@article{WessigBehrendsKumkeetal.2016, author = {Wessig, Pablo and Behrends, Nicole and Kumke, Michael Uwe and Eisold, Ursula and Meiling, Til and Hille, Carsten}, title = {Two-photon FRET pairs based on coumarin and DBD dyes}, series = {RSC Advances}, volume = {6}, journal = {RSC Advances}, publisher = {Royal Society of Chemistry}, address = {Cambridge}, issn = {2046-2069}, doi = {10.1039/c6ra03983a}, pages = {33510 -- 33513}, year = {2016}, abstract = {The synthesis and photophysical properties of two new FRET pairs based on coumarin as a donor and DBD dye as an acceptor are described. The introduction of a bromo atom dramatically increases the two-photon excitation (2PE) cross section providing a 2PE-FRET system, which is also suitable for 2PE-FLIM.}, language = {en} } @article{WessigSchulzePfennigetal.2017, author = {Wessig, Pablo and Schulze, Tanja and Pfennig, Alexandra and Weidner, Steffen M. and Prentzel, Sascha and Schlaad, Helmut}, title = {Thiol-ene polymerization of oligospiroketal rods}, series = {Polymer Chemistry}, volume = {8}, journal = {Polymer Chemistry}, publisher = {Royal Society of Chemistry}, address = {Cambridge}, issn = {1759-9954}, doi = {10.1039/c7py01569k}, pages = {6879 -- 6885}, year = {2017}, abstract = {The nucleophilic thiol-ene (thia-Michael) reaction between molecular rods bearing terminal thiols and bis-maleimides was investigated. The molecular rods have oligospiroketal (OSK) and oligospirothioketal (OSTK) backbones. Contrary to the expectations, cyclic oligomers were always obtained instead of linear rigid-rod polymers. Replacing the OS(T)K rods with a flexible chain yielded polymeric products, suggesting that the OS(T) K structure is responsible for the formation of cyclic products. The reason for the preferred formation of cyclic products is due to the presence of folded conformations, which have already been described for articulated rods.}, language = {en} } @article{WessigMatthesPick2011, author = {Wessig, Pablo and Matthes, Annika and Pick, Charlotte}, title = {The photo-dehydro-Diels-Alder (PDDA) reaction}, series = {Organic \& biomolecular chemistry : an international journal of synthetic, physical and biomolecular organic chemistry}, volume = {9}, journal = {Organic \& biomolecular chemistry : an international journal of synthetic, physical and biomolecular organic chemistry}, number = {22}, publisher = {Royal Society of Chemistry}, address = {Cambridge}, issn = {1477-0520}, doi = {10.1039/c1ob06066j}, pages = {7599 -- 7605}, year = {2011}, abstract = {The photo-dehydro-Diels-Alder (PDDA) reaction is a valuable extension of the classical Diels-Alder (DA) reaction. The PDDA reaction differs from the DA reaction by the replacement of one of the C-C-double bonds of the diene moiety by a C-C triple bond and by the photochemical triggering of the reaction. This entails that, in contrast to the DA reaction, the PDDA reaction proceeds according to a multistage mechanism with biradicals and cycloallenes as intermediates. The PDDA reaction provides access to a considerable variety of compound classes. For example, 1-phenylnaphthlenes, 1,1'-binaphthyls, N-heterocyclic biaryls, and naphthalenophanes could be obtained by this reaction.}, language = {en} } @article{TechenCzaplaMoellnitzetal.2013, author = {Techen, Anne and Czapla, Sylvia and M{\"o}llnitz, Kristian and Budach, Dennis B. and Wessig, Pablo and Kumke, Michael Uwe}, title = {Synthesis and spectroscopic characterization of fluorophore-labeled oligospiroketal rods}, series = {Helvetica chimica acta}, volume = {96}, journal = {Helvetica chimica acta}, number = {11}, publisher = {Wiley-VCH}, address = {Weinheim}, issn = {0018-019X}, doi = {10.1002/hlca.201200616}, pages = {2046 -- 2067}, year = {2013}, abstract = {Fluorescence probes consisting of well-established fluorophores in combination with rigid molecular rods based on spirane-type structures were investigated with respect to their fluorescence properties under different solvent conditions. The attachment of the dyes was accomplished by 1,3-dipolar cycloaddition between alkynes and azides (click' reaction) and is a prime example for a novel class of sensor constructs. Especially, the attachment of two (different) fluorophores on opposite sides of the molecular rods paves the way to new sensor systems with less bulky (compared to the conventional DNA- or protein-based concepts), nevertheless rigid spacer constructs, e.g., for FRET-based sensing applications. A detailed photophysical characterization