@article{MachatschekHeuchelLendlein2021,
  author    = {Machatschek, Rainhard Gabriel and Heuchel, Matthias and Lendlein, Andreas},
  title     = {Thin-layer studies on surface functionalization of polyetherimide},
  series = {Journal of materials research : JMR / Materials Research Society},
  volume    = {37},
  journal   = {Journal of materials research : JMR / Materials Research Society},
  number    = {1},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {0884-2914},
  doi       = {10.1557/s43578-021-00339-7},
  pages     = {67 -- 76},
  year      = {2021},
  abstract  = {Among the high-performance and engineering polymers, polyimides and the closely related polyetherimide (PEI) stand out by their capability to react with nucleophiles under relatively mild conditions. By targeting the phthalimide groups in the chain backbone, post-functionalization offers a pathway to adjust surface properties such as hydrophilicity, solvent resistance, and porosity. Here, we use ultrathin PEI films on a Langmuir trough as a model system to investigate the surface functionalization with ethylene diamine and tetrakis(4-aminophenyl)porphyrin as multivalent nucleophiles. By means of AFM, Raman spectroscopy, and interfacial rheology, we show that hydrolysis enhances the chemical and mechanical stability of ultrathin films and allows for the formation of EDC/NHS-activated esters. Direct amidation of PEI was achieved in the presence of a Lewis acid catalyst, resulting in free amine groups rather than cross-linking. When comparing amidation with hydrolysis, we find a greater influence of the latter on material properties.},
  language  = {en}
}
@article{IzraylitLiuTarazonaetal.2021,
  author    = {Izraylit, Victor and Liu, Yue and Tarazona, Natalia A. and Machatschek, Rainhard Gabriel and Lendlein, Andreas},
  title     = {Crystallization and degradation behaviour of multiblock copolyester blends in Langmuir monolayers},
  series = {MRS communications / a publication of the Materials Research Society},
  volume    = {11},
  journal   = {MRS communications / a publication of the Materials Research Society},
  number    = {6},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {2159-6859},
  doi       = {10.1557/s43579-021-00107-y},
  pages     = {850 -- 855},
  year      = {2021},
  abstract  = {Supporting the wound healing of soft tissues requires fixation devices becoming more elastic while degrading. To address this unmet need, we designed a blend of degradable multiblock copolymers, which is cross-linked by PLA stereocomplexation combining two soft segments differing substantially in their hydrolytic degradation rate. The degradation path and concomitant structural changes are predicted by Langmuir monolayer technique. The fast hydrolysis of one soft segment leads to a decrease of the total polymer mass at constant physical cross-linking density. The corresponding increase of the average spacing between the network nodes suggests the targeted increase of the blend's flexibility.},
  language  = {en}
}
@article{ZhongWangAdelsbergeretal.2011,
  author    = {Zhong, Qi and Wang, Weinan and Adelsberger, Joseph and Golosova, Anastasia and Koumba, Achille M. Bivigou and Laschewsky, Andr{\´e} and Funari, Sergio S. and Perlich, Jan and Roth, Stephan V. and Papadakis, Christine M. and M{\"u}ller-Buschbaum, Peter},
  title     = {Collapse transition in thin films of poly(methoxydiethylenglycol acrylate)},
  series = {Colloid and polymer science : official journal of the Kolloid-Gesellschaft},
  volume    = {289},
  journal   = {Colloid and polymer science : official journal of the Kolloid-Gesellschaft},
  number    = {5-6},
  publisher = {Springer},
  address   = {New York},
  issn      = {0303-402X},
  doi       = {10.1007/s00396-011-2384-1},
  pages     = {569 -- 581},
  year      = {2011},
  abstract  = {The thermal behavior of poly(methoxydiethylenglycol acrylate) (PMDEGA) is studied in thin hydrogel films on solid supports and is compared with the behavior in aqueous solution. The PMDEGA hydrogel film thickness is varied from 2 to 422 nm. Initially, these films are homogenous, as measured with optical microscopy, atomic force microscopy, X-ray reflectivity, and grazing-incidence small-angle X-ray scattering (GISAXS). However, they tend to de-wet when stored under ambient conditions. Along the surface normal, no long-ranged correlations between substrate and film surface are detected with GISAXS, due to the high mobility of the polymer at room temperature. The swelling of the hydrogel films as a function of the water vapor pressure and the temperature are probed for saturated water vapor pressures between 2,380 and 3,170 Pa. While the swelling capability is found to increase with water vapor pressure, swelling in dependence on the temperature revealed a collapse phase transition of a lower critical solution temperature type. The transition temperature decreases from 40.6 A degrees C to 36.6 A degrees C with increasing film thickness, but is independent of the thickness for very thin films below a thickness of 40 nm. The observed transition temperature range compares well with the cloud points observed in dilute (0.1 wt.\%) and semi-dilute (5 wt.\%) solution which decrease from 45 A degrees C to 39 A degrees C with increasing concentration.},
  language  = {en}
}
@article{ZhongAdelsbergerNiedermeieretal.2013,
  author    = {Zhong, Qi and Adelsberger, Joseph and Niedermeier, M. A. and Golosova, Anastasi and Bivigou Koumba, Achille Mayelle and Laschewsky, Andr{\´e} and Funari, S. S. and Papadakis, Christine M. and M{\"u}ller-Buschbaum, Peter},
  title     = {The influence of selective solvents on the transition behavior of poly(styrene-b-monomethoxydiethylenglycol-acrylate-b-styrene) thick films},
  series = {Colloid and polymer science : official journal of the Kolloid-Gesellschaft},
  volume    = {291},
  journal   = {Colloid and polymer science : official journal of the Kolloid-Gesellschaft},
  number    = {6},
  publisher = {Springer},
  address   = {New York},
  issn      = {0303-402X},
  doi       = {10.1007/s00396-012-2879-4},
  pages     = {1439 -- 1451},
  year      = {2013},
  abstract  = {Thick poly(styrene-b-monomethoxydiethylenglycol-acrylate-b-styrene) [P(S-b-MDEGA-b-S)] films (thickness 5 mu m) are prepared from different solvents on flexible substrates by solution casting and investigated with small-angle X-ray scattering. As the solvents are either PS- or PMDEGA-selective, micelles with different core-shell micellar structures are formed. In PMDEGA-selective solvents, the PS block is the core and PMDEGA is the shell, whereas in PS-selective solvents, the order is reversed. After exposing the films to liquid D2O, the micellar structure inside the films prepared from PMDEGA-selective solvents remains unchanged and only the PMDEGA (shell part) swells. On the contrary, in the films prepared from PS-selective solvents, the micelles revert the core and the shell. This reversal causes more entanglements of the PMDEGA chains between the micelles. Moreover, the thermal collapse transition of the PMDEGA block in liquid D2O is significantly broadened. Irrespective of the solvent used for film preparation, the swollen PMDEGA shell does not show a prominent shrinkage when passing the phase transition, and the transition process occurs via compaction. The collapsed micelles have a tendency to densely pack above the transition temperature.},
  language  = {en}
}