deposition (OMBD) were investigated by the use of near-edge X-ray absorption fine structure (NEXAFS) spectroscopy. For the assignment of the spectral features of the C, N, and O K- edge absorption spectra, fingerprint spectra of poly(p-phenylene terephthalamide)(Kevlar), poly(ethylene terephthalate), poly(p-phenylene-1,3,4-oxadiazole), and 2,5-di- (pentadecyl)-1,3,4-oxadiazole, which contain related chemical moieties, were recorded. Ab initio molecular orbital calculations, performed with explicit treatment of the core hole, are used to support the spectral interpretations. Angle-resolved NEXAFS spectroscopy at the C, N, and O K-edges suggests a preferentially upright orientation of the oxadiazole derivative in the outermost layer of the films. X-ray specular reflectivity data and molecular modeling results suggest a similar interpretation.}, language = {en} } @article{BrumaSchulzKoepnicketal.1999, author = {Bruma, Maria and Schulz, Burkhard and K{\"o}pnick, Thomas and Stiller, Burkhard and Belomoina, Nataliya and Mercer, Frank W.}, title = {Synthesis and study of aromatic polyamides containing silicon and phenylquinoxaline rings in the main chain}, year = {1999}, abstract = {New poly(phenylquinoxaline-amide)s with silicon in the main chain have been prepared by polycondensation reaction of a diacid chloride, namely bis(p-chlorocarbonyl-phenyl)-diphenylsilane, with aromatic diamines containing one or two phenylquinoxaline rings separated by a flexible bridge such as ether or methylene. These polymers were easily soluble in polar aprotic solvents such as N-methylpyrrolidinone (NMP) and dimethylformamide (DMF) and showed high thermal stability with decomposition temperature being above 450°C and glass transition temperature in the range of 260- 304°C. Polymer solutions in NMP were processed into thin flexible films which exhibited very smooth surfaces, free of pinholes when studied by atomic force microscopy. The free-standing films showed a dielectric constant in the range of 3.6-3.7.}, language = {en} } @article{BrumaHamciucSchulzetal.1999, author = {Bruma, Maria and Hamciuc, Elena and Schulz, Burkhard and K{\"o}pnick, Thomas and Stiller, Burkhard and Mercer, Frank W.}, title = {Synthesis of fluorinated poly(phenylquinoxaline-amide)s and study of thin films made therefrom}, year = {1999}, abstract = {A series of five fluorinated poly(phenylquinoxaline-amide)s were synthesized by a polycondensation reaction of a diacid chloride containing the hexafluoroisopropylidene (6F) group, namely 2,2-bis(p-chlorocarbonylphenyl)- hexafluoropropane, with various aromatic diamines incorporating two phenyl-substituted quinoxaline rings. These polymers were easily soluble in polar aprotic solvents such as N-methylpyrrolione (NMP), dimethylformamide (DMF), and tetrahydrofurane (THF), and showed a high thermal stability with decomposition temperatures above 400 °C and glass transition temperatures in the range of 260-290 Tg. Polymer solutions in NMP were processed into free-standing films that showed low dielectric constant values, in the range of 3.4-3.9, and good mechanical properties, with tensile strength in the range of 40-80 MPa and elongation to break in the range of 22-55\%. Very thin films, in the range of tens of nanometer, which were deposited onto silicon wafers exhibited very smooth surfaces, free of pinholes when studied by atomic force microscopy (AFM).}, language = {en} } @article{BrumaSchulzKoepnicketal.1999, author = {Bruma, Maria and Schulz, Burkhard and K{\"o}pnick, Thomas and Stiller, Burkhard and Mercer, Frank W.}, title = {Study of thin films made from aromatic polyamides with silicon and phenylquinoxaline rings in the main chain}, year = {1999}, abstract = {Aromatic polyamides containing silicon and phenylquinoxaline rings in the main chain have been prepared by polycondensation reaction of a silicon-containing diacid chloride, namely bis(p-chlorocarbonylphenyl) -diphenylsilane, with various aromatic diamines having preformed phenylquinoxaline units. These polymers were easily soluble in polar aprotic solvents, such as N-methylpyrrolidinone (NMP) and dimethylformamide (DMF), and in tetrahydrofurane. They showed high thermal stability with decomposition temperature being above 450°C and glass transition temperature in the range of 253-304°C. Polymer solutions in NMP were processed into thin films having the thickness of tens of nanometer to 10 mm, by spin-coating onto glass plates or silicon wafers. The films had strong adhesion to substrates and exhibited very smooth surfaces, free of pinholes, in atomic force microscopy (AFM) studies. The free-standing films had dielectric constant in the range of 3.48-3.69. Thermal treatment of the films up to 350°C rendered them completely insoluble in organic solvents, while maintaining their smoothness and strong adhesion to the silicon substrate, and with no Tg in DSC experiments. Their FTIR spectra did not show any changes compared to the untreated films, meaning that polymers maintain their structural integrity at high temperature. {\´O} 1999 Elsevier Science S.A. All rights reserved.}, language = {en} }