was performed in MeOH (and in basic H2O/MeOH mixtures) for i) rod constructs containing carboxyfluorescein, ii) rod constructs containing carboxyrhodamine, iii) rod constructs containing both carboxyfluorescein and carboxyrhodamine, and iv) rod constructs containing both pyrene and perylene parts. For each dye (pair), two rod lengths with different numbers of spirane units were synthesized and investigated. The rod constructs were characterized in ensemble as well as single-molecule fluorescence experiments with respect to i) specific roddye and ii) dyedye interactions. In addition to MeOH and MeOH/NaOH, the rod constructs were also investigated in micellar systems, which were chosen as a simplified model for membranes.}, language = {en} } @article{MertensHilschHaralampievetal.2018, author = {Mertens, Monique and Hilsch, Malte and Haralampiev, Ivan and Volkmer, Rudolf and Wessig, Pablo and M{\"u}ller, Peter}, title = {Synthesis and characterization of a new Bifunctionalized, Fluorescent, and Amphiphilic molecule for recruiting SH-Containing molecules to membranes}, series = {ChemBioChem}, volume = {19}, journal = {ChemBioChem}, number = {15}, publisher = {Wiley-VCH}, address = {Weinheim}, issn = {1439-4227}, doi = {10.1002/cbic.201800268}, pages = {1643 -- 1647}, year = {2018}, abstract = {This study describes the synthesis and characterization of an amphiphilic construct intended to recruit SH-containing molecules to membranes. The construct consists of 1)an aliphatic chain to enable anchoring within membranes, 2)a maleimide moiety to react with the sulfhydryl group of a soluble (bio)molecule, and 3)a fluorescence moiety to allow the construct to be followed by fluorescence spectroscopy and microscopy. It is shown that the construct can be incorporated into preformed membranes, thus allowing application of the approach with biological membranes. The close proximity between the fluorophore and the maleimide moiety within the construct causes fluorescence quenching. This allows monitoring of the reaction with SH-containing molecules by measurement of increases in fluorescence intensity and lifetime. Notably, the construct distributes into laterally ordered membrane domains of lipid vesicles, which is probably triggered by the length of its membrane anchor. The advantages of the new construct can be employed for several biological, biotechnological, and medicinal applications.}, language = {en} } @article{WessigJohnSperlichetal.2020, author = {Wessig, Pablo and John, Leonard and Sperlich, Eric and Kelling, Alexandra}, title = {Sulfur tuning of [1,3]-dioxolo[4.5-f]benzodioxole (DBD) fluorescent dyes}, series = {European journal of organic chemistry}, volume = {2021}, journal = {European journal of organic chemistry}, number = {3}, publisher = {Wiley-VCH}, address = {Weinheim}, issn = {1434-193X}, doi = {10.1002/ejoc.202001418}, pages = {499 -- 511}, year = {2020}, abstract = {The replacement of oxygen by sulfur atoms of [1,3]-dioxolo[4.5-f]benzodioxole (DBD) fluorescent dyes is an efficient way to adjust the photophysical properties (sulfur tuning). While previously developed S-4-DBD dyes exhibit considerably red-shifted absorption and emission wavelength, the heavy atom effect of four sulfur atoms cause low fluorescence quantum yields and short fluorescence lifetimes. Herein, we demonstrate that the replacement of less than four sulfur atoms (S-1-DBD, 1,2-S-2-DBD, and 1,4-S-2-DBD dyes) permits a fine-tuning of the photophysical properties. In some cases, a similar influence on the wavelength without the detrimental effect on the quantum yields and lifetimes is observed. Furthermore, the synthetic accessibility of S-1- and S-2-DBD dyes is improved, compared with S-4-DBD dyes. For coupling with biomolecules a series of reactive derivatives of the new dyes were developed (azides, OSu esters, alkynes, maleimides).}, language = {en} } @article{WessigBadetkoCzarneckietal.2022, author = {Wessig, Pablo and Badetko, Dominik and Czarnecki, Maciej and Wichterich, Lukas and Schmidt, Peter and Brudy, Cosima and Sperlich, Eric and Kelling, Alexandra}, title = {Studies toward the total synthesis of arylnaphthalene lignans via a Photo-Dehydro-Diels-Alder (PDDA) reaction}, series = {The journal of organic chemistry}, volume = {87}, journal = {The journal of organic chemistry}, number = {9}, publisher = {American Chemical Society}, address = {Washington}, issn = {0022-3263}, doi = {10.1021/acs.joc.2c00195}, pages = {5904 -- 5915}, year = {2022}, abstract = {An efficient method for the preparation of arylnaphthalene lignans (ANLs) was developed, which is based on thePhoto-Dehydro-DIELS-ALDER(PDDA) reaction. While intermolecular PDDA reactions turned out to be inefficient, theintramolecular variant using suberic acid as tether linking two aryl propiolic esters smoothly provided naphthalenophanes. Theirradiations were performed with a previously developed annular continuous-flow reactor and UVB lamps. In this way, the naturalproducts Alashinol D, Taiwanin C, and an unnamed ANL could be prepared.