@phdthesis{Helpa2015, author = {Helpa, Vanessa}, title = {Interplay between mineral reaction and deformation via structural defects}, url = {http://nbn-resolving.de/urn:nbn:de:kobv:517-opus4-90332}, school = {Universit{\"a}t Potsdam}, pages = {x, 104}, year = {2015}, abstract = {This thesis contains three experimental studies addressing the interplay between deformation and the mineral reaction between natural calcite and magnesite. The solid-solid mineral reaction between the two carbonates causes the formation of a magnesio-calcite precursor layer and a dolomite reaction rim in every experiment at isostatic annealing and deformation conditions. CHAPTER 1 briefly introduces general aspects concerning mineral reactions in nature and diffusion pathways for mass transport. Moreover, results of previous laboratory studies on the influence of deformation on mineral reactions are summarized. In addition, the main goals of this study are pointed out. In CHAPTER 2, the reaction between calcite and magnesite single crystals is examined at isostatic annealing conditions. Time series performed at a fixed temperature revealed a diffusion-controlled dolomite rim growth. Two microstructural domains could be identified characterized by palisade-shaped dolomite grains growing into the magnesite and granular dolomite growing towards calcite. A model was provided for the dolomite rim growth based on the counter-diffusion of CaO and MgO. All reaction products exhibited a characteristic crystallographic relationship with respect to the calcite reactant. Moreover, kinetic parameters of the mineral reaction were determined out of a temperature series at a fixed time. The main goal of the isostatic test series was to gain information about the microstructure evolution, kinetic parameters, chemical composition and texture development of the reaction products. The results were used as a reference to quantify the influence of deformation on the mineral reaction. CHAPTER 3 deals with the influence of non-isostatic deformation on dolomite and magnesio-calcite layer production between calcite and magnesite single crystals. Deformation was achieved by triaxial compression and by torsion. Triaxial compression up to 38 MPa axial stress at a fixed time showed no significant influence of stress and strain on dolomite formation. Time series conducted at a fixed stress yield no change in growth rates for dolomite and magnesio-calcite at low strains. Slightly larger magnesio-calcite growth rates were observed at strains above >0.1. High strains at similar stresses were caused by the activation of additional glide systems in the calcite single crystal and more mobile dislocations in the magnesio-calcite grains, providing fast diffusion pathways. In torsion experiments a gradual decrease in dolomite and magnesio-calcite layer thickness was observed at a critical shear strain. During deformation, crystallographic orientations of reaction products rearranged with respect to the external framework. A direct effect of the mineral reaction on deformation could not be recognized due to the relatively small reaction product widths. In CHAPTER 4, the influence of starting material microfabrics and the presence of water on the reaction kinetics was evaluated. In these experimental series polycrystalline material was in contact with single crystals or two polycrystalline materials were used as reactants. Isostatic annealing resulted in different dolomite and magnesio-calcite layer thicknesses, depending on starting material microfabrics. The reaction progress at the magnesite interface was faster with smaller magnesite grain size, because grain boundaries provided fast pathways for diffusion and multiple nucleation sites for dolomite formation. Deformation by triaxial compression and torsion yield lower dolomite rim thicknesses compared to annealed samples for the same time. This was caused by grain coarsening of polycrystalline magnesite during deformation. In contrast, magnesio-calcite layers tended to be larger during deformation, which triggered enhanced diffusion along grain boundaries. The presence of excess water had no significant influence on the reaction kinetics, at least if the reactants were single crystals. In CHAPTER 5 general conclusions about the interplay between deformation and the mineral reaction in the carbonate system are presented. Finally, CHAPTER 6 highlights possible future work in the carbonate system based on the results of this study.}, language = {en} }