@article{AlNajiSchlaadAntonietti2020, author = {Al-Naji, Majd and Schlaad, Helmut and Antonietti, Markus}, title = {New (and old) monomers from biorefineries to make polymer chemistry more sustainable}, series = {Macromolecular rapid communications}, volume = {42}, journal = {Macromolecular rapid communications}, number = {3}, publisher = {Wiley-VCH}, address = {Weinheim}, issn = {1022-1336}, doi = {10.1002/marc.202000485}, pages = {11}, year = {2020}, abstract = {This opinion article describes recent approaches to use the "biorefinery" concept to lower the carbon footprint of typical mass polymers, by replacing parts of the fossil monomers with similar or even the same monomer made from regrowing dendritic biomass. Herein, the new and green catalytic synthetic routes are for lactic acid (LA), isosorbide (IS), 2,5-furandicarboxylic acid (FDCA), and p-xylene (pXL). Furthermore, the synthesis of two unconventional lignocellulosic biomass derivable monomers, i.e., alpha-methylene-gamma-valerolactone (MeGVL) and levoglucosenol (LG), are presented. All those have the potential to enter in a cost-effective way, also the mass market and thereby recover lost areas for polymer materials. The differences of catalytic unit operations of the biorefinery are also discussed and the challenges that must be addressed along the synthesis path of each monomers.}, language = {en} } @article{HerfurthVollBulleretal.2012, author = {Herfurth, Christoph and Voll, Dominik and Buller, Jens and Weiss, Jan and Barner-Kowollik, Christopher and Laschewsky, Andr{\´e}}, title = {Radical addition fragmentation chain transfer (RAFT) polymerization of ferrocenyl (meth)acrylates}, series = {Journal of polymer science : A, Polymer chemistry}, volume = {50}, journal = {Journal of polymer science : A, Polymer chemistry}, number = {1}, publisher = {Wiley-Blackwell}, address = {Malden}, issn = {0887-624X}, doi = {10.1002/pola.24994}, pages = {108 -- 118}, year = {2012}, abstract = {We report on the controlled free radical homopolymerization of 1-ferrocenylethyl acrylate as well as of three new ferrocene bearing monomers, namely 4-ferrocenylbutyl acrylate, 2-ferrocenylamido-2-methylpropyl acrylate, and 4-ferrocenylbutyl methacrylate, by the RAFT technique. For comparison, the latter monomer was polymerized using ATRP, too. The ferrocene containing monomers were found to be less reactive than their analogues free of ferrocene. The reasons for the low polymerizability are not entirely clear. As the addition of free ferrocene to the reaction mixture did not notably affect the polymerizations, sterical hindrance by the bulky ferrocene moiety fixed on the monomers seems to be the most probable explanation. Molar masses found for 1-ferrocenylethyl acrylate did not exceed 10,000 g mol(-1), while for 4-ferrocenylbutyl (meth) acrylate molar masses of 15,000 g mol(-1) could be obtained. With PDIs as low as 1.3 in RAFT polymerization of the monomers, good control over the polymerization was achieved.}, language = {en} }