}, language = {en} } @article{GrimmMeyerCzaplaetal.2013, author = {Grimm, Christiane and Meyer, Thomas and Czapla, Sylvia and Nikolaus, J{\"o}rg and Scheidt, Holger A. and Vogel, Alexander and Herrmann, Andreas and Wessig, Pablo and Huster, Daniel and M{\"u}ller, Peter}, title = {Structure and dynamics of molecular rods in membranes application of a Spin-Labeled rod}, series = {Chemistry - a European journal}, volume = {19}, journal = {Chemistry - a European journal}, number = {8}, publisher = {Wiley-VCH}, address = {Weinheim}, issn = {0947-6539}, doi = {10.1002/chem.201202500}, pages = {2703 -- 2710}, year = {2013}, abstract = {Molecular rods consisting of a hydrophobic backbone and terminally varying functional groups have been synthesized for applications for the functionalization of membranes. In the present study, we employ a spin-labeled analogue of a recently described new class of molecular rods to characterize their dynamic interactions with membranes. By using the different approaches of ESR and NMR spectroscopy, we show that the spin moiety of the membrane-embedded spin-labeled rod is localized in the upper chain/glycerol region of membranes of different compositions. The rod is embedded within the membrane in a tilted orientation to adjust for the varying hydrophobic thicknesses of these bilayers. This orientation does not perturb the membrane structure. The water solubility of the rod is increased significantly in the presence of certain cyclodextrins. These cyclodextrins also allow the rods to be extracted from the membrane and incorporated into preformed membranes. The latter will improve the future applications of these rods in cellular systems as stable membrane-associated anchors for the functionalization of membrane surfaces.}, language = {en} } @article{CzarneckiWessig2018, author = {Czarnecki, Maciej and Wessig, Pablo}, title = {Scaling Up UV-Mediated Intramolecular Photodehydro-Diels-Alder Reactions Using a Homemade High-Performance Annular Continuous-Flow Reactor}, series = {Organic Process Research \& Development}, volume = {22}, journal = {Organic Process Research \& Development}, number = {12}, publisher = {American Chemical Society}, address = {Washington}, issn = {1083-6160}, doi = {10.1021/acs.oprd.8b00353}, pages = {1823 -- 1827}, year = {2018}, abstract = {Here we present a self-made annular continuous-flow reactor that can be used in the UV/vis range in an internal numbering-up manner. As a model reaction, we chose a powerful batch-scale-limited benzoannelation method, namely, an intramolecular photodehydro-Diels-Alder (IMPDDA) reaction. The scale-up potential of this particular photochemical benchmark reaction toward the preparation of macrocylic (1,7)naphthalenophanes by variation of selected flow parameters is presented.}, language = {en} } @article{StorchMaierWessigetal.2016, author = {Storch, Golo and Maier, Frank and Wessig, Pablo and Trapp, Oliver}, title = {Rotational Barriers of Substituted BIPHEP Ligands: A Comparative Experimental and Theoretical Study}, series = {European journal of organic chemistry}, volume = {22}, journal = {European journal of organic chemistry}, publisher = {Wiley-VCH}, address = {Weinheim}, issn = {1434-193X}, doi = {10.1002/ejoc.201600836}, pages = {5123 -- 5126}, year = {2016}, abstract = {The interconversion barriers of 14 different 3,3- and 5,5-disubstituted tropos BIPHEP [2,2-bis(diphenylphosphino)-1,1-biphenyl] and BIPHEP(O) [2,2-bis(diphenylphosphoryl)-1,1-biphenyl] ligands were investigated by enantioselective dynamic high performance liquid chromatography (DHPLC) and DFT calculations using the B3LYP/6-31G* and M06-2X/6-31G* levels of theory. The experimentally determined enantiomerization barriers varied from 86.8 to 101.4 kJmol(-1) and were found to be in excellent agreement with the calculated data. The root-mean-square deviations are 7.3 kJmol(-1) for the B3LYP functional and 11.3 kJmol(-1) for the M06-2X method.}, language = {en} }