@article{SchwarzeRiemer2020, author = {Schwarze, Thomas and Riemer, Janine}, title = {Highly K+ selective probes with fluorescence emission wavelengths higher than 500 nm in water}, series = {ChemistrySelect}, volume = {5}, journal = {ChemistrySelect}, number = {42}, publisher = {Wiley-VCH}, address = {Weinheim}, issn = {2365-6549}, doi = {10.1002/slct.202003785}, pages = {13174 -- 13178}, year = {2020}, abstract = {Herein, we report on the synthesis of highly K+/Na+ selective fluorescent probes in a feasible number of synthetic steps. These K+ selective fluorescent probes, so called fluoroionophores, 1 and 2 consists of different highly K+/Na+ selective building blocks the alkoxy-substituted N-phenylaza-18-crown-6 lariat ethers (ionophores) and "green" (cf. coumarin unit in 1) or "red" (cf. nile red unit in 2) fluorescent moieties (fluorophores). The fluorescent probes 1 and 2 show K+ induced fluorescence enhancement factors of 4.1 for 1 and 1.9 for 2 and dissociation constants for the corresponding K+ complexes of 43 mM (1+K+) and 18 mM (2+K+) in buffered aqueous solution. The fluorescence signal of 1 and 2 is changed by less than 5 \% by pH values in the range of 6.8 to 8.8. Thus, 1 and 2 are capable fluorescent tools to determine extracellular K+ levels by fluorescence enhancements at wavelengths higher than 500 nm.}, language = {en} } @phdthesis{Qin2019, author = {Qin, Qing}, title = {Chemical functionalization of porous carbon-based materials to enable novel modes for efficient electrochemical N2 fixation}, doi = {10.25932/publishup-44339}, url = {http://nbn-resolving.de/urn:nbn:de:kobv:517-opus4-443397}, school = {Universit{\"a}t Potsdam}, pages = {146}, year = {2019}, abstract = {The central motivation of the thesis was to provide possible solutions and concepts to improve the performance (e.g. activity and selectivity) of electrochemical N2 reduction reaction (NRR). Given that porous carbon-based materials usually exhibit a broad range of structural properties, they could be promising NRR catalysts. Therefore, the advanced design of novel porous carbon-based materials and the investigation of their application in electrocatalytic NRR including the particular reaction mechanisms are the most crucial points to be addressed. In this regard, three main topics were investigated. All of them are related to the functionalization of porous carbon for electrochemical NRR or other electrocatalytic reactions. In chapter 3, a novel C-TixOy/C nanocomposite has been described that has been obtained via simple pyrolysis of MIL-125(Ti). A novel mode for N2 activation is achieved by doping carbon atoms from nearby porous carbon into the anion lattice of TixOy. By comparing the NRR performance of M-Ts and by carrying out DFT calculations, it is found that the existence of (O-)Ti-C bonds in C-doped TixOy can largely improve the ability to activate and reduce N2 as compared to unoccupied OVs in TiO2. The strategy of rationally doping heteroatoms into the anion lattice of transition metal oxides to create active centers may open many new opportunities beyond the use of noble metal-based catalysts also for other reactions that require the activation of small molecules as well. In chapter 4, a novel catalyst construction composed of Au single atoms decorated on the surface of NDPCs was reported. The introduction of Au single atoms leads to active reaction sites, which are stabilized by the N species present in NDPCs. Thus, the interaction within as-prepared AuSAs-NDPCs catalysts enabled promising performance for electrochemical NRR. For the reaction mechanism, Au single sites and N or C species can act as Frustrated Lewis pairs (FLPs) to enhance the electron donation and back-donation process to activate N2 molecules. This work provides new opportunities for catalyst design in order to achieve efficient N2 fixation at ambient conditions by utilizing recycled electric energy. The last topic described in chapter 5 mainly focused on the synthesis of dual heteroatom-doped porous carbon from simple precursors. The introduction of N and B heteroatoms leads to the construction of N-B motives and Frustrated Lewis pairs in a microporous architecture which is also rich in point defects. This can improve the strength of adsorption of different reactants (N2 and HMF) and thus their activation. As a result, BNC-2 exhibits a desirable electrochemical NRR and HMF oxidation performance. Gas adsorption experiments have been used as a simple tool to elucidate the relationship between the structure and catalytic activity. This work provides novel and deep insights into the rational design and the origin of activity in metal-free electrocatalysts and enables a physically viable discussion of the active motives, as well as the search for their further applications. Throughout this thesis, the ubiquitous problems of low selectivity and activity of electrochemical NRR are tackled by designing porous carbon-based catalysts with high efficiency and exploring their catalytic mechanisms. The structure-performance relationships and mechanisms of activation of the relatively inert N2 molecules are revealed by either experimental results or DFT calculations. These fundamental understandings pave way for a future optimal design and targeted promotion of NRR catalysts with porous carbon-based structure, as well as study of new N2 activation modes.