@article{LippoldEidnerKumkeetal.2017,
  author    = {Lippold, Holger and Eidner, Sascha and Kumke, Michael Uwe and Lippmann-Pipke, Johanna},
  title     = {Dynamics of metal-humate complexation equilibria as revealed by isotope exchange studies - a matter of concentration and time},
  series = {Geochimica et cosmochimica acta : journal of the Geochemical Society and the Meteoritical Society},
  volume    = {197},
  journal   = {Geochimica et cosmochimica acta : journal of the Geochemical Society and the Meteoritical Society},
  publisher = {Elsevier},
  address   = {Oxford},
  issn      = {0016-7037},
  doi       = {10.1016/j.gca.2016.10.019},
  pages     = {62 -- 70},
  year      = {2017},
  abstract  = {Complexation with dissolved humic matter can be crucial in controlling the mobility of toxic or radioactive contaminant metals. For speciation and transport modelling, a dynamic equilibrium process is commonly assumed, where association and dissociation run permanently. This is, however, questionable in view of reported observations of a growing resistance to dissociation over time. In this study, the isotope exchange principle was employed to gain direct insight into the dynamics of the complexation equilibrium, including kinetic inertisation phenomena. Terbium(III), an analogue of trivalent actinides, was used as a representative of higher-valent metals. Isotherms of binding to (flocculated) humic acid, determined by means of Tb-160 as a radiotracer, were found to be identical regardless of whether the radioisotope was introduced together with the bulk of stable Tb-159 or subsequently after pre-equilibration for up to 3 months. Consequently, there is a permanent exchange of free and humic-bound Tb since all available binding sites are occupied in the plateau region of the isotherm. The existence of a dynamic equilibrium was thus evidenced. There was no indication of an inertisation under these experimental conditions. If the small amount of Tb-160 was introduced prior to saturation with Tb-159, the expected partial desorption of Tb-160 occurred at much lower rates than observed for the equilibration process in the reverse procedure. In addition, the rates decreased with time of pre-equilibration. Inertisation phenomena are thus confined to the stronger sites of humic molecules (occupied at low metal concentrations). Analysing the time-dependent course of isotope exchange according to first-order kinetics indicated that up to 3 years are needed to attain equilibrium. Since, however, metal-humic interaction remains reversible, exchange of metals between humic carriers and mineral surfaces cannot be neglected on the long time scale to be considered in predictive transport models.},
  language  = {en}
}
@misc{TaubertBalischewskiHentrichetal.2017,
  author    = {Taubert, Andreas and Balischewski, Christian and Hentrich, Doreen and Elschner, Thomas and Eidner, Sascha and G{\"u}nter, Christina and Behrens, Karsten and Heinze, Thomas},
  title     = {Water-soluble cellulose derivatives are sustainable additives for biomimetic calcium phosphate mineralization},
  url       = {http://nbn-resolving.de/urn:nbn:de:kobv:517-opus4-400453},
  pages     = {17},
  year      = {2017},
  abstract  = {The effect of cellulose-based polyelectrolytes on biomimetic calcium phosphate mineralization is described. Three cellulose derivatives, a polyanion, a polycation, and a polyzwitterion were used as additives. Scanning electron microscopy, X-ray diffraction, IR and Raman spectroscopy show that, depending on the composition of the starting solution, hydroxyapatite or brushite precipitates form. Infrared and Raman spectroscopy also show that significant amounts of nitrate ions are incorporated in the precipitates. Energy dispersive X-ray spectroscopy shows that the Ca/P ratio varies throughout the samples and resembles that of other bioinspired calcium phosphate hybrid materials. Elemental analysis shows that the carbon (i.e., polymer) contents reach 10\% in some samples, clearly illustrating the formation of a true hybrid material. Overall, the data indicate that a higher polymer concentration in the reaction mixture favors the formation of polymer-enriched materials, while lower polymer concentrations or high precursor concentrations favor the formation of products that are closely related to the control samples precipitated in the absence of polymer. The results thus highlight the potential of (water-soluble) cellulose derivatives for the synthesis and design of bioinspired and bio-based hybrid materials.},
  language  = {en}
}