}, language = {en} } @misc{MondalDeyBaburinetal.2013, author = {Mondal, Suvendu Sekhar and Dey, Subarna and Baburin, Igor A. and Kelling, Alexandra and Schilde, Uwe and Seifert, Gotthard and Janiak, Christoph and Holdt, Hans-J{\"u}rgen}, title = {Syntheses of two imidazolate-4-amide-5-imidate linker-based hexagonal metal-organic frameworks with flexible ethoxy substituent}, url = {http://nbn-resolving.de/urn:nbn:de:kobv:517-opus4-94360}, pages = {9394 -- 9399}, year = {2013}, abstract = {A rare example of in situ linker generation with the formation of soft porous Zn- and Co-MOFs (IFP-9 and -10, respectively) is reported. The flexible ethoxy groups of IFP-9 and -10 protrude into the 1D hexagonal channels. The gas-sorption behavior of both materials for H2, CO2 and CH4 showed wide hysteretic isotherms, typical for MOFs having a flexible substituent which can give rise to a gate effect.}, language = {en} } @misc{RoesslerBomhoffHaschkeetal.2011, author = {R{\"o}ssler, Patrick and Bomhoff, Jana and Haschke, Josef Ferdinand and Kersten, Jan and M{\"u}ller, R{\"u}diger}, title = {Selection and impact of press photography}, series = {Postprints der Universit{\"a}t Potsdam : Philosophische Reihe}, journal = {Postprints der Universit{\"a}t Potsdam : Philosophische Reihe}, number = {103}, issn = {1866-8380}, url = {http://nbn-resolving.de/urn:nbn:de:kobv:517-opus4-93694}, pages = {25}, year = {2011}, abstract = {The selection of 'good' pictures has increasingly become a crucial factor when transmitting news to the recipients. Every day thousands of events are happening and millions of pictures are taken. By choosing photographs for newspapers and magazines, photographic editorial departments want to attract the recipients' attention, evoke emotions and get them to read their stories. But what exactly is a good picture that meets these expectations? Which criteria are decisive for selecting pictures and what effects of this selection can be measured on the recipients' side? This article presents the results of a research project carried out at the University of Erfurt in 2008 and conducted in collaboration with the German weekly magazine stern. It deals with the selection and impact of press photography by introducing the concept 'photo news factors'. Applying the traditional news value theory to pictures, photo news factors are defined as selection criteria that, on the part of the communicator, decide whether the press photos are worth publishing. Furthermore, they are assumed to exert an influence on the intensity of attention that a picture arouses.}, language = {en} } @phdthesis{Beyvers2008, author = {Beyvers, Stephanie}, title = {Selective excitation of adsorbate vibrations on dissipative surfaces}, url = {http://nbn-resolving.de/urn:nbn:de:kobv:517-opus-25516}, school = {Universit{\"a}t Potsdam}, year = {2008}, abstract = {The selective infrared (IR) excitation of molecular vibrations is a powerful tool to control the photoreactivity prior to electronic excitation in the ultraviolet / visible (UV/Vis) light regime ("vibrationally mediated chemistry"). For adsorbates on surfaces it has been theoretically predicted that IR preexcitation will lead to higher UV/Vis photodesorption yields and larger cross sections for other photoreactions. In a recent experiment, IR-mediated desorption of molecular hydrogen from a Si(111) surface on which atomic hydrogen and deuterium were co-adsorbed was achieved, following a vibrational mechanism as indicated by the isotope-selectivity. In the present work, selective vibrational IR excitation of adsorbate molecules, treated as multi-dimensional oscillators on dissipative surfaces, has been simulated within the framework of open-system density matrix theory. Not only potential-mediated, inter-mode coupling poses an obstacle to selective excitation but also the coupling of the adsorbate ("system") modes to the electronic and phononic degrees of freedom of the surface ("bath") does. Vibrational relaxation thereby takes place, depending on the availabilty of energetically fitting electron-hole (e/h) pairs and/or phonons (lattice vibrations) in the surface, on time-scales ranging from milliseconds to several hundreds of femtoseconds. On metal surfaces, where the relaxation process of the adsorbate via the e/h pair mechanism dominates, vibrational lifetimes are usually shorter than on insulator or semiconductor surfaces, in the range of picoseconds, being also the timescale of the IR pulses used here. Further inhibiting factors for selectivity can be the harmonicity of a mode and weak dipole activities ("dark modes") rendering vibrational excitation with moderate field intensities difficult. In addition to simple analytical pulses, optimal control theory (OCT) has been employed here to generate a suitable electric field to populate the target state/mode maximally. The complex OCT fields were analyzed by Husimi transformation, resolving the control field in time and energy. The adsorbate/surface systems investigated were CO/Cu(100), H/Si(100) and 2H/Ru(0001). These systems proved to be suitable models to study the above mentioned effects. Further, effects of temperature, pure dephasing (elastic scattering processes), pulse duration and dimensionality (up to four degrees of freedom) were studied. It was possible to selectively excite single vibrational modes, often even state-selective. Special processes like hot-band excitation, vibrationally mediated desorption and the excitation of "dark modes" were simulated. Finally, a novel OCT algorithm in density matrix representation has been developed which allows for time-dependent target operators and thus enables to control the excitation mechanism instead of only the final state. The algorithm is based on a combination of global (iterative) and local (non-iterative) OCT schemes, such that short, globally controlled time-intervals are coupled locally in time. Its numerical performance and accuracy were tested and verified and it was successfully applied to stabilize a two-state linear-combination and to enforce a successive "ladder climbing" in a rather harmonic system, where monochromatic, analytical pulses simultaneously excited several states, leading to a population loss in the target state.}, language = {